Can anyone tell me how to purchase a replacement bulb for both my rear wiper switch and my rear defroster switch on my 2002 PT Cruiser? I've removed the bulbs (easy to do as they simply unscrew with a quarter turn), but the Chrysler dealer tells me the bulbs aren't sold by anyone, including...

I am trying to remove my alternator from a 94 Voyager with a 3.3 engine. I have it detached from the engine but I cannot get it out from the bottom and back of the engine. It just will not squeeze through the space to the right of the exhaust pipe between the body and the crossover...

The models with 15" wheels have about a 36.5' turning radius -- with 16" or 17" wheels the turning radius gets larger -- as high as 40'. As long as you're aware of it from the start then it's fine. I recently test-drove a new PT Cruiser Limited and found it very enjoyable overall. It's probably...

Hello everybody: I have a 1997 Plymouth Voyager 3.3 Auto Tranny 4 speed has 56,800 original miles. I had or have a problem related to the Radiator Fans relay, I bought it brand new from Chrysler friendly dealer, because the fans would run and run and run, and they told me that the relay "hidden...

This is probably a DS question or rather answer. I just looked up the specs for Sylvania bulbs for the 9004 series using: http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/Products/ProductComparison/default.htm What blows my brain is that the lumens is identical for all the products,...

Hi I have a 1996 chrysler LHS.....everytime I go through a large puddle of water in road, my check engine light comes on and car stalls.....the car will start turning but takes awhile for it to start....then eventually starts and runs fine, but check engine light remainson. ...... I have had new...

Many parts have been replaced in the front end of my 300M 1999 to eliminate a clunk that started with a problem with front left strut. Most were done under the extended warranty including steering rack and front struts. They just replaced the bottom half of steering column and the left strut...

So I go to Cottman (who have done good work for me in the past) and get a full drain, flush, pan drop and clean service on my transmission. Verify proper fluid. A few weeks later I notice a very minor oil leak on my carport. I didn't put two and two together and figured I had developed an oil...

As you well know (thanks to Thelma Ritter for that phrase...) there is a conversion to put a 5 speed Toyota box behind Mr. Slant Six. Which one, and where do you get the bellhousing?

Chrysler Turbine Car >From the early 1950's to approximately 1980, the Chrysler Corporation built a series of dedicated automotive gas turbines. There were at least seven generations of Chrysler turbine engines designed, built, and run, at a cost the company to this day will not disclose,...

Happy New Year. My sister in law is looking at her first new Chrysler product in years. She had an early 1980s Horizon, but for the past 15 years has had a reliable Mazda 323 that now is approaching 300K miles (YES, 300K miles). Anyhow, she is considering an 2003, or newer PT Crusier...

Let's say hypothetically I have a Magnum 318 Dodge truck with a dead ECM and I want to get rid of the ECM entirely. I know there is a carb manifold available, will a standard electronic or points distributor fit these engines? Or is there an aftermarket one that does and provides conventional...

I'm lost with fwd cars - none of the parts are in the right place! any advice or opinions welcome: on a '95 Chrysler LHS.....nice car, 110,000 miles, in great shape (should be with all the new parts on it)..... has a CLUNK when the wheel is cranked full left (going forward) or right (going...

Not sure of the source of this problem, so hoping someone here can help. I have a 92 Voyager with 3.3 and 4 spd. tranny. The speedo does not go all the way to 0 (zero) during stop and go driving and on long trips, the needle gets stuck at various places on the speedo. Tapping the speedo cluster...

Hello: I went to replace the #74 bulbs in the AC control in my 1991 LeBaron. Easy job, I thought, until I removed the center fascia. The dashboard's mounts are disintegrating! The radio is being held by two threads of plastic, and when I went to turn the screws on the AC control's mount, plastic...

I got codes 21 and 51 which indicate a faulty O2 sensor on my 91 Grand Caravan with a 3.3Litre engine. What is the easiest way of changing the Oxygen Sensor? The 3.3 Engine does not leave any room between the air intake plenum and the firewall for access to anything on the righthand engine cylinder...

I would like to mention my observation on how the power windows operate electrically. The system consists of one where all 4 window motors (4 door car) have power on both leads whenever the ignition is on. Pressing a window switch simply removes power from and grounds one lead or the other...

I'm going to take a trip which will require pulling a trailer behind my 92 Voyager w/ 3.3. I may have to travel down and up some steep hills and my question is: If I'm in 3rd and travelling between 30 and 35 MPH, can I manually move the shift selector from 3rd down to 1st without damaging these...

Since there have been many posts here about this problem I thought I'd relate my recent experience (Dec 28/05). 2001 Intrepid 2.7L V6 ("R" code engine) with 220,000 Km (136 K miles). Oil/Filter changes every 5000 km (3100 miles). Oil has been 5W-30; either Valvoline Maxlife or various brands of...

I know this may be a stupid ?... my mom has a flat tire on her PT Cruiser.. front drivers side. I removed the lug nuts but the wheel still isn't coming off. She doesn't have a manual as she got the car used... What do I need to do to get it off??? Thanks!