1.5(G) model:EF6 sale Japan Car location;Japan. Engine, mission good working condition http://japanesejapan.at.infoseek.co.jp/1991%20CRX%20B16A.jpg ---------- Kuroyanagi Shouten Ltd Japan. #510 Castle May, 3-1422 Ueda-Higashi Tenpaku, Nagoya Japan 468-0006

it broke off when I was unscrewing it. Anyone have any idea how I can get the screw out of the hole, there is only the plastic stump remaining.

Hello- My 2000 Civic Si is makes a squeaking/chirping noise when the engine is running. I can make the noise go away by putting a very small amount of weight on the clutch pedal. I can also make the noise go away if I gently push in on the boot that covers the joint between the clutch slave...

Hello Everyone, need some advice.... I've been having this ongoing problem with my alignment since I got my Integra from my cousin. Yes it was also involved in a front and rear collision (by her), but I don't see any signs of frame damage. The inner walls are once again beginning to wear with no...

Hi all, PLEASE READ THIS It Will Work. If you do as I have done! Just Do It! follow the 4 steps. $6.00 to $15,000.00 in 30 days!

> wrote in message ... > I wanted to see how Toyota dropped the Avalon 3.5 liter V6 into the > all-new 2007 Camry. The horsepower is down a notch, but the Cary > probably is making do with regular gas, unlike the...

When selling my '93 Honda Accord is it to both parties advantage to go to the DMV together to transfer title and finalize the deal (California)? Someone wanted to buy the car off me last night after driving it around the block. He had the money but I didn't feel comfortable with his haste. I have a...

www.ralirotadosvinhosverdes.org

I've tried replacing the map sensor but no luck. Can anyone help? Thanks

I just replaced the compressor, condensor, expansion valve and drier on my 95 accord. Flush the lines, added oil, vac'd the system for an hour and charged it. It is blowing good cold air but I get a high pitched squeal that sounds like it is coming from the expansion valve when I turn the system...

The air just failed. One day it was not cold but can still hear the hissing under the glove compartment. Th enext day no hissing, I guess it leaked all the freon. In your opinion what is the most common item that fails. Tx

Hi all! Is the starter from a 92-95 civic will fit 88-91 civic? I did not take either off but so far the do look the exact same.Anyone know for sure if they are compatible? Thanks!

My 2002 Acura TL lease is almost ended. Rather than purchase my car from Honda finance at residual value I would like to purchase my vehicle at auction. Is there any way to trace where my car goes AFTER I return it to the Acura dealer? I'm hoping to purchase it back below residual value.

I need some help. I bought an engine from a junk yard and it ended up being a 1986 D16A1 . I have a 1990 honda civic dx hatchback that I would like to put that D16A1 into but I understand that it may take custom engine mounts. I also understand that I will need a custom clutch. Will my...

I have 96 honda accord and i have noticed from a past couple of days that i have to press the acceleration pedal to start the car. This was not the case in the past. And once the car is started i have to maintian a constant rpm for soem time otherwise the car vibrates a lot. This doesnot happen...

94 Honda Accord EX - 300K miles I replaced the head gasket, after "lapping to plate" both the head and deck. I took precautions to remove as much of the abrasive residue as possible, and after 110 miles I changed the oil and filter. The timing belt was installed in the "same tooth" as before, and...

Hi all: I am on my way to replace the crank oil seal in my 93 Civic, but have hit a snag. I can't get the timing belt drive pulley off. This pulley sits behind the large crankshaft pulley. Does anyone have any tricks to removing it? I've tried prying on the plate that sits behind it, but that...

What do most folks use to preserve the dash covers etc. these days that really works? I'm leaning towards a silicon based solution as I think stuff like amorall suck... JT

Opened the hood last week to find a little ball of insulation sitting on the battery. Apparently a rodent got up into the engine, stood on the battery, and took swipes at the insulation. There is a 4-inch-diameter hole in the insulation there. I took it to the dealer for service and had them...

On my Honda '86 CRX how do I go about pulling the horn button off? A spring or some other device under the horn button has changed so that the horn wants to stay on. Right now both horns are disconnected so that I can drive it. Thanks for any help with this. Pj