|
|
|
|
1 |
583 |
|
|
'01 Yukon Rear Disc brake pad change by
[email protected]
Greetings;
I'm about to help a neighbor change the brake pads on a Yukon SUV.
I'm not sure of the year but it is probably a 2001, model SLT.
Are there any tricks in changing front and/or rear pads?
Do I need the special tool to rotate the rear piston back into the
caliper, or is it as easy as...
|
August 27th 06 12:44 AM
by Shep
|
2 |
468 |
|
|
89 cutlass sierra TPS adjustment by
Trav
Is there anyway to adjust the throttle position sensor.
Tried putting a used one in but still same results. While going down
the road the car pulses and surges, kind of loses power and slows then
jumps back up.
its a tech 4 2.5 ltr
sounds like a diagnostic comes back as the TPS is low.
|
|
5 |
786 |
|
|
calling the smog gurus by
hex
hi I just failed the good ole california smog test i have a 98
civic EX manual
109K i failed with high HC tthe first time around cause i just drove
it in without doing anything
since its never failed before after failing once I did new plugs, dist
cap and rotor added 2 cans of heet to 1/4...
|
|
2 |
722 |
|
|
Question on Stalling??? maybe fuel pump?? by
hdivr
I have a 2003 Ford Explorer Sport Trac with 68,000 miles. I'm thinking
I have a fuel related problem. Idles fine and will accelerate normally
up to 3,000 rpm. After that, runs rough and won't accelerate. Let off
throttle and idles normally again. So I replaced fuel filter.....no
luck.
Now I'm...
|
|
6 |
468 |
|
|
98 Maxima/Start-up Blue Smoke by
Cool Breeze
Hi, my 98' Maxima has about 126,000 miles; it runs great; burns about
one quart of oil every 2,200 miles; and all other fluid levels are
perfect and so far require no topping off.
Problem: If I've driven it hard the night before, it tends to smoke
from the tailpipe upon starting (blue smoke). ...
|
|
2 |
519 |
|
|
HEI by
pater
What year did GM switch from points to HEI. Was the first year for HEI
73 or 74
|
August 27th 06 04:00 PM
by ray
|
5 |
549 |
|
|
Engine brake in Automatic gearbox by
[email protected]
Hello.
In an Automatic gearbox, instead of a clutch, there's a torque
converter, right?
Now, I know that in manual gearbox, engine brake happens because the
engine is 100% connected to the wheels - so engine revs down = car
slows down.
However, in automatic gearbox, there's the torque converter -...
|
|
9 |
992 |
|
|
Another steering column question (Cavalier) by
George[_1_]
('99 Cavalier) With the lock plate removed, should the steering shaft be
falling back down the column? Mine is, making it very difficult to put
the lock plate back on.
TIA,
George
|
|
5 |
654 |
|
|
Mazda 626 sway bars by
nrmartin
I have a '99 Mazda 626 V.6. Are the following the same thing? "sway bar
link kit" and "sway bar bushings and stabilizing links"? I had the former
replaced in Feb. 2004 and am being told I need the latter. If they are the
same, how often do these things need to be replaced, normally?
|
|
2 |
576 |
|
|
Transmission Valve body gaskets by
davemac[_1_]
Any tranny techs out there? I have been rebuilding my wife's 93
Toytota camry transmission valve body (A540E) and have run into a snag.
I have all the replacement gaskets, but for the seperator plate
gaskets, the original gaskets seem to be 'bonded' to the upper and
lower seperator plates. Don't...
|
|
0 |
294 |
|
|
Fuel pressure regulator? by
John P.[_1_]
Where is the Fuel pressure regulator located, on a 2001 crown vic? Is
it easy to replace? What are the steps. thanks!
|
|
0 |
593 |
|
|
I rounded the bleeder screw - what now? by
bryanska
Hi,
I bled the brakes in my 2002 Alero yesterday, for what I plan is the
only time. I'd like to know the bleeding process I'll have to follow,
now that I have to replace one bleeder screw.
Two of the bleeder screws were rounded in the process. I used a flare
nut wrench specifically designed for...
|
|
3 |
1,082 |
|
|
1988 old calais by
sirdigger18058
Hi all. I have a 1988 olds calais with the tech 4. Can anyone tell me
where the fuel cut-off solenoid is located? Many thanks
--
sirdigger18058
------------------------------------------------------------------------
sirdigger18058's Profile:...
|
August 27th 06 08:52 PM
by Shep
|
1 |
623 |
|
|
'95 pontiac Grand Prix-theft deterrent relay problem by
Ebay
Hi can anyone help me ,I have a problem starting this car it will start
sometimes, but when sitting for a while it will not. I have changed the
starter motor, but it still does the same thing. It has and alarm system on
it also with a theft deterrent relay inline with the starter system, I...
|
August 27th 06 08:57 PM
by Ebay
|
0 |
1,855 |
|
|
1992 buick 5.7 odometer malfunction by
[email protected]
My odometer works when I am traveling over 60mph and not below. I
replaced speed sensor on transmission and it didn't help. It is a big
problem because fuel gauge is also not working and I have to guess how
many miles I have driven and have run out of gas once! Trip odometer
even travels in...
|
|
0 |
3,276 |
|
|
Trivia questions - just for fun. by
Lhead
I'll post the answers soon.
1. What was the first American car company to produce an overhead cam
engine?
2. What was the second?
3. What American car holds the record for number of carburetors as
delivered from the factory?
( 1 2 3)
|
|
26 |
1,771 |
|
|
1998 GM Express Van by
oman
My van cools okay when going down the road, but does not cool at all
when at an idle. I've hooked up pressure gages and they read about 40
psi on the low side and 200 psi on the high at idle and at 2000 RPM
they read 30 psi and 230 psi. The outside temp is about 90F with about
50% humidity. I'm...
|
August 28th 06 01:12 AM
by oman
|
0 |
425 |
|
|
acura rl engine revs when stopping! by
r bewer
just wondering if anyone else has experienced this. when i'm coming to a
stop either at a red light or a parking space, the brake pedal seems to
get a little hard and the engine revs like i've got the accelerator to
the floor. it feels like it wants to take off! and all the time i have
my foot...
|
|
6 |
787 |
|
|
2001 Crown Victoria Fuel Pump by
John P.[_1_]
My 2001 Crown Victoria has hard morning starts(((hard start= cranking
for 10 seconds..letting go of the key and then engine starts, very hi
RPM in the "ON" postition)), but it starts fine for the rest of the
day. What could be the problem?! Already replaced, fuel filter, Air
idle control valve but...
|
|
4 |
951 |