|
|
94 A4LD Vacuum Modulator Replacement by
rj
I have determined that the vacuum modulator is defective (tranny fluid in
the vacuum hoses) and have a replacement ($37.50) to install.
I removed the passenger seat and console and peeled the carpet up to expose
an access cover on top of the tranny hump.
It appears one bolt/stud secures the...
|
December 24th 04 04:23 PM
by rj
|
2 |
644 |
|
|
94 AC by
rj
The clutch seized on my AC compressor so I've picked up a new/reman from the
parts house. Questions:
1) Tag on new compressor says is shipped with "minimal" oil. What kind of,
how much and where should oil be added?
2) Got a new "dryer" at the same time but see no way to "break" the old one
out....
|
January 25th 05 09:15 PM
by rj
|
0 |
288 |
|
|
94 AC Compressor Replacement by
rj
The clutch seized on my AC compressor so I've picked up a new/reman from the
parts house. Questions:
1) Tag on new compressor says is shipped with "minimal" oil. What kind of,
how much and where should oil be added?
2) Got a new "dryer" at the same time but see no way to "break" the old one
out....
|
|
2 |
356 |
|
|
94 Air Conditioning by
rj
The clutch seized on my AC compressor so I've picked up a new/reman from the
parts house. Questions:
1) Tag on new compressor says is shipped with "minimal" oil. What kind of,
how much and where should oil be added?
2) Got a new "dryer" at the same time but see no way to "break" the old one
out....
|
January 25th 05 09:13 PM
by rj
|
0 |
452 |
|
|
94 Auto Door Locks Not by
The Ranger[_3_]
My wife's 1994 Explorer XLT 8-cylinder is starting to get a
little long in the tooth apparently. It recently clicked over
the 150K mile when multiple things simply gave up their
collective ghosts.
First was the fuel pump -- right _after_ I filled the tank. 17
gallons of premium unleaded down...
|
|
7 |
554 |
|
|
94 Brake Problem by
Randy
I have a 94 sport that I bought new and have had a few minor mechanical
problems over the years but I need help to figure out this one. The brake
pedal will freeze/lock in the up position when applying the brakes. If you
continue to press the pedal it will eventually give and brake the car,...
|
|
2 |
486 |
|
|
94 EB 4x4 drive shaft by
Paul
Changing U-joint on Pass. side front 4x4 drive shaft. How does this side
remove from diiferential? Drivers side just slides out easy, Pass side
stays put. What holds the pass. side in?
Thanks
|
August 8th 05 08:11 PM
by Chris
|
2 |
764 |
|
|
94 EB 4X4 Driver Seatbelt problem by
Sam[_3_]
94 4x4 EB Explorer. Driver side seat belt has been a pain in
the rear to use over the last year. Hard to pull out...doesn't
retract automatically sometimes.....etc.
Today tried to use it and I could not pull it out any. I am unable in
other words to use the seatbelt. It is stuck.
2...
|
|
2 |
349 |
|
|
94 EB 4x4 intake gasket procedure by
Sam
Last week I torqued down my lower intake manifold bolts hoping to
solve the "mysterious" coolant leak that leaves no drips anywhere.
Well a week after I have done this I am still lossing coolant.
Later on today I am going to pull the intake manifold off and examine
the the manifold area.
I have a...
|
March 26th 06 02:54 AM
by JohanB
|
1 |
526 |
|
|
94 EB 4x4 License Plate Light assembly by
Sam[_3_]
On the rear of my vehicle is the license plate. The license
plate has 2 bulbs that shine on it...one on the right and one on the
left. The assembly stays in place an whenever you need to change the
bulb one pulls the bulb assembly out the back and replaces the bulb
and then reinstalls the bulb...
|
|
2 |
630 |
|
|
94 EB 4x4 remote issues by
hello
I have a 94 EB 4x4 Explorer. One day I came out after work to find my
doors unlocked. I KNOW if locked the doors. I shrugged it off and
did not think anything of it.
Then one day my stock car alarm started to go off. I quickly disarmed
it.
Ever since then the remote control functions of the...
|
July 20th 05 02:49 PM
by hello
|
3 |
438 |
|
|
94 Eplorer-Enginer Probelms by
ckirk
I have a 94 Explorer with the 4-liter V-6 with engine trouble. The engine
starts and idles fine, however, under all levels of acceleration including
driving under power at speed the engine hesitates and sputters causing a
loss of power. When the gas pedal is released the engine calms down,...
|
|
4 |
256 |
|
|
94 Exp 4wd V6 tranny ? by
Henry Kolesnik
124,000 miles..
The tranny slips when cold but OK when it warms up..
Also need to know if there is a vacuum line that controls it?
Thanks
Hank
|
|
5 |
407 |
|
|
94 Exploere stalling cold ? by
Henry Kolesnik
It stalls when trying to take when the engine is cold. I think the idle is
too low as it's a little below 500 on the tach. Can anyone tell me what the
factory spec. on th eidle speed is ?
tnx
--
73
Hank WD5JFR
|
|
1 |
426 |
|
|
94 explorer by
[email protected]
The transmission does not move anywhere when I put it in overdrive or first it'll only take offense I'm going down the road I can shift from 2nd to drive and the rest of the gears does anybody know what the problem is
|
|
0 |
1,874 |
|
|
94 explorer by
team3
looking for the location of the port to recharge the a/c on my 94 Explorer
|
|
1 |
269 |
|
|
94 Explorer - anti lock brakes pulsing when parking by
Randy Johnson
Hello all -
For the past few months, my anti-lock brakes will activate when pulling
into a parking space. It can be a shock sometimes when you feel like your
brakes aren't working. Brakes are fine at all other times - only happens
when the front wheels are cranked sharply.
Could this...
|
|
2 |
495 |
|
|
94 explorer 5 speed 4 Wheel Drive ? by
KD4PQF
I can not get my four wheel drive to engage...It acts like the
push puttons on the dash are not working. How do i check them or what
else do i look for?
Thanks
|
November 12th 04 07:25 PM
by Ulysses
|
2 |
1,312 |
|
|
94 Explorer A/C Clutch not operating by
Deanesfield
Hi
I have noticed that my A?C clutch doesnt operate when required
I have put a meter across the plug and get no reading - I have check
the fuses
Is there a relay I should check or is this serious ??
Regards
|
|
7 |
449 |
|
|
94 Explorer Auto Transmission Problem by
Fred
My automatic transmission started pumping the fluid out. I was told that it
was probably the cooling line that broke. How much of a job is it to
replace the cooling line and is it rubber or metal? Thanks for any info.
Fred.
|
|
3 |
765 |