|
|
Intermittent Techometer Problem by
John
Hi, I have a 99 Firebird, 6 cylinder, auto transmission and the
tachometer only works half the time. Everything else is ok. When the
Tach does work it works good so I figure it must be a bad connection
somewhere but I'm not sure where to look. Any Ideas?
Thanks John
|
|
1 |
286 |
|
|
What's the sensor on the air box called? by
[email protected]
Hi Everyone,
I have a 97 Buick Riviera with GM's 3800 II 3.8 engine
w/supercharger. There's a sensor mounted on the air box directly over
the air filter. I am assuming it's to tell the computer what the
temperature of the air is. Is this correct? Also does anyone know what
this sensor would be...
( 1 2)
|
|
18 |
607 |
|
|
|
November 30th 05 10:20 PM
by gfulton
|
18 |
887 |
|
|
chevy venture wiper issues by
my.migraine
I recently started having issues with my 2001 chevy venture wipers.
Stated out that the driver side arm didn't go all the way down during
use. Hubby tried to adjust by loosening nut and moving arm. This
resulted in arms banging into each other. He "adjusted" again and I am
at least back to...
|
|
2 |
931 |
|
|
Onstar Response Time by
John Shepardson
I used this in a new car today and didn't get a response after 45
minutes.
Is this typical?
Was I charged for this since my service included 30 minutes of phone
time?
Quite disappointed.
|
November 30th 05 09:12 PM
by John S.
|
6 |
468 |
|
|
ignition module by
SteveM
My 92 Mercury Capri wont start, it'll turn, but no ignition. I checked
the spark plugs, the coil, and the fuel lines. I understand it could be
a numbe rof issues, my dad had suggested it could be the ignition
module. where are these, and is is this even the problem? thanks for
taking time to even...
( 1 2)
|
|
12 |
780 |
|
|
Quality of Beck/Arnley parts by
Masospaghetti
How good is Beck/Arnley products compared to, say, AC Delco or Denso or
the Advance/Autozone house brands? The price is vastly better ($67
compared to $100 for the house brands and $150 for AC Delco). I'm
looking at a remanufactured alternator for a 1985 Corolla SR5.
Thanks!
|
November 30th 05 03:12 PM
by M0stro
|
4 |
290 |
|
|
Mercury 1979 Zephyr Z-7 FOR SALE by
kb3dxl
Automatic 3.3L in-line 6cyl 2dr coupe. Only 59K miles! Garage Kept.
Tan interior and exterior. AC no longer functions. Needs head liner.
Corner tail lights damaged. Dent on passenger side rocker panel.
Great condition. Replacement parts such as tail lights can be included
after discussing the...
|
November 30th 05 08:00 AM
by kb3dxl
|
0 |
497 |
|
|
|
|
23 |
1,035 |
|
|
Starter or ignition issue?? by
Nan
Hi, thanks for taking the time to read my post.
We have a 1993 Ford Aerostar Minivan. The following has happened
recently:
While I drove it: Out running errands, so several stop and start
times, it would fail to start at some point.
Other than the initial "click" (once) from the solenoid,...
( 1 2 3)
|
|
20 |
876 |
|
|
1977 F-250 by
staplz
I am having a problem with my 1977 F-250, it has a 400 with a automatic
tranny. First off, my head lights are acting funny. when I turn my truck
on, the headlights come on all by themselves, the tail lights do not, just
the headlights. Yet, if I turn on my head light switch, the headlights
stay...
|
|
3 |
406 |
|
|
Ford Focus by
Dunsy
I have a 2002 Ford Focus ZX3. I hear a clicking noise when I am traveling down the road. I believe that it is most likely CV joints. How hard is it to change these?
--
Dunsy
------------------------------------------------------------------------
View this thread:...
|
November 29th 05 11:31 PM
by
|
2 |
748 |
|
|
Burning smell by
Mark-T
Recently I noticed an odor in my car, smells like
burning rubber. Not good! It is particularly
noticeable when I am idling at an intersection.
My first thought is the tires, but that doesn't
make sense - they would burn only after a skid, right?
Could it be burning oil, does that smell like...
( 1 2)
|
November 29th 05 11:29 PM
by
|
18 |
764 |
|
|
S-10 rearend axle removal?? by
Steve
I have an '88 S-10 4X4, 2.8L.
The left axle seal is leaking and I went to replace it yesterday. The
Chilton manual being my guide, I remove the differential cover plate. It is
necessary to remove the central carrier pin to allow the axle to be pushed
in and the removal of the axle retaining "C"...
|
|
9 |
839 |
|
|
Overheating engine.. Does this seem like a blown head gasket by
Al Kondo
I have a 96 Sentra GXE. The engine has been overheating recently and
I have conducted quite a bit of diagnosis on it to determine the
problem. There a bunch of things I have eliminated because I have
changed the parts in a similar overheating problem last year. I have
changed out the...
|
|
2 |
553 |
|
|
fuel pump by
jdl
If the filter and strainer on an electric fuel pump were totally clogged,
wouldn't the pump still make a noise, on the initial prime, couldn't you
still hear it, even though it wasn't pumping gas?
On some electric motors, I can hold the output shaft and it won't turn,
but I can still hear the...
|
November 29th 05 06:46 PM
by jdl
|
2 |
347 |
|
|
A question about heater by
John61
If I just move the slider to maximum heat, but keep the fan OFF, does it
consume any gas?
My 94' Caravan's heater works great, in early winter I don't need to turn on
the fan. It gives out lot of hot air though. I guess it uses recycled heat
from under the hood, right?
However, I noticed a...
( 1 2 3 ... Last Page)
|
November 29th 05 06:19 AM
by John61
|
40 |
1,179 |
|
|
96 Chevy Cavalier - white gunk on dipstick - head gasket? by
[email protected]
Ok here is the deal... I had an extrnal head gasket leak on this car a
month ago and had a friend change the head gasket everything was fine.
I put about 700 miles on the car in 3 weeks or so with no problems.
The car sat for a week without being run. I took it about 70 miles on
the highway (it has...
|
|
6 |
777 |
|
|
golf clutch fault... slave or master ??? by
screwballtarius97
Hi last week my ford tarus start injected fluid everywhere so I pulled over had it tow and so called repaired being told it was a $19.00 connection part that caused the problem. Later in the week my car wouldn't go over 20 mph without rev up to 4,000 rpm. I was then told by mechicanic to pay...
|
|
0 |
564 |
|
|
|
|
1 |
741 |