Don't know know if the question has been asked before, but humor me for a bit and share your thoughts on gas prices and if ya think driving an SUV is unpatriotic? In my own mind its a complicated question that can effect US national security (the part where we in the USA are dependent upon foreign...

FLIP WILSON SHOWS.... ABOUT 4O EPIDODES,,,, WILL BE ON T V L A N D CABLE TODAY STARTING AT 7AM UNTIL SUNDAY,, ITS A MARATHON,,, GET YOUR RECORDERS READY ENJOY YOUR HOLIDAY!!!!! LUVYAS

If you had a choice, would you go with the detroit locker in rear only, or go with lockright front and back. Given that 2 lockrights are about $150.00 Canadian less then the detroit. I'm changing gears, so now is the time to do something, so the install cost of the detroit wont come into it....

Hi Group, I have a 1991 GMC K-2500 with the 350 CID engine {5.7 Liter}, 217,000 miles, runs great, doesn't use oil. It developed a water leak and the garage replaced the intake gasket. When I picked it up the oil pressure was very low, about 15 highway, 0 at idle. I assumed they had loosened a wire...

How many people would be interested in a small 4x4 diesel swap kit,particularly a 5 cylinder Benz or a Isuzu or Mits, in a TJ or YJ Jeep? Or a Bronco?

I'm looking for a 4x4 car that will excel in snowy conditions. I've had a '91 Jeep Cherokee, a '97 Jeep Wrangler Sport and a '01 Land Rover Discovery II. All of them were equipped with stock 4x4 systems, and none of them impressed me when it came to deep snow capabilities (not so deep that they...

Got the replacement rear springs on. Not without incident and I'll report later when project is completed. Now the front -- old spring is off and new spring is in place. But I cannot remove the top connecting link pin holding the connecting link to the stabilizer bar! The instructions that came...

My 98 Z-71 has this annoying sound like washers on a bolt everytime I go over the railroad tracks or any bump of substance. Last weekend while changing the oil, I started looking at my suspension at the rear passenger side since that seems to be where the sound is coming from. I noticed that the...

Sorry -- I messed up the last post. Here is how it should have come: -------------------------------------------------------------------- CJ brakes are repaired and springs are on!! Some of you on the list have been a GREAT help, and I appreciate it. I know this cj doesn't compare to some of...

I'm planning to buy a used SUV in the very near future. I'd narrowed it down to an early 90's 4runner. When looking around, though, I noticed one or 2 1990 Landcruisers in the same price range. Looking for some experienced opinions on which would better suit my needs. This rig will be used as a...

Happy 4th everyone. I'm in the market for a used CR-V. To date, I've test-driven two, both 5 speed manual transmission. One was a 2000, the other a 2001. The first, the 2000, that I drove made a loud whirring/humming sound when the steering was maxed out in a 360 degree turn, in both directions....

While doing the spring replacement (which is about finished!!) I noticed the inner pads on the front brakes were about worn out on both the driver and passenger side. I don't remember exactly when I replaced them -- but seems like 20,000 miles or so ago. I could be wrong. The outer pads looked a...

Xterra Firma is the premiere Internet destination for all things related to the Nissan Xterra SUV. This site is for the community and by the community - sharing and kind-hearted discussion are very much encouraged. Whether you off-road, compete in audio, crawl the malls or you just love your...

this is proabley old stuff now but I've got a 1995 landcruiser fulltime 4 wheel drive.Can I fit freewheel hubs and if so any change in mpg an handeling. cheers Dave H

Anybody recommend a god rebuilder for my jimmy's vortec?? Have to do a major soon. thanks dan

Hello! A friend of mine just bought a 2nd hand Range Rover 4.6 HSE (1999) and is desperately looking for the manual, which is usually included when buying a new car. But since this is a 2nd hand... the previous owner had lost the manual. Can anyone pls tell me where to find the guide (online to...

Greetings: I just bought a 2004 Sequoia, and I was going to move my winch from my old truck to the Sequoia, but I can't seem to find anyone that sells winch mounts for the Sequoia. Anyone know of one, or has anyone tried a mount for a tundra on their Sequoia? Thanks

I am interested in buying a used small import p/u. Are the Mazda B series a decent truck...body, mechanical, reliabilty. In relation to the others...Toyota or Nissan, between the years of 1984-1990...what would be the best truck (in your opinion)... (PS: I will be keeping it stock) Thanks in...

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7910251909

Hi.. please check out a new automotive forum at http://www.forumring-auto.com. Thanks Raymond