A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Ford Explorer Forum Tools Search this Forum Feed Icon
  Thread Reverse Sort Order / Thread Starter Last Post Replies Views
1997 Explorer Control Trac Problem by Pops54
The 4 wheel, 4 wheel low lights are blinking 6 times every 2 minutes. The front axle is engaging on turns. This problem resurfaced after 6 months. I had posted here about it, the problem stopped after I cleaned the brake dust from the front wheels. That did not work this time! Question, how many...
January 16th 06 02:22 AM
by Pops54 Go to last post
4 427
1997 Explorer Idling, and serp. belt by Shaggz
Hi this is my first post. I have a 1997 Ford Explorer.4wd. It has been running really rough. 4 liter 6 Cylinder.4wd. I am expecting an IAC Valve issue. I was think that the belt might also be causing the problem. I purchased a belt from a store, and with cursing and swearing. I got it on right.
December 31st 07 07:53 PM
by Ulysses[_2_] Go to last post
1 250
1997 4.0L won't idle by Stan
I have a 1997 Explorer 4.0L it will start and stay running as long as there is pressure on the accelerator pedal. I just drove it down the road, it runs fine but will die if I take my foot off of the pedal. This just started today. Any Ideas what the problem is? Thanks Stan
September 25th 07 07:32 PM
by Ulysses[_2_] Go to last post
3 369
1997 Eddie Bauer power antenna by [email protected]
Power antenna just went on my truck..Is it easy to replace it? I found someone on ebay who is selling them..Any help? Thanks
May 2nd 05 03:12 PM
by Al Williams Go to last post
3 783
1997 Explorer (4 liter pushrod engine) No Start, O2 Sensor codes,Intermittent engine Power loss by AS
I recently helped a friend of mine with the following problem: His check engine light would come on and the codes read would be related to the O2 sensors. He complained about the car having intermittent power loss but would not describe it as a miss. Last week the car finally died. The...
May 12th 07 11:21 PM
by AS Go to last post
0 723
1997 explorer 4 door drivers door by Richard[_12_]
My 1997 Explorer was hit and run on the drivers door, it is a 4 door can anyone tell me what year doors will fit? For the record it is power window and lock, no keyless entry. By the way the incident was witnessed and the Hit and Run a'hole was arrested for hit and run and DUII within an hour but...
December 10th 07 08:26 PM
by Richard[_12_] Go to last post
4 237
1997 Explorer 8 cyl Starter or Solenoid by [email protected]
My Explorer will start fine most of the time but other times it just clicks once when i turn the ley. I can retry and it starts fine. Today it just clicked and it had to retry it 10 times before it started. Im guessing the starter solenoid is bad. Question, is the solenoid replacable or do I...
September 11th 07 07:00 PM
by Ulysses[_2_] Go to last post
1 225
1997 Explorer center brake light not working by Larry
To all, The center brake light is not working on my 97 explorer. The price for a new one is $250. This is an LED unit so it shouldn't have burned out. Besides being expensive I have to drill out some rivets to remove it. Any other known issues besides the light itself. ....Larry
July 14th 05 05:19 PM
by Fred 2 Go to last post
2 778
1997 Explorer Code Problem (P1780) by jerry
I just got a error code message of P1780, which tells me the problem is the transmission control switch is out of range. Can anyone tell me what I need to do to fix this issus, and explain what this error code really means? Thanks.. Jerry
January 10th 06 03:15 AM
by Jim Warman Go to last post
1 795
1997 Explorer Key Fob Program by Ron
Can anyone provide instuctions for programming the key fob for my 1997 Explorer. I replaced the batteries in the key fob that hasn't worked for a while. The doors do not open. I remember something about turning the key in the ignition on and off five times but don't remember all the details. Is it...
April 13th 05 07:20 PM
by DearDeva Go to last post
2 605
1997 explorer outside mirrors by norm
I was thinking about purchasing a set of aftermarket outside heated mirrors for my 97 explorer and was wondering if the factory had already put the wires to connect the heater in the space where the original power mirrors are located. Also, I have a broken seat latch, the one that tilts the...
