|
|
How to adjust rear door opening height? by
blueheron
Hi all,
I have a 2000 xlt. When I'm parked in my garage and open the rear door it
hits the top of my garage entry (resulting in paint scratches). I was hoping
someone here could either point me towards some online instructions or share
their knowledge on how to adjust the opening height so that...
|
|
5 |
468 |
|
|
How to change the battery terminal by
Jonelle H via CarKB.com
I have a 1991 Ford Explorer and my nephew said the battery terminal needs
changed but he didn't have time today. I went and got the new terminals but
I don't know how to change them. Could someone help me with this? Thank you.
|
|
1 |
1,641 |
|
|
How to check belt tensioner? by
Happy Traveler
'98 Explorer with 5.0L engine, 115K miles. Serpentine belt started chirping
at start-up in cold weather. Driving through puddles with cold engine makes
it worse - a deep puddle caused it to slip so bad that I lost power steering
until the belt dried up -- bad deal! Couldn't do much about it,...
|
|
5 |
573 |
|
|
how to clean IAC valve ? by
Cindory
Hi,
after reading some news here, i would like how clean my IAc valve?
We'll change oxygen sensor next week-end but, may be, my IAC valve needs to
be cleaned. How can I do that ?
Do i have to change the gasket if I don't change the valve ?
I have a chilton book, but they say how change it but not...
|
|
9 |
384 |
|
|
How to disable alarm by
Rush
I have a 2002 Ford Explorer and want to disable the alarm system. Darn
thing is unpredictable.
|
April 6th 07 03:41 AM
by Rush
|
0 |
540 |
|
|
how to remove steering rack? by
[email protected]
I have a '98 Explorer XLT, and I need to take out the steering rack.
I have a Haynes manual, and it says to disconnect the steering input
shaft; remove the hoses; remove the power steering cooler; separate
the tie-rod ends from the wheel spindle; and remove the steering gear
mounting bolts.
Then...
( 1 2)
|
|
13 |
637 |
|
|
How to Replace 97 Explorer Blend Door Actuator Fails with Clicking Noise by
cw
Followed Steve's advice, replaced blend door actuator, fixed problem.
(
http://groups.google.com/group/rec.autos.makers.ford.explorer/browse_thread/thread/cb2c2e662bde8ad5/e8b72a6d051afa07?lnk=gst&q=blend&rnum=18#e8b72a6d051afa07
)
Here is my report:
The situation
1997 Explorer Limited, AWD. Air...
|
November 6th 16 06:18 PM
by Scott
|
2 |
3,386 |
|
|
How to replace antenna base? 99 Sport by
Some Guy[_2_]
Does anyone how I could replace the antenna and base on my 99 Explorer
Sport?
Recently, it came flying off right in the middle of a drive-in car
wash (yeah, it happens!).
Anyways, I mistakenly bought just the top metal part, but it won't fit
the base, there seems to be a piece of the the old one...
|
|
0 |
272 |
|
|
how to replace explorer 99 high mount lamp by
ed
What's the remove/replace procedure for the 99 high mountl amp. The
newer ones have external screws but this must have some internal
release behind the liner or else some kind of snap release.
|
January 10th 06 01:02 PM
by ed
|
0 |
521 |
|
|
How to tell if My CV joint is bad in my back wheel? by
McNick
Hey everyone,
I have a loud clicking noise coming from my back drivers wheel... It
sputters when I accelerate, and makes a whining noise on the highway. The
clicking is only at low speeds.
I am thinking its the CV joint, but not sure. I have had everything else
checked out, so its just about the...
|
June 19th 08 03:23 AM
by McNick
|
0 |
523 |
|
|
How to Test O2 Sensors on '97? by
Ulysses
I have a '97 Explorer, Control Trac, auto trans, and 4.0L OHV engine. I
have error codes PO136 and PO141. I tried to test the O2 sensors as
outlined in my Hayne's manual but am unable to manage to get a wire into the
connector so I can test it. Is there a trick to this? Hayne's says not...
( 1 2)
|
|
13 |
2,092 |
|
|
How to unstick an IAC? by
[email protected]
I've been having some typical problems with my Explorer not keeping
idle. I've cleaned the IAC once ad it fixed it, for a while. The
other night I had to just rev up the engine for a second to clear it
out. Today I noticed its doing the same thing. Tried cleaning it and
no luck this time. I...
|
January 28th 05 04:58 AM
by Kevin D
|
1 |
295 |
|
|
How to use 4wd feature on 2000 Explorer - EB by
Theresa
Hi all. My manual was stolen out of my car a while back and I haven't
replaced it yet.
I will be driving in some possibly heavy snow this weekend and was
wondering how to use the 4wd feature. Is it as simple as just "turning
it on"? Does the car need to be in motion, park, etc when turning...
|
|
6 |
459 |
|
|
HP Desktop for sale! by
pbdude
Hi,
I have an unused HP Pavilion with the fallowing specs:
# Processor: AMD Athlon 64 X2 4000+ (2.1GHz, 2000MT/s System Bus)
# Memory: 2048MB PC2-5300 DDR2 SDRAM memory (2x1GB) (expandable to 8 GB (4 x 2 GB) (64-bit OS)/ 4 GB (4 x 1 GB) (32-bit OS))
# Hard Drive:320GB 7200RPM SATA 3G (3.0 Gb/sec)...
|
October 14th 07 09:36 AM
by pbdude
|
0 |
247 |
|
|
Hubs or worse by
Tom
Hi,
I have a 1993 ford explorer. One of the manual locking hubs wont shift
out of free position but after putting it on the hoist and turning it
it spun the drive shaft indincating it was in lock position. When
driving it I get a horrible grinding noise that increases with speeds.
I am forced to...
|
February 10th 06 02:10 PM
by Tom
|
2 |
333 |
|
|
Humming '96 EB 4x4 by
KJ
My '96 EB 4x4 emits a loud humming sound from the front end that is loudest
between 40 and 50 mph. The sound goes away when I steer to the right, but
is unaffected when I steer left, so I figured that it must be the bearing
and hub assembly on the right side of the truck (steering to the...
|
June 4th 06 07:16 PM
by JohanB
|
3 |
440 |
|
|
|
|
0 |
942 |
|
|
I am going to jump off a bridge by
[email protected]
Hello all:
I bought a 2002 Ford Explorer with 42,000 miles on it. I love the
truck, excepet for these niggling issues.
1. Between 2300 and 2800 RPM I hear a noise like metal being ground up
in a blender.
2. there is an annoying squeak that comes from the rear end of the
truck when I go over...
|
March 15th 05 08:00 PM
by HeyNow
|
2 |
558 |
|
|
I had to tighten my (idle?) because my 2000 wouldn't stay running, HELP? by
coachpaul2003
I really do not know a lot about cars but I am trying to learn and I was on
a trip of one way 1400mi. and i got there and drove around town everyday.
When i got ready to leave my explorer would start but die unless i kept my
foot on the accelerator. I do not know what to call it but i screwed...
|
March 22nd 05 01:25 AM
by David
|
3 |
490 |
|
|
i need a new drivers seat for my explorer 1993 model by
hedgerum
anybody know where i can find one to buy online for a good price ? i
plan to hunt some junkyards this weekend also but just shopping around,
my current seat has totally collapsed, quite hard to drive in its
current shape. thanks to all in advance
|
|
1 |
866 |