|
|
Code 11 by
Amos
After having the time chain gasket changed on a 3.3L '95 Intrepid the
engine is completely dead. Testing produced Code 11 below.
11 No ignition reference signal detected during cranking (bad Hall
effect) OR timing belt skipped one or more teeth; OR loss of either
camshaft or crankshaft position...
|
|
1 |
219 |
|
|
Do you want to buy cheap cars?! Well then, check this out! by
amos
If you are looking for bargains in used cars, just please log on to
http://cars.ozfreeonline.com all the best bargains of used cars in
Australia and New Zealand are in OzFreeOnline. You can even get your
own used cars listed for free! It is all for free! Visit out site now
and see what we are...
|
March 8th 07 09:17 AM
by amos
|
0 |
437 |
|
|
Code 11 by
Amos
After having the time chain gasket changed on a 3.3L '95 Intrepid the
engine is completely dead. Testing produced Code 11 below.
11 No ignition reference signal detected during cranking (bad Hall
effect) OR timing belt skipped one or more teeth; OR loss of either
camshaft or crankshaft position...
|
October 7th 05 01:59 PM
by Amos
|
0 |
252 |
|
|
i have a 92 dodge dynisty that will go in gear but wont shift by
amy
I have a 92 dodge dynasty that will go in gear but won't shift
--
posted from
http://www.motorsforum.com/chrysler/i-have-a-92-dodge-dynisty-that-will-go-in-gear-but-wont-shif-72137-.htm
using MotorsForum's Web, RSS and Social Media Interface to
rec.autos.makers.chrysler and other automotive...
|
|
2 |
2,336 |
|
|
|
August 26th 05 03:16 PM
by David
|
1 |
241 |
|
|
97 DODGE GRAND CARAVAN SE 3.3L STALLS by
[email protected]
Hello,
I have a 97 dodge grand caravan se 3.3L 130K.
Last year I had the same problem that's happening now but worst.
The engine would suddenly stall and die wether I'm on the streets or
the freeway. It happened when I was at freeway speed with my family on
board. Scary.
I ran code check and even...
|
September 13th 06 12:09 AM
by juzme
|
5 |
378 |
|
|
318 V8 with roller rockers by
Andrew
Hi I am assembling a 2nd pair of heads for my old V8.
this pair of heads will have adjustable rollerrockers on them.
The lifters in the block are hydrolic lifters
my question is - What do I set the valve gap to with these ajustable
rockers? Im guessing ZERO to mimic the old steel rocker that you...
|
|
6 |
303 |
|
|
1996 Grand Caravan starting problem by
Andrew B. Brown
In the last few weeks my 1996 Grand Caravan has had trouble starting.
When you turn the key all instruments light up and you hear one
"click". If you jiggle the gearshift lever up harder into PARK the car
usually starts.
I was told the PARK/NEUTRAL switch needed adjusting or replacing. I
took...
|
February 8th 05 06:49 AM
by tdodge
|
4 |
485 |
|
|
Signal light on A '91 Daytona by
andrew janssen
I got a problem with my darn Signal light. It's busted up front, where the
bulb is good, but I get a "quick flash" on the dashboard and on the rear
signal. The weird part: when it's 30'c or above, the light works.
To me, it sounds like a shotty connection somewhere, so, any ideas of...
|
|
0 |
285 |
|
|
new radiator but no heat by
[email protected]
I installed a new radiator in my 99 chrysler concorde with at 3.2
litre engine. Everything is working fine but I noticed that I'm not
getting heat from the system. I sometimes notice that the floor on the
dirver side of the car is wet. Any suggestions will be appriciated.
Thanks,
Drew
( 1 2)
|
|
11 |
614 |
|
|
Dodge Viper Battery Location??? by
[email protected]
I have run into some trouble with my 1998 v10 Dodge Viper and i need to
get to the battery. I've searched the entire car high and low and
called 2 dealerships and neither of them knew where it was located
either. If anyone has an idea of where it could be located it would be
appreciated.
|
|
5 |
421 |
|
|
Changing tires on 97 concorde LXI by
[email protected]
Hi,
Is there some magic little something that I have missed??? I removed
all the nuts including that funny little plastic one and can't get the
tire off if you paid me. It just doesn't budge. Please enlighten me,
as I am stuck completely.
thx
|
February 26th 08 02:38 AM
by Mike
|
1 |
176 |
|
|
Alternator by
Andrusbk
I'm replacing the alternator in my 02 PT Cruiser this weekend, any
pointers?
|
April 14th 06 01:38 AM
by NewMan
|
1 |
471 |
|
|
Alternator by
Andrusbk
I'm replacing the alternator in my 02 PT Cruiser this weekend, any
pointers?
|
|
3 |
354 |
|
|
dodge ram transmission please help.. by
Andy F via CarKB.com
I have a 8cyl. dodge ram 4x4 with an automatic transmission. Out of the
blue it started to shift really hard into overdrive. It seems to really
rev, and then shift really hard. It makes the dash shake when it shifts. It
doesn't always do this. All the other gears are fine, and shift...
|
|
1 |
383 |
|
|
Is the Chrysler 3.5 engine any good? by
andy[_3_]
replying to Geoff, andy wrote:
our 2005 300 has 161,000...and i was just talking to a guy who has 243,000 on
his...
--
for full context, visit http://www.motorsforum.com/chrysler/is-the-chrysler-3-5-engine-any-good-15458-.htm
|
|
0 |
2,494 |
|
|
|
|
0 |
469 |
|
|
2001 Caravan washer wiring?? by
Angel Sands
My front washer doesn't work. Think it may be a problem with wiring.
Replaced with new one, no sound when the switch is pushed in. Hooked up the
rear to front so that I can see where I am going. Would be nice to see
where I've been. If anyone can help with wiring diagram so that I might
trace...
|
February 8th 05 06:34 AM
by tdodge
|
1 |
263 |
|
|
Chrysler 300C "lemon" RETRACTION.. by
Angelo D via CarKB.com
After posting the previous thread,I have been contacted by some Chrysler
techs,who think they may know what the problem is with this vehicle.I have
also been contacted personnally via E Mail by some pretty important people
who are now assisting me and also offered to contact the dealership to...
|
|
3 |
391 |
|
|
2006 Chrysler 300C LEMON by
Angelo D via CarKB.com
I just bought the 06 300C for a price of 44K...It had 38 miles on it and is
now in the dealers repair facility.There is an apparent transmission problem
with this vehicle which thier diagnostics can't seem to locate. They have a
manfacturer representative coming to make a determination as to what...
( 1 2 3 ... Last Page)
|
July 5th 05 07:02 PM
by Steve
|
57 |
3,048 |