A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Chrysler Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Reverse Sort Order Views
2000 Chrysler Grand Voyager Water Pump by William R. Walsh
Hello all... This has been a "fun" van to own--while it seems to be reliable enough and is holding up well, it has had enough stupid problems to make you wonder... It's a 2000 Grand Voyager with the 3.3L V6. About two or three months ago, it suddenly and without provocation dumped coolant out of...
October 25th 07 12:46 AM
by philthy[_1_] Go to last post
5 522
88 Ram 250 4Speed OD Auto Swap? by [email protected]
Hi, I was wondering about retro-fitting my 88 Ram 250 with a 4 speed OD auto trans? Did one exist for this chassis that would swap in semi-easily with say a driveshaft and cross-member swap? If yes, what model and year etc? Thanks!
March 3rd 08 02:57 PM
by Steve[_1_] Go to last post
5 311
1998 Concorde started smoking heavily, died and seemed to have blownsomething up. by afx
I was driving the car when it started smoking heavily so I pulled over, the temp was fine but then the car sputtered pulling into the parking spot and died, also some weird fluid seemed to be leaking but well get to that later. I didnt know exactly what it was so I started checking fluids...
March 19th 08 04:37 PM
by Steve[_1_] Go to last post
5 565
'96 Town & Country sway bar "clunk" by Kevin Bootz
Replaced struts, links, bushings, outer tie rod ends,... and STILL have an annoying clunk when driving down the road. Any known solutions? Thanks
March 19th 08 01:54 AM
by Kevin Bootz Go to last post
5 223
Conclusion: Exhaust leak '00 300M (cause, and remedy) by MoPar Man
Over the past few months my 2000 300m developed an exhaust bark that sounded like it was coming from the front or center of the car, not the rear. A visual inspection on a hoist (Midas) indicated that the first muffler/resonator in the exhaust chain was the problem - it's single seam running down...
April 26th 08 02:01 AM
by MoPar Man Go to last post
5 494
PT Cruiser chiming and sputtering by [email protected]
I have a 2006 PT Cruiser and I’m having a weird problem. While driving, the car will start chiming (like I’ve left the keys in with the door open). The warning lights on the dash (oil, airbag, etc) will start flashing, the speedometer will move around wildly and the engine will start surging. It...
May 13th 08 02:25 PM
by Art[_1_] Go to last post
5 271
Is there no Chiltons or Haynes repair book for post-1999 LH body cars? by MoPar Man
Can anyone explain why there is no $20 Chiltons or Haynes (or equivalent) service / repair manual for 1999 - 2004 LH body cars?
May 20th 08 07:12 PM
by [email protected] Go to last post
5 445
Whistling sound coming from engine. by [email protected]
I just changed the front timing chain cover and I had to change the intake manifold gasket. Since I changed the intake manifold gasket there is a very loud sound coming from the engine. I changed the manifold gasket again and still the same sound. I have a 86 jeep grand wageneer. and can't find...
May 31st 08 04:02 PM
by Bill Putney Go to last post
5 324
PT INFO FOR THE GROUP - AC Fan/ Thanks Glenn Beasely by pe2[_2_]
Well gang- I posted earlier this month and Glenn Beas told me that the AC fan might have died, due to our PT compressor making the car shake, and causing a small drop in power. Glenn my friend-you were right. Today, we took the baby in for a check up, and oil change. 4 hours, and $600 later-we...
June 5th 08 12:33 AM
by pe2[_2_] Go to last post
5 247
After the heater core, now comes....next.... by Glenn O'Connor
Hi all. After having the heater core, and a front brake job done, which was needed; the next thing is having the shifter cable replaced on this '99 Concorde. When I picked up the auto, it was stiff, very stiff, to shift. I, dumbly, retook possession of the "thing" for a few days. Well by the...
