|
|
Bearing replacement by
Brandon9
2001 crown vic working on rear wheel bearings
Finally I have some time to replace these bearings. i sat down today
after reading a bit on it and absorbing information from the guys at
checker.
According to all data i need to use a bearing puller to get them out,
however, checker has never heard...
|
|
2 |
375 |
|
|
|
June 19th 06 08:44 PM
by Shep
|
3 |
522 |
|
|
Buick Roadmaster Low Voltage at Fuel Pump Connector by
[email protected]
I have a 94 Buick Roadmaster with a 5.7 engine that has developed a
progressive starting problem. At first, it would fail to start, and a
few minutes later it would. Now, it cranks but will not start. Spark is
O.K., but no fuel pressure. Checking the voltage at the connector to
the tank, I...
|
June 19th 06 08:43 PM
by Shep
|
3 |
671 |
|
|
Fuel Pump Location (srt) by
[email protected]
on a dodge '05 stratus automatic, 4-door sedan, w/2.4L engine?
and what should be the average mpg in the city?
>mho
>v fe
>drive 10% less, fill up when half-empty at
>the lowest major station (help create a glut)
|
|
5 |
379 |
|
|
Removing the ECM and Running Without by
[email protected]
I need to know if it possible to remove an ECM from a 1983 Camaro Z28
with a 305. I would like to get rid of many of the smog controls, put a
new intake manifold, carburetor and an ignition that will operate
without the ECM. Is this possible without any major problems? I don't
plan on having this...
|
|
1 |
530 |
|
|
96 Kia Sephia transmission problem? by
E.T.
For the past week my 96 Kia sephia (yes the famous lemon model) has
been having odd behavior problems. Everytime I make a full right
turn..........the engine sputters and usually dies out. I usually then
have to quickly put it in neutral and then start it up again. The thing
is.....it only did it...
|
June 19th 06 02:36 AM
by E.T.
|
0 |
227 |
|
|
Four post car lift by
dswanson
Gary,
Disi you ever find out any info on you lift? I just (yesterday) purchased
a Lincoln Model 7015 also. It needs cables at least.
|
|
0 |
678 |
|
|
Totoya Corolla S mirror by
Dennis
How do you remove the outside mirror? Does the inside (plastic ) cover pop
off or do I have to remove the whole inside door panel? Thanks.
|
June 18th 06 06:38 PM
by Don
|
2 |
247 |
|
|
94 Concorde (Intrepid) Defroster stuck on HIGH & HOT ! by
Kraig Whiting
My climate control system on 1994 Plymouth Concorde is possessed. At times,
for no reason that I can figure out, all the lights on the climate control
console go out, the fan goes into High mode with full heat. You can't turn
it off no matter what you do. But give it time, sometimes a few...
|
|
4 |
417 |
|
|
A/C Clutch Question by
bruce
The compressor on my '00 Voyager 2.4 siezed, and the clutch melted
down, so I've ordered a replacement compressor. The car uses a 10PA17C
compressor with a 6 groove belt. It's effectively the same compressor
as what's on my ''95 Eagle vision except with a different pulley on the
clutch. My issue...
|
June 18th 06 04:58 PM
by
|
5 |
763 |
|
|
86 nova carburetor by
revsharkie
I'm new to this group. Saw a message from a couple months ago asking
for help with a carburetor problem with an 86 nova--sounded just like
the problem we're having here. I'm wondering if the person with the
original problem (name on the post was "silver5liter") was able to
resolve it and if so,...
|
|
4 |
634 |
|
|
Ez-pc 500 by
Ponti
Hi everyone,
I'm from the Netherlands and need some help of some good men from a
cross the sea. Maybe some one has the program autoxray ez-pc 500 that I
can download from him or her through (msn)!
I can give some upgrade code that I receved from the support desk of
autoxray (don't know if they...
|
June 18th 06 03:13 PM
by Ponti
|
0 |
540 |
|
|
weird BMW taillight arrangement? by
Nate Nagel
just took a look at the lightson my landlady's newer BMW 3-series...
apparently her dashboard told her that one of her taillights was out...
well I pulled the lights out and here two of the taillight bulbs appear
to be P21/5W like you would expect, the other two are P21Ws! I guess
they are run in...
|
|
0 |
435 |
|
|
1997 escort by
Bob Jones
Working on my girlfriends car, just replaced the PVC valve tube because of a
vacuum leak that was causing rough idle. My temp tape fix worked for a
while but finally wasn't doing the job anymore hence the permanent fix.
After the replacement she's still idling really bad. Press on the gas...
|
June 18th 06 12:46 PM
by Kevin
|
1 |
203 |
|
|
John Deere Blade clutch not engaging by
[email protected]
I have a 10 year old john deere sx38 lawn tractor. Over the last year
intermittantly the blade clutch has become disengaged suddenly while
cutting the lawn. When I try to reengage the blade nothing happens. The
engine keeps running it is just the blade that becomes disengaged. Then
it suddenly...
|
|
3 |
418 |
|
|
Spark Plug Wire Length GM Small Block by
[email protected]
I have a 305 engine in a 1983 Camaro. I purchased the car and the plug
wires were not attached to the plugs or distributer. Does the length of
each wire matter, or can I use the longest wire for 1 and 2 cylinder
and etc... I am not sure what to do.
Thanks
|
|
4 |
411 |
|
|
'89 Tempo/Topaz Fan Control Module Q by
[email protected]
Have an A/C-equipped '89 Tempo/Topaz with an inoperative radiator fan.
I jumpered the fan to the battery, it works. I jumpered the relay on
the drivers side headlight, it clicks and my multimeter says it has
continuity when energized. I also tested the coolant temp sensor near
the thermostat and it...
|
|
5 |
642 |
|
|
1991 Chevy Lumina that stalls by
Jenn
Hello guys...I'm hoping someone can help me with this horrific problem
that I'm having. I own a 1991 Chevy Lumina 3.1L V6 car. It has over
135,000 miles on it. There are a lot of parts that are new from Auto
Zone within the past few years on it, alternator, boots, etc. I've been
having this one...
|
June 17th 06 11:26 PM
by JM
|
9 |
595 |
|
|
Lexus transponder programming by
[email protected]
Does anyone know the procedure for programming the master key and valet
key on a 2001 Lexus LS430 . I have had no luck with the various
procedures I've tried any help would be appreciated.
Big Jan
|
|
0 |
378 |
|
|
|
June 17th 06 10:50 PM
by *
|
2 |
642 |