What is the best way to replace a water pump on a 1996 Plymouth Voyage with a 3.0 engine? The engine is extremely close to the firewall and that makes it difficult to access the water pump. Will removing the passenger side tire and fender help? -- Message posted via http://www.carkb.com

Archive-name: autos/chrysler-faq/general/part1 Posting-Frequency: 15 days Last-modified: 2006/6/1 Version: 5.9 This section is generally revised every 300 days. - - - - - - - - - - - - IMPORTANT. Do not attempt to respond to . Due to spam this address DOES NOT GO ANYWHERE. ...

Nomen Nescio wrote: > Why are your balls in an uproar over the term, "******?" > > While I generally refrain from day-to-day use of this word, it should not > be a source of friction, regardless of your racial or political persuasion. > > The word itself is nothing more than a corruption of the...

Is it possible to disable the Headlight Off-Time Delay on the newer minivans? -- Jeff Wieland

Very recently I've noticed a noise coming from my front end. I've only noticed it at very slow speeds when turning the steering wheel fairly rapidly, such as maneuvering to park. There is a noticeable muffled clunk noise from the passenger side front when the car's direction is being changed. It...

Archive-name: autos/chrysler-faq/general/part4 Posting-Frequency: 15 days Last-modified: 2004/4/13 Version: 4.2 IMPORTANT. Do not attempt to respond to . Due to spam this address DOES NOT GO ANYWHERE. Instead, reply to faq2 at that allpar /dot/ com address. Thank you. - - - - - - - -...

Changed oil on 300M -- put in 1/2 quart too much...Will this be a problem? Thanks in advance..

I have a 2001 PT Cruiser, won’t start... checked to make sure that the spark plugs were firing.... discovered that the spark if any is very weak.. and when I turn the key to the off position the spark plugs fire one time very strong.... I have never seen anything like it... Why would the plug...

Hi: I want to permanently remove the air conditioner compressor from a 1990 3.3 L Voyager. I will need a different length serpentine belt, but will I also need to find some sort of extra idler pulley to take the place of the compressor? Dave

The recent issue tests after market bulbs, including the GE NightHawk and the Sylvania bulbs. Their results were inconsistent depending upon the car lamp in question. I found that the NightHawk did give me a boost in my 04 Town and Country and the GE/Toshiba inferred bulbs improved my 98 RAV4 much...

There is a hesitation when you start out until you hit 3000 rpm's then it will take off. you can also hear some pinging. Is it the timing belt or what else could it be!!! I've replace the ignition coil box, plugs and wires, erg valve, fuel filter the O2 sensor. I am now out of Ideas except for...

My Dodge 360 engine's timing can only be checked looking downward at the flywheel from an inspection hole inside the van. The smog specs call for 6 degrees retarded. Since there are no reference marks at the inspection hole except for a "centering" line on the hole, can someone tell me how many...

My gear select cable is starting to bind. I understand the connection at the transmission, but how difficult is it to change out the cable at the shifter end?

The other day I went to get a new battery for my car, and on the way it overheated. I pulled the 195deg thermostat out and replaced it with a 192deg, but it's still overheating. When I parked it, I heard a sort-of "gurgling" sound coming from where the thermostat is, and the upper hose is easy to...

I'm trying to replace the vacumn power brake booster on a 1994 Dodge Caravan (auto transmission, V6 3.0, non-ABS). I have removed the master cylinder, the vacumn hose and the four mounting nuts inside the vehicle. The Chilton's manual then says: "...unfasten the brackets mounting the steel water...

Just purchased a pair of Moog sway bar links and have some questions. I couldn't find a metric or sae wrench that would fit on the hex nut. Also, the nut will only screw on about two turns on the bolt before it starts binding. Upon closer examination, the threaded hole in the nut appears to be...

My son's grandparents gave him a 92 Dodge Dynasty. They thought it just needed a new windshield wiper motor so I bought one at Auto Zone today but that didn't fix the problem. When you turn the wipers on, there is a clicking noise but nothing happens. We've been given a couple of ideas as to...

On a convertible, does anyone know how to remove the front rubber gasket, between the roof and the windshield. I have a '95 LeBaron, but I thihk all the LeBarons and Sebrings areound that time are similar. It's firmly attached to a metal strip**, a U-channel that the instructions say has screws...

Saw the pics and specs on this car. Another Mini clone. No four door model, no room for more than probably two people, where is the family going to sit? Load of groceries? That is what is wrong with this car: This is not the car for Americans. I am a loyal Chrysler owner and the 2007 Caliber...