|
|
Rear Alignment in '91 Civic? by
jim beam
Brandy Alexandre wrote:
> Before I move to another state, I went to the same Honda mechanic for
> decades. Before I left, I had him give the car one last look and fix
> everything that needed fixing. I got new shocks/structs and other
> funky things. And a week later a new radiator because the...
|
|
6 |
536 |
|
|
|
|
0 |
720 |
|
|
valves or pinging? by
chibitul
Hi, how can I tell the difference between valve misadjusment and
pinging? next time I fill up I am going to try higher octane, 93
instead of 87, if the noise goes away I conclude it is pinging, if the
noise remains I think it must be the valves. is this logic correct or
faulty? thanks
|
|
4 |
425 |
|
|
does 1999 4 cylinder have balancer shafts by
Ray
getting brave enough to change my timing belt on 1999 honda accord 4
cylinder
so far i have looked at step by step instructions for timing belt
instalation off of the internet however this information was for early
90's honda.
everything i have seen looks fairly easy so far
|
August 11th 05 12:50 AM
by TWW
|
3 |
318 |
|
|
unbelievable! by
finding z0
My daughter's been driving my '91 Acura (she's 18). This is the same
car that had its oil drain bolt stipped by Jiffy-Lube recently, and had
its AC converted to the newer coolant not long ago. She mentioned the
battery light came on the other day. I told her this car eats a battery
about every 4...
|
|
0 |
261 |
|
|
91 SI rebuilt motor eats litre of oil per week!!! by
jim beam
RayGun wrote:
> Hey All.. I rebuilt my daughters 91 Si, had burned and bent exhaust
> valves. Put in new rings, valves, valve seats, gaskets and all the
> necessary items needed. Break-in period was gentle and 2000 kms.
> It passed the emission test no sweat, but after about three months
> started...
|
|
0 |
350 |
|
|
91 SI..eating a litre of oil a week, after rebuild??? by
RayGun
Hi All
I just rebuilt my daughters 91 SI last winter, had one broken and one
bent valve.
New rings, valves, seals, gaskets, the whole enchelada.
2000 km easy break-in period, passed the emission test no sweat, then
slowly started to use oil. Seven months later it is using about a litre
a week, but...
|
August 11th 05 01:41 PM
by RayGun
|
0 |
369 |
|
|
D15 sleeving by
Majorly Confused
Where can I get my D15 block sleeved (iron sleeves) affordably?
|
August 11th 05 07:34 PM
by h24
|
8 |
406 |
|
|
1999 Honda CRV - Low Engine Idle by
mikenycz
I have a 1999 CRV that runs well. The one thing that I notice is that
the engine idles at 300-400 rpm (using the tach on the dash). The car
does not stall but when I run the AC, the compressor keeps cutting in
and out due to the low rpm's (i.e. the AC is fine when riding at any
speed). Only idle is...
|
|
0 |
447 |
|
|
Correct tire size? by
Mofu
I recently got a good deal on a set of used, but minty, bridgestone
potenza's (195/60R15) mounted on integra gsr blades and I'm planning
on installing them on my 99 civic se. However, the new rim'n rubber
combination is slightly taller and wider than what is currently on the
car. Is it safe to...
|
August 12th 05 01:20 AM
by Mofu
|
2 |
398 |
|
|
Life-Time Brake Pads? by
Nino NoSpam
Does anyone know if "Life-time" brake pads are a good idea for Honda CR-Vs?
Will it affect ABS braking?
Does Honda make them or are they an aftermarket product?
|
|
3 |
367 |
|
|
Swapping out brake bleeder screws by
MAT
Hi All,
I finally got speedbleeders for my Si of which I plan on installing with
fresh brake fluid this weekend. My question is can I replace each screw and
bleed it one corner at a time in one step or do I need to replace all 4
bleed screws and go back and bleed them again. I'm wondering if...
|
August 12th 05 02:03 AM
by Bruce
|
2 |
392 |
|
|
Groaning / Squeaking / Screeching noise from LR wheel??? by
bertbarndoor
What could this be?
It all started about a week ago. Whenever I turned in one direction
(can't remember if it was right or left) the left rear wheel would
squeek (sounded like it was once per revolution, *squeak* *squeak*
*squeak* faster or slower depending on my speed.
Now, for the last 2 days,...
|
August 12th 05 02:07 AM
by Pars
|
5 |
659 |
|
|
MPG with AC on - 92 Civic AT by
[email protected]
AAAAaaaaaaaaaaarghhhhhhh!
I drained the tank, topped it off, hit the trip reset and started my
experiment. I drove down the tank until darn near empty using the air
conditioner on recirc for the entire tankful. Last night the little
lady ran some errands and put $10 in to get her around! See what...
|
August 12th 05 03:41 AM
by Pars
|
3 |
224 |
|
|
92 civic suspension by
jim beam
John wrote:
> Hello,
>
> Can someone confirm if I have struts or shocks/coils on my 92 civic dx
> hatch?
>
> Thanks!
>
> John
>
|
August 12th 05 07:09 AM
by John
|
2 |
325 |
|
|
98 honda civic LX 1.6L a/c systea by
charlee
98 honda civic LX 1.6L
Have replaced the whole entire a/c system,
when reading the a/c gauges low side indicates
35 and high side indicates 250 to 300.
High side too high, can some one point me the right direction to solve
this high side problem
|
|
0 |
211 |
|
|
Si '91 eating oil after rebuild. by
Jason
In article >, RayGun >
wrote:
> Hello All
> I rebuilt my daughters 91 SI last winter, after determining it had some
> head aches...
> Broken valve and a bent valve.
> Did the rings, valves, guides all gaskets, and after an easy 2000 km
>...
|
August 12th 05 06:32 PM
by Jason
|
0 |
403 |
|
|
|
August 12th 05 09:45 PM
by Jerzy
|
2 |
355 |
|
|
Temp gauge reads cold - 1994 Accord by
acellier
1994 Accord EX
Car starts and runs OK, but mileage is a bit low. I think the O2 sensor may be shot - barely passed smog last couple times. But new issue:
My temp gauge rarely rises above the bottom peg.
Checked the TW sensor with an ohmeter and IR gun. The resistance appears very close to the...
|
|
2 |
697 |
|
|
Hood Pins by
Elle
Has anyone installed these on his/her Honda?
Any thing I should look out for while installing?
What manufacturer of hood pins do you like?
My 91 Civic's hood release lever and cable mechanism have been a pain for
many years. I am thinking of discarding the whole setup, sacrificing looks
for...
|
|
5 |
387 |