February 29th 08 04:21 PM
by Glenn O'Connor Go to last post
5 494
Rusting Tire Rims by Even Stephen
My 2003 PT Cruiser has slow air pressure leaks in both front tires. The tires have only 10,000 miles of wear. The service department has told me that the rims of the PT tend to corrode and the seals break and air does seep out (a design flaw). Other than removing the tires and sanding the...
February 19th 08 02:42 AM
by Bryan[_2_] Go to last post
5 234
2003 Caravan dead PCM by sonnyg9
2003 Dodge Caravan w/ 76,500 miles has dead PCM. Dealer is quoting $1100 for repair. This seems very high for unplugging and plugging in a computer. Can someone please explain the level of work required for this repair? I understand the PCM is around $450, but why is the install $650? Also I asked...
October 27th 07 01:48 AM
by philthy[_1_] Go to last post
5 250
Help: 96 Caravan no front washer? by Bill[_20_]
Hello, Does anyone know where the voltage outputs from that supplies the front washer motor? I have no voltage output from the output connector, completely dead. I traced back to the connector before it, and still nothing. Then it goes into a big harness housing and continues on. I have checked...
November 8th 07 04:33 AM
by Bill[_20_] Go to last post
5 299
2008 Grand Caravan driver headrest problem by [email protected]
Hello! We purchased a 2008 Grand Caravan SXT 2 weeks ago and are happy with it overall. Our Voyager was 10 yrs old so it is nice to have a new car. The big issue for me here is that I find the front seat's headrest to be the most uncomfortable headrest I have ever used. The headrest is not...
November 7th 07 03:54 AM
by Ron Seiden Go to last post
5 412
94 Voyager fuel pumps and codes. by gtb
Greetings, My original fuel pump has been loud for 20000 miles. It finally died and had it replaced about a month ago. The new pump lasted about 3 weeks b4 it started making intermittent rattling sounds. The shop replaced it and now this 2nd pump is starting to get noisy. Could there be anything...
November 22nd 07 08:22 AM
by Ted Mittelstaedt Go to last post
5 167
97 Plymouth Grand Voyager SE Problem by Jeff[_40_]
Hello. I have a 97 Plymouth Grand Voyager SE with 197,000 miles. Recently the service engine soon light started coming on and the van started stalling at idle. I took it to a dealer and they couldnt find anything wrong with it except Map Sensor/ Baro which I already had replaced. I also had it at a...
November 22nd 07 11:13 AM
by maxpower Go to last post
5 365
300M: Crash test improvement by software upgrade? by [email protected]
Hi, In the following link there are crash test results for the Chrysler 300M year 1999-2000 and 2001-2004 models: http://www.iihs.org/ratings/ratingsbyseries.aspx?id=477 The crash test results were "not so good" for the 1999-2000 models. The results were improved in later models partly as...
December 5th 07 11:18 PM
by Bill Putney Go to last post
5 480
2000 voyager : How to check codes without scan tool? by Woodsy[_2_]
I have tried the on/off, on/off, on/off trick = nothing I held the trip and rest buttons in during power on and the van went into a diagnostic: Code 999 Check 1 Check 2 Check 3
December 8th 07 04:36 PM
by philthy[_1_] Go to last post
5 198
2002 TC Question by Scott T. Indresano
My sister-in-law has a 2002 Chrysler Town & Country with the 3.8l V6. Lately her gauges have been going crazy, and it wouldn't start. The battery was charged. The alternator and battery test fine. Now after several jumps, she has no dash lights when the headlights are on. Thanks in...
January 5th 08 10:53 PM
by philthy[_1_] Go to last post
5 173
Service manual for 2001 T&C by Luke Packard
Anyone have a recommendation for a service manual for my 2001 Town & Country Limited? One of my side sliding doors intermittently fails to automatically open/close. The dealer wants $500 to replace the latch assembly. I want to see how difficult the job is so maybe I can start fixing these...
June 5th 08 10:24 AM
by maxpower[_2_] Go to last post
5 447
Post New Thread


Display Options
Showing threads 2241 to 2260 of 6940
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:20 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.