|
|
Reducing Power Steering Pump PSI on Modern Car by
[email protected]
Car less than 10 years old, conventional hydraulic
PSP(Power Steering Pump). I do not think it is
variable PS.
I'm a twitchy driver, and would like to reduce the
amount of PS assist, hence increasing the
amount of steering effort I need to exert before
inadvertently veering into an adjacent lane...
( 1 2 3)
|
|
22 |
997 |
|
|
|
|
1 |
542 |
|
|
How well does the $80 harbor freight bubble balancer work on cartires? by
M.L.[_2_]
I know the thinner the tire, the more static balancers do well versus
dynamic spin balancers (or road force balancers, for that matter), so we
know that's why a lot of motorcycles do just fine with just a static
balance.
And, I know that an ounce of static unbalance is far worse than an ounce...
|
July 20th 15 08:16 AM
by gregz
|
3 |
487 |
|
|
GM B-Body: 1977 and after by
[email protected]
I have been told by members of a
social group devoted to 1973-77
A-Body "colonnade"-style that
the new 1977 downsized B-body
(Caprice, Bonneville, 88, and Le
Sabre) was no more than an A-
body frame with a new body bolted
onto it.
|
|
2 |
355 |
|
|
1997 ford when cold starts runs 2 sec. then dies but starts right back by
mike[_34_]
up and runs fine have changed coil pack and the lower o2 sencer coil pack was
shoting spark to all cyc . at same time
--
posted from
http://www.motorsforum.com/tech/1997-ford-when-cold-starts-runs-2-sec-then-dies-but-starts-116232-.htm
using MotorsForum's Web, RSS and Social Media Interface...
|
|
0 |
810 |
|
|
Leisure Components 486 isolator by
[email protected]
I have a new(old stock) Leisure Components Corp. 486 battery
isolator.isolator.
I cant find them, on the web. They were in Cerritos, Ca.
I have no hook up diagram for this.
Would anyone be able to help with a diagram or hook up info?
It is not marked in any way.
|
|
2 |
885 |
|
|
drum brake, unfamiliar hardware; how to remove? by
[email protected]
('04 Cavalier, rear brakes) Instead of the since-God-was-a-boy
hold-down spring/pin/cup system, these brakes have a single large,
sort of 'W' shaped spring, spanning the two shoes, and passing over a
half-round retainer at the base. Here's a picture (set of 2): ...
|
|
2 |
384 |
|
|
my avs by
[email protected]
My Lexus ES300 wont start I keep thinking is the battery but it shows the avs lights before I goes out off and I have recharge the battery every time it goes off so I how I fix the avs , what. Should I do
|
|
1 |
300 |
|
|
Road noise, depends on steering by
[email protected]
04 Cavalier, 115K. Tires are decent, and don't seem to be wearing
unevenly.
Low-pitch droning noise at highway speed. Originally, this was only
when steering left; but now, also when going straight. The noise goes
away when steering right. ("steering" as in a lane change or road
curve.) No...
|
|
9 |
377 |
|
|
engine swap by
Teresa Sanchez
i have a 84 s10 with a 2.0 v6 i took that out and bought a 2.8 v6 off a 88 jimmy i put the other motors heads and intake manifold i got in but i think the starter doesnt fit in i crank it and it makes a scraping noise
i loose in the bolts a it worked for a little bit im thinking that the fly...
|
|
3 |
493 |
|
|
Premium grade gas for Mazda CX7 by
Andy K
The Turbo
The two upscale trim levels of the CX-7, called the "s-Touring" and the "s-Grand Touring" come with a 2.3 L, 4-cylinder engine with direct fuel injection and a turbocharger. This engine puts out 244 horsepower and 258 lbs.. per foot. of torque. It needs 91 octane fuel to achieve its...
|
|
6 |
646 |
|
|
Color code questions by
[email protected]
On my 2008 Honda Odyssey, I see this as the last line on the label at the door:
SHJ 8 AB5 - YR573M -F -B
I went to the dealer to buy touch-up paint and showed them the photo of the label I took with my smart phone. They gave me the paint with this code on the little...
|
|
4 |
314 |
|
|
GM Ignition Switch / Key Question by
Bob[_53_]
Hello,
Re the GM ignition switch fiasco:
Have had the key modified at Dealership.
Talk about a "Mickey Mouse" solution to a serious defect.
Question: If one complains, and insists, will they install a new
ignition cylinder lock at no cost,
|
|
2 |
305 |
|
|
Cadillac CTS with manual? by
Paul Hovnanian P.E.
Is a manual transmission (with clutch) an option on one of these?
Or is there an alternative explaination for a practically brand new CTS in
front of me exhibiting the classic 'I don't know how to use a clutch' lurch
at every stop light and sign?
--
Paul Hovnanian ...
|
|
5 |
434 |
|
|
P0340 code on Ford 2.0L DOHC by
Paul Barrett
Getting a P0340 (Camshaft Position Sensor signal) code on a 1999 Ford Escort
ZX2 (2.0L DOHC).
The sensor was cheap so that's the first thing I changed out - no change.
Did all the point-to-point resistance tests in the Ford procedures - all
in-spec.
Found that the timing belt had some...
|
June 26th 15 01:07 PM
by AMuzi
|
8 |
1,218 |
|
|
2003 F150 power steering hose removal: small wrench by
Michael Wilson
I'm trying to remove the power steering hose on a 2003 F150 5.4L. It's really tight where the hose connects to the power steering motor. I would need like a 2-3 inch long wrench to move the 11/16 bolt. Any experience or advice for this project?
Thanks,
MIke
|
June 25th 15 04:54 PM
by .[_2_]
|
3 |
479 |
|
|
the Italian mustang by
bob
http://racing.ford.com/enthusiasts/newsroom/2015/bertone-built-a-mustang-in-1965---but-it-hasnt-been-seen-since-.html
looks kind of GM'ish in places to me
bob
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
|
|
7 |
780 |
|
|
Lexus IS 250 tire prices by
Andy K
My friend has a Lexus IS 250.
He was told they use special tires and he has been paying $500 each.
Is that true ?
Sounds ridiculous.
My car has larger tires that go for $119 each.
( 1 2)
|
|
12 |
489 |
|
|
Urgent Opening ::Aix/Linux Systems engineer @ Tampa,FL by
Anil Chowdary
Job Title: Aix/Linux Systems engineer
Duration: 1 Year
Location: Tampa, FL
Client: Hillsborough County Public Schools
Only Green Card Holders
Submit ALL of the following:
1. Updated Resume (100% matching)
|
|
0 |
271 |
|
|
fuel line repair by
[email protected]
('04 Cavalier) I have a leak in the (steel) fuel return line, just
where it mates with the plastic line from the tank. I have released
the latch on the 'quick' disconnect, and, with effort, I can rotate
the pipe in the disconnect. But, so far, I haven't been able to pull
it out at all. If anyone...
|
|
0 |
271 |