|
|
Question on vortec 'poppet' style fuel injection system by
AWN
Good day,
I was wondering if anyone could confirm or deny this for me... Regarding
GMıs poppet injection spiderı system on the 4.3L vortecs, etc., do any of
you know if all cylinders receive fuel at the same time? In other words, is
it possible to mix up the poppets or if theyıre all working...
|
June 18th 07 03:57 PM
by AWN
|
7 |
503 |
|
|
hesitation and random misfire (4.3L Vortec 95 Jimmy 4x4) by
AWN
Good day,
If there are any GM techs here, perhaps you could tell me if I might be
missing something. I canıt seem to shake a +25% Long Term Fuel Trim issue
that causes hesitation at low rpms and occasional random misfire and cyl 1
misfire codes. The fuel pressure at the rail with the key off is...
|
May 27th 07 05:54 PM
by AWN
|
0 |
887 |
|
|
240sx 1992 - a/c condenser RE/Re question by
AWN[_2_]
Hi there,
This may sound ridiculous but does anyone have first-hand experience pulling
an A/C condenser out of a 1991 Nissan 240sx (S13)? It seems like the pass
side corner is bolted to the frame or something - I don't know how to free
it up. The system has no gas in it right now and I am putting...
|
|
3 |
274 |
|
|
A/C techs: will a venturi vac pump work well enough foroccasional use? by
AWN[_2_]
Good day,
I was wondering if a venturi (air actuated) vac pump will suffice for
pulling 28inHg to evacuate moisture from my A/C system in a project Nissan?
I have heard of shadetree mechs using engine vac as well for this task in a
pinch. I don't want to rip apart an old fridge nor do I want to...
( 1 2)
|
|
10 |
592 |
|
|
|
|
1 |
1,145 |
|
|
Ng for bodywork and refinishing? by
AWN[_2_]
Hi there,
I wanted to know if any of you knew of a ng to discuss autobody work, paint,
panel retrofits, etc? Is that fair game here? I need advice about how to
tackle a bad quarter panel and rocker. I don't know if I should cut one out
of a donor car or patch the existing one. The rocker has a...
|
|
0 |
472 |
|
|
Do any of you use an oxy-acet torch for exhaust work? by
AWN[_2_]
Sorry for the xpost...
> I have some exhaust work to do on an old project Nissan and I'm wondering if
> any of you use gas torches for this? If so, what do you best suggest for
> the filler? I've heard that coat hanger and bailing wire material works
> well but I also have some rods kicking...
|
|
1 |
383 |
|
|
A/C problem- 95 Jimmy SLT 4x4 by
AWN[_2_]
Sorry for the repeat post from alt.autos.4x4.chevy-trucks I thought I cc'd
these ngs also... Ooops.
Good day,
I have searched on this and looked at a few different scenarios but I
thought
I'd ask if anyone has seen a solution firsthand... My A/C blows very cold,
the evap/drier get very...
|
|
9 |
586 |
|
|
Silly question on vac reservoir/check valves by
AWN[_3_]
Good afternoon,
I can't believe that I'm stumped on this one but perhaps we could have
some light shed if possible...
My 95 S15 Jimmy used vac actuated blend doors, transaxle switching, etc.
It's the system with the vac 'ball' under the hood. Here's the question -
where do check valves fit...
|
|
0 |
231 |
|
|
|
|
1 |
308 |
|
|
Valve cover bolt thread pitch and diameter?? by
AWN[_3_]
Hi there,
Is there a common size for imports such as Hondas and Nissans? More
specifically, does anyone know what pitch and diameter the valve cover
stud/bolt is for a 92 Nissan 240sx?
Thanks.
Andrew.
|
|
2 |
194 |
|
|
peugeot 306 td 95 by
axel via CarKB.com
my fuses keep blowing need diagram of fusebox to see where to put the fuses
plz help me
--
Message posted via http://www.carkb.com
|
|
1 |
400 |
|
|
|
January 14th 05 10:03 PM
by Ayn
|
0 |
298 |
|
|
|
|
0 |
264 |
|
|
Mazda MPV Timing belt by
Ayre Schnell
is the mazda mpv timing belt suggested change interval at 60k miles?
if yes, is there also a reset required for some type or alert on the dash (that may or
may not come on at about this time)?
( 1 2)
|
|
11 |
908 |
|
|
What paperwork is required in CA for an out-of-state vehicletraffic stop? by
AZ
I searched all over the California DMV web site and I can't find the
requirements for what paperwork is required during a traffic stop when
you're driving an out-of-state vehicle in California.
I'm pretty sure they require both registration and insurance paperwork
but I can't actually find...
( 1 2)
|
|
17 |
962 |
|
|
2002 Dodge Intrepid pinging by
AZ Nomad
I've got a 2002 Dodge Intrepid that is pinging way too much. I've switched
to premium fuel and that helped a bit at first, but it is still pinging too
much. Vehicle has 145K miles.
A mechanic who saw the car suggested that the combustion chamber has taken
on carbon and that has increased the...
|
|
3 |
209 |
|
|
|
|
0 |
323 |
|
|
Transmission fluid leak by coolant line by
[email protected]
I have a 95 Nissan 240sx. There seems to be a pink oily substance by
the coolant line leading out from the rad. It only leaks if i were to
rev the engine. I was wondering could it be possible that the pink oily
substance be transmission fluid and would it come out from the rad? Any
suggestions on...
|
|
3 |
374 |
|
|
Ford Focus Locking Steering Column - 2001 by
a[_2_]
We just bought a used Ford Focus with 65K miles. The igniotion switch
started to give us problems and after researching the problem I found out
that ignition cylinder failure was very common on theses cars so I replaced
the cylinder.
That did not fix the problem. The switch works and I can...
|
March 19th 07 12:58 AM
by a[_2_]
|
2 |
340 |