Can anyone provide instuctions for programming the key fob for my 1997 Explorer. I replaced the batteries in the key fob that hasn't worked for a while. The doors do not open. I remember something about turning the key in the ignition on and off five times but don't remember all the details. Is it...

I am about to replace the radius arm bushings for the second time on my '91. At about 91,000 I used NAPA poly bushings, and they are needing replacement at about 140,000. Any experience with the replacement rubber bushings vs Ford OEM bushings? And I also remember reading something about using...

From: Richard 1999 XLS V6 automatic. When I put the truck in park yesterday the shift indicator did not go all the way to park (P). It still shifts fine but the indicator is one position off when in PARK= R on indicator, when in REVERSE = N on indicator, and etc. Is this something that can...

I was thinking of adding a hitch to a 95 XLT. Any idea what something like this might cost? I'm only looking to use it for a bike rack, or cooler rack, so I really won't be needing the light wires, just the hardware hitch piece. Any idea?

I bought a ford explorer wrecked, light damaga, to fix. I am ready to put the valance on, and the fog lamps. It has wires coming off the wiring harness for the fog lamps but the fog lamps I ordered didn't come with any other wires. What do i need to do to get the lights on. Thanks, Suzi

i have a problem with my 95 eddie explorer.when i come to a stop light my truck acts like it wants to die but when i turn the fan on full blast it seems idle a little smoother.can someone help me with this problem. thank you harvickcrew --

OK, here is my problem. I'm an idiot and accidentally drove my '97 AWD V8 XLT (which was in great condition) into 2 feet of water and got stuck. No, I didn't know it was 2 feet, and no I should not have driven into it not knowing how deep it was. With that out of the way, here is my problem...

can anyone tell me how to remove and replace this switch on the steering columb?

Before I call Ford I just wanted to know if the spare tire cable was ever actually recalled and if I should expect them to replace it for free or not. The only posts I found on the subject were from 2000 and were not conclusive. Thanks.

1996 Explorer XLT 5.0 AWD In the past 6 months or so it's been difficult to unlock all the doors from the inside using the unlock button on the driver's side door. I have to rock the switch between lock/unlock several times before the doors will finally unlock. Any ideas what could be wrong and...

My 99 Limited is an awesome vehichle except for the ride .... I have fairly new tires (less than 10k on them) $400 worth of new shocks that didn't improve anything Any suggestions??? Dale

No I didn't do the soldering. My eyes aren't what they used to be, much less the steadiness in my hands. I did the Save My Sanity swap at www.shareamemory.com/radio and got the board which included very detailed pictures of the procedure and concise instructions on how to fix the problem. You'll...

Can you add a built in car seat to 1997 explorer?

Where is the receiver located in the vehicle?

Hello; I have a '98 Explorer Sport V6 4.0L SOHC 2WD. When the car is started up a noise can be heard for about 4-5 seconds. It sound like something is getting scratched. During the day the noise starts fading after the car has been ran for about half an hour and it is started again. After the...

Hello. Last week my 96 Explorer began making a noise as I went to work. I wasn't sure what it was, so I left it with a nearby Goodyear shop to check it out. They said my water pump was about to fail...the bearings were shot. I let them replace it and the noise went away. However, now whenever I...

What are the best shocks for a 1999 explorer w/ 75k, used 99% on the road?

:?: This is starting to get to me. Calls out HEGO sensor, I replaced as old ha some bad wires. Cleared codes and it comes back after about a 5 mile drive. Cleaned MAF with no help. -- Posted using the http://www.autoforumz.com interface, at author's request Articles individually checked for...

V-6 I have a good torque wrench and was thinking about changing my own spark plugs. Rear on the passenger side looks difficult. Is this a diy job?

I have recently bought a 2002 ford explorer 4x4.It came with a class 2 hitch that seems to be part of the bumper.It has bumper stops on it and its shaped the same as the bumper.what i need help with here is how can i get a class 3 hitch to put on it and is it possible.i installed many of these...