A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Ford Explorer Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Extreme shutter after steering rack installed by plex4r
I just replaced the rack in my 1995 EB Ford Explorer. I filled the steering reservoir and started the engine. The car is still up on jack stands. With a helper slowly turning the wheel I kept filling. At this point it took less than a quart. When the wheel is turned you can feel it is very...
July 9th 08 10:40 PM
by plex4r Go to last post
0 516
Stabilizer Link question by [email protected]
Here's a pic from my 98 Ford Explorer: http://tinyurl.com/5mfsg6 Is it a stablizer link? I had a break job done recently and they said I needed to do something with my stabilizer links. I cannot remember if the link was bad, or needed tightening, rubber thingys, or something. I am able to move...
July 8th 08 07:56 AM
by jonezzzman[_2_] Go to last post
2 556
98' Explorer 2WD Steering Rack by dosio
Hi everyone, I come across a problem , trying to pin point. Recently when truck is not moving but engine running , turning the steering wheels ether left or right , I get very noticeable vibration on steering wheel. Check oil , it was fine. If truck is loaded with something heaver, by turning...
July 7th 08 04:02 AM
by No Name Go to last post
1 621
Advice to Explorer Drivers by C. E. White[_2_]
I had an Explorer almost run me off the road this morning. This prompted me to give Explorer drivers a little friendly advice - When using your turn signal as a virtual bumper, please be sure that your intended victim can actually see your turn signal. Here is what happened - I was driving...
(Multi-page thread 1 2 3 ... Last Page)
July 6th 08 08:19 PM
by Jack[_4_] Go to last post
107 9,213
2002 Explorer Front Wheel Bearing Removal by George[_21_]
Hi- I am trying to replace the front wheel bearing assemblies on my 02 Ford Explorer XLT V8. I cannot get at the three 15mm bolts that hold the assembly onto the back spindle housing. Does anyone know if these require a special tool? I've tried all sorts of box wrenches. Sockets will not clear...
July 3rd 08 08:29 PM
by Jim Warman Go to last post
1 702
test msg. by Bill Hall
July 2nd 08 04:09 PM
by Bill Hall Go to last post
0 360
ford explorer a/c by darthmaul72
I have a '94 explorer and I am replacing the compressor the dryer and the expansion tube. I know that I have to flush the evaporator and the condensor but I'm not sure about the flushing process. If anyone has any info on how to flush the a/c system, I would really appreciate it....
June 30th 08 04:29 PM
by darthmaul72 Go to last post
0 605
having trouble with transmission by [email protected]
I'm buying a 1995 ford explorer the only problem is that the truck sticks in first gear it wont go into second we think it might be the modulator if anyone knows why it wont go into second let me know.
June 29th 08 07:19 PM
by Jim Warman Go to last post
4 369
Help us save usenet news for Time-Warner customers by Usenet user
Time-Warner corporate is dropping usenet news as of June 23, 2008. Please help by asking them to keep it. The person to call works for the TW president: Barbara Burroughs phone 203-351-2281 email: ** Posted from http://www.teranews.com **
June 23rd 08 11:47 PM
by Jim Holcomb Go to last post
2 540
toast by Jack[_4_]
taste
June 22nd 08 06:06 AM
by Jack[_4_] Go to last post
0 450
1997 ford explorer xlt awd 5.0 v8 143,000 miles on it. by bubba
i have to replace the a/c pump on my explorer. it came with these round shims,and a long inline filter. where does the filter go and it says the pump dosent come with the oil. how much oil do i put in it or does the 134a come with the refill kit and how much oil do you put in. ? oh i got the pump...
June 20th 08 06:48 AM
by bubba Go to last post
0 459
cooling system part name? by RickinSLC
Hi all, Can’t find my shop manual and need to know a part name. 96 exp-V6. As you face the vehicle, it’s in the upper l/h quadrant of engine compartment. About the size of your palm; 2 hoses fitted on one side, 1 on the other; vacuum line goes into top; diaphram hooked to little metal lever. ...
June 20th 08 06:41 AM
by bubba Go to last post
1 496
Power Window Problem by Tube Audio[_2_]
I have a 1990 Ford Ranger with Power Windows. Today when I went to raise the driver's side window it would not go up. I heard a clicking sound as if something was slipping or not engaging. If I grabbed the window with one hand while holding the window in the up
June 19th 08 09:25 PM
by Charlie Bress[_3_] Go to last post
1 502
How to tell if My CV joint is bad in my back wheel? by McNick
Hey everyone, I have a loud clicking noise coming from my back drivers wheel... It sputters when I accelerate, and makes a whining noise on the highway. The clicking is only at low speeds. I am thinking its the CV joint, but not sure. I have had everything else checked out, so its just about the...
June 19th 08 03:23 AM
by McNick Go to last post
0 522
Help! 2002 "Audiophile" wiring by akheel
I've done everything I know to do and I still can't get the answer. I went to install an aftermarket audio/video/nav unit in my 2002 Mercury Mountaineer. The truck has what the manual calls the "Audiophile" sound system which includes a subwoofer. I have a Chilton's manual with wiring diagrams,...
June 18th 08 09:33 AM
by akheel Go to last post
0 508
2002 Explorer Heater Hose Tee by [email protected]
We have an Eddie Bauer 2002 Explorer. Today, we blew a heater hose fitting. It seems like a tee that was press fit onto the heater hose. It seems that the hose goes from the thermostat, back to the tee, and is then routed twards the back of the vehicle and towards the (passgenger)firewall. I...
June 11th 08 02:54 AM
by [email protected] Go to last post
0 920
07 MY Explorer Eddie Bauer v8 4x4 has CLUNK when starting and stopping by Stephen Beck
My 98 sport did this too. They'd "tighten" something related to the driveshaft, but it would reappear. I'm 1 year in a 3 year lease? Can anyone tell me what this might be and if I'll have to live with it another 2 years!? Thanks!
June 8th 08 03:16 PM
by Stephen Beck Go to last post
0 494
2007 Explorer Keyless Entry Codes No sticker on computer module by [email protected]
Is there a method to get the codes without the label on the computer module? Just bought the Explorer and have no codes for the keyless entry. I can find no sticker on the computer module. Is there a way to get the code other than being extorted by the Ford Dealer? Thanks for any help.
(Multi-page thread 1 2)
June 6th 08 11:57 AM
by Esteban Go to last post
11 967
All Weather Floor Mats by adnvi77o
Just Because I thought this was cool... The Intro-Tech Automotive All Season HEXOMAT™ Custom Auto Mat is manufactured in the USA (877) 712-4222 using only the finest quality non-fading and non-cracking materials. http://www.customautoaccessories.com/All-Season-Auto-Hexomat.html The exclusively...
June 6th 08 09:49 AM
by adnvi77o Go to last post
0 725
Drop link rod part number? by Gorf
Does anyone know the part number for the front drop link rods? If you know somewhere that will ship to the UK and accepts PayPal that would be a bonus, too... :o)
June 4th 08 05:20 PM
by Gorf Go to last post
0 329
Post New Thread


Display Options
Showing threads 261 to 280 of 3084
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 12:56 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.