I've had the transmission replaced a year or so ago, the van has 98,000+ on it, 3.3L V6, air, PS,PB,PW,AB,ALB, new tires. When I start to turn, I hear a clunk or a thump(dependin on your ear! :-) ) when I begin to turn. It's not the clicking of the CV joints, just a thump. I know it needs struts...

I am in the process of tightening the screws that holds the wiper trim down on my 300M at the base of the windshield. Everytime the front end is taken apart they remove it and never get the screws in tight again. I am using nylon cable ties to shrink the holes that the trim screws go into and it...

Jeeps Keep Brother of a Budding Serial Killer Busy This is a true story. After graduating high school, I didn't know what to do with my life. I had a notion to attend Akron University in 1984, but that was soon squashed. Thankfully, it turns out for the good! My mother remarried in 1984 just...

The wipers work from time to time but not consistently. Mostly I click it to the on position which starts at the delayed setting. It sometimes starts and sometimes speeds up as I turn it to the most frequent position. If I set it to low directly it rarely works and high is even rarer. The relay...

I have found it impossible to get through the telephone and e-mail maze to reach the DaimlerChrysler President's office. Does anyone have the number or experience dealing with a high level executive when you cannot get someone to listen to you? They send nice e-mails saying to call...

A few days ago the ABS light on the dashboard of our 2002 Chrysler minivan (47K miles) stays on constantly. The brakes seem to work fine. Is this anything to worry about ? Is there anything I could check myself ?

I note that the "new" unit has rounded corners , but has the same grey and black connectors. Can this unit fit and work in an old CC body? Yes, I know the "new" units have several (that means 2) screws on the LHS and RHS as compared to the "old" Cc units with a single "big" screw on the RHS and...

I'm thinking about buying a Dodge Charger SE. Anyone here own one or heard anything about it? Most reviews I've found are one the Hemi-powered Charger, so there's not much info out there on the V6.

Hey All - I just bought a used 2001 Sebring LXi Sedan... And Love It! I've been trying to figure out the autostick feature from day-one, but I have had limited success. What I am noticing is that sometimes on start up, the gear selector on the dash shows all the speeds and the P R N D are...

My '99 Plymouth Voyager is getting about 3 miles per gallon; used 1/2 tank to drive to Detroit and back to Ann Arbor (about 60 minutes of driving). Notice needle going way down on short trips as well. No smell of gas, tank doesn't empty when car's not running, exhaust doesn't smell overly gassy. ...

I heard Gov. Jennifer Granholm of Michigan being interviewed on the radio this morning. She referred to an engine plant in Dundee, set up jointly by D-C, Mitsubishi and Hyundai, where labor costs are only 3%. This is a unionized (UAW) plant. If labor costs so little, how much is to be saved by...

Is it someone who knows exactly what the contents of a tow kit/tow package is???. I know about the extra tranny cooler, but what else is it? My car is a Chrysler Grand Voyager LXi 3.8L -96

I know this is not the right place to ask for advice,but anyone who can I would appreciate it.Here is the problem,October 25 2004,my husband and I traded in my truck to a dealership.They then sold it to another dealership in south Texas.Well on January 20 2006, I recieved aletter from a wrecker...

I've just put my 92 plymough voyager in the auto trader. It has 147k. It's a little rusty with the common light blue peeling paint syndrome. It has the 3.3L v6. The only problems are that the downpipe disconnected from the cat inlet. It was clamped and I think the clamp rusted through. It's...

My 96 LHS ran hot the other day. Symptoms we Wife said she smelled antifreeze inside the car. Saw no evidence of a heater core leak. Popped the coolant tank cap and it blew coolant out pretty hard. Left it running and put in some water until it calmed down a bit although it continued to...

One of my OEM alloy wheels on my 01 PT Cruiser has an inside dent. It is enough to give a measurable runout on the inside of the tire tread. Is it ever OK to take a whack at the rim with a sledge hammer to work out the bend or is this always a death sentence for the wheel? (I know, I will pick up...

Anyone know which cylinder is #3 on my 97 3.5l Concorde? According to my Chilton's it is 56 34 12 front I don't trust the book because I found a few pictures that were wrong- they were upside down or reversed! I got a code 43- Autozone put a tester on it and said it was #3 misfire- I replaced...

heater blower dont work, I cannot find the resistor on the fire wall or a relay switch, i changed fuses and checked them all, seems like half work and thats it

My 2002 Chrysler town and Country van suddenly refused to let me turn the key to start it up. I tried all the conventional tricks like moving the steering wheel a bit. Nothing! In desperation I gave the car a hot shot from my brother in laws car. I don't really know why. There wasn't a hint of a...

The passenger-side carpet is wet underneath the floor mat on a 2003 voyager I recently purchased. We are in South Florida with the A/C running when we drive so I am assuming it is the drain on the A/C. Any ideas on how to fix this? Thanks Tim