|
|
2000 explorer oil leak... by
Hank
I have a 2000 Explorer, 4.0 push rod with 55000 miles and now have a
small engine oil leak. Die indicates it's coming from the engine
front cover (timing belt cover) area . It is a minute leak that's
undetectable in the dipstick. Has anyone out there in Explorer land
done this type of job...
|
|
1 |
553 |
|
|
|
|
2 |
1,611 |
|
|
NIGHTHAWK vs. SILVERSTAR by
Buford T. Justice
Has anyone tried the new GE NIGHTHAWK Headlights? Are they brighter and
better than Sylvania SilverStar Headlights?
http://www.ge.com/stories/en/20287.html?category=Product_Home
http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/HighPerformance/Silverstar/default.htm
( 1 2 3 ... Last Page)
|
April 22nd 05 07:32 PM
by y_p_w
|
35 |
1,949 |
|
|
B&S Engine Off-season Storage: drain gas tank or stabilize? by
Jim
Well the trees are turning green and the snow's finally gone, so that
means it's time to put the snowblower away. After I run it for a little
while to warm it up and then change the oil, should I keep running it to
drain the gas from the tank/carb, or should I keep gasoline in the tank
and rely on...
( 1 2)
|
|
10 |
683 |
|
|
diesel golf flywheel setting by
[email protected]
Hi
1995 VW Golf Diesel
Have installed the timing belt, but don't know where the mark to line
the flywheel is, or what setting.
Assuming the #1 piston is TDC, where do i find the markings on the
flywheel.
Plese help
|
|
1 |
469 |
|
|
Off topic, tractor pto shaft by
[email protected]
I have a small metal tubing shaft that goes to my dads tiller. The
female end is a little too short and when I get on uneven ground the
male shaft is on the very tip of the female shaft and breaks the female
shaft.
I cant find the female tuning anywhere as it seems to be an odd size.
Is it...
|
April 22nd 05 09:59 AM
by Huw
|
9 |
585 |
|
|
BHG 7mge won't start after replaced by
[email protected]
Hi you all,
had a BHG on my cressida 7MGE lately, replaced the gaskets and new ARP
head bolts and most of the hoses, after all the things are done, the
engine will not start only cranks.
went thru all the wires, hoses, sensors, all connected and OK, but just
won't start.
the compression seems a...
|
|
0 |
421 |
|
|
flywheel seeting for diesel golf 95 by
brown
Hi
1995 VW Golf Diesel
Have installed the timing belt, but don't know where the mark to line
the flywheel is, or what setting.
Assuming the #1 piston is TDC, where do i find the markings on the
flywheel.
Plese help
|
April 22nd 05 12:53 AM
by brown
|
0 |
386 |
|
|
91 caprice by
shawn macdonald via CarKB.com
i have a question about my 305 distributor....i'm going to replace the
ignition module and pickup coil cause it won't start..lol...actually, it
worked great then one morning wouldn't go....there is fire from the coil
but not from the wires after the distributor...i'm hoping this will fix it
but i...
|
|
4 |
255 |
|
|
what's the idle speed of a small block Chevy? by
Nate Nagel
subject says all... also what is the size of the crank pulley that
drives the alternator? I have a 12SI alt. on my '55 Stude and it seems
to be marginal at idle (spec is 550 RPM in neutral) Trying to figure
out if I have an alternator problem or just need a bigger pulley.
thanks,
nate
--
|
|
9 |
789 |
|
|
86 Grand Am clutch/starter question by
[email protected]
1986 Pontiac Grand Am, maual, 5-speed.
This model has a safety mechanism where you normally have to engage
the clutch or the starter won't crank. If you mash the clutch down
only 1/2 or 2/3 way, the engine wouldn't crank; you had to press it
almost to the floor, but not quite.. And for years this...
|
|
3 |
431 |
|
|
Colors of speaker wires in 85 Cutlass by
[email protected]
Can anyone help me with a speaker wire dilemma. I have an 85 olds
cutlass supreme. Just bought some new rear speakers, but the existing
wires in the car a
yellow and black on drivers side
and
dark blue and light blue on the pass side
So the question is: which wire on each side is positive and...
|
|
0 |
341 |
|
|
CNG conversion by
Not Me
Played with the numbers and I can save big $$ using CNG.
I have a 04 Caravan (3.8L) and need a source of hardware to convert to duel
fuel (gas/CNG and perhaps optioinal LP).
Any input would be appreciated.
|
April 21st 05 09:57 PM
by Martik
|
1 |
1,283 |
|
|
Another question, stiffness and noise in power steering. by
Rob
My 2000 Malibu has stiffness in the steering and also a noise when
turning. It's not really a squealing noise, it's more like the noise
you get when wiping a window...if that makes any sense.
I have noticed stiffness in the steering for over a year now. It hasn't
really gotten anyworse. I'm...
|
April 21st 05 07:31 PM
by Rob
|
0 |
806 |
|
|
Can this really happen? by
wllmprstn
I own a Ford Super Duty 7.3 deisel it runs great
lots of power but somehow I am getting deisel fuel
in my coolant, I have already had the head gaskets
replaced and the heads are not cracked. What could the problem be?????
|
|
5 |
408 |
|
|
what bends when wheels go out of alignment? by
Ted Johnson
Let's say your car is in perfect alignment, and then your wife
drives it for a few years and:
o hits a few potholes, and
o pulls in too far and hits the front tires against the
cement block at the end of the parking stall
Now the car is out of alignment (pulls to one side a bit
at freeway speeds).
|
|
5 |
296 |
|
|
Ford Festiva no power by
rush
Greetings,
I've got a '92 Festiva, with fuel injection auto trans, that has no power
going up hills. It acts like it's "dogging out". It's ok on level ground,
but when you take off, or go uphill, it loses all power. It's better at
higher RPM's The former owner took off the cat to see if that was...
|
|
2 |
518 |
|
|
Chrysler mini va cross reference by
Raymond J. Henry
I have a 1986 Plymouth Voyageur that is in need of a trans. It's got a
4-cyl auto. The damn thing doesn';t have enough power to get out of
it's own way. I'm thinking I'd like to find a donor vehicle with a 2.2
turbo or the likes, and drop the whole works in.
Can anyone out there tell me what I...
|
|
4 |
348 |
|
|
Attaching tail light by
Martik
1980 Tbird tail light just fits into place w/o any clips. What should I use
to 'glue' it to the trim? There was some black putty like material all
around but it is too loose for my liking.
Thanks
|
|
1 |
178 |
|
|
antifreeze leak- 95 corsica 2.2 by
legshaper
my corsica is dripping (gushing might describe this better...) antifreeze
as i type this, not from hoses, radiator, or heater core, but from the
front side of engine block, water pump maybe? i wouldn't be on the
computer if i knew. Any ideas?
|
|
3 |
682 |