|
|
Inaccurate wheel balancing - has any1 here experienced this ? by
MasterBlaster
"Juhan Leemet" wrote
> > I can't imagine a modern tire, particularly the newer lower profiles changing
> > diameter at high speed enough to affect the balance of the tire/wheel assembly.
>
> I recall seeing some film showing the changes in shape of a tire at speed.
> The outer surface of the tire...
|
|
0 |
2,120 |
|
|
|
|
0 |
2,609 |
|
|
Is this an alignment problem? by
E. Meyer
On 11/11/04 9:47 PM, in article
, "Peter R"
> wrote:
> Hi,
>
> My vehicle hit the curb pretty hard last week. It was towed to a
> garage and have the axle, CV