August 22nd 05 03:28 PM
by Gerald Riggs Go to last post
1 322
1997 Explorer P0171 and 174 trouble codes by Larry
To all, Any ideas? These indicate "lean fuel air mixture bank 1" and P0 174 is the same for bank 2. It drives fine. I noticed this happens after I drive about a mile then shut it off and go to McDonalds, then continue on. If I just leave home and head a couple of miles to the freeway then...
October 11th 05 01:18 PM
by Bigusdickus Go to last post
5 693
1997 Explorer P1121 and P0122 AND powere steering issue by Chevrolet[_2_]
Says that code 1121 is : Throttle Position Sensor Inconsistent with Mass Air Flow Sensor code 0122is :Throttle Position Sensor circuit Low Input wel I changed the TPS with a used one and it still does the same thing. I erased the codes by disconnecting the live to the battery but no go.. Anyone...
May 13th 07 12:53 AM
by Chevrolet[_2_] Go to last post
0 323
1997 Explorer P171 and P174 codes Thanks for help by Larry
A couple of months ago I posted that I was getting P171 and 174 lean on bank 1 and 2 fault codes. Some of you suggested cleaning or replacing the MAF sensor if nothing else obvious was wrong. Cleaning it using CRC Lectramotive cleaner did the trick. Runs fine and codes are gone. Thanks all for...
December 30th 05 06:02 PM
by Larry Go to last post
0 254
1997 Explorer Sport by ricks2311
I saw several posts regarding the best years of Explorers. I personally own a 1997 and just recently purchased a 2001 used Explorer vehcile. My 1997 Explorer (Purchased Used) has 154,000 miles and all I did was replace the fluids (Oil, Trans, etc) no other problems so far and still have it. I...
April 7th 05 04:23 PM
by ricks2311 Go to last post
0 1,318
Question
1997 Explorer steering tight by Stewart Hill
I have my dad's 1997 Explorer and have fixed a few things, brakes etc, but it has really stiff steering. The rack and ps pump were replaced last year. The front drive shafts turn full time. The steering seems stiff from that. I'm used to my 94 Explorer with auto locking hubs. I can't find...
January 3rd 07 02:06 AM
by Stewart Hill Go to last post
0 658
1997 Explorer XLT SOHC - Trailer Adapter Wiring by Bones[_2_]
Hello all. I need to replace the trailer wiring harness that runs from the right rear bumper connector to the center of the rear bumper. The 4-wire flat connector has finally corroded. I guess I could just cut it off and splice a new flat-4, but I don't want to deal with shrink/heat wrap,...
October 10th 07 03:42 AM
by Darby OGill Go to last post
1 264
1997 for explorer power steering pulsates when turning wheel by Rand
Wheels turns freely with motor off and weight off front suspension. With the motor running the front suspension and wheels pulsate when turned either direction. All tires are just balanced and rotated. The pulsating did not occurr before, but dosen't matter whether it's moving or up on the hoist....
October 7th 12 08:08 PM
by Rand Go to last post
0 2,446
1997 Ford Expler XLT, Control Track 4x4 *Transfer Case Problums by 1963GalaxieXL500
*Shudder or binding senation-in tight turns while vehicle is in 4x4 auto mode. I have change Transfer Case oil, Oil was was burnt but was not old, Then the problum went away but has returned after 2 weeks. IF any one know how to fix this problum PLEASE Email me at
October 15th 05 02:23 AM
by 1963GalaxieXL500 Go to last post
0 858
1997 ford explore fuel filter by moonboysd
how on earth do you remove the fuel filter can't seem to unscrew or pull the lines off of it.
August 19th 05 01:32 PM
by [email protected] Go to last post
2 1,230
Post New Thread


Display Options
Showing threads 281 to 300 of 3084
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:49 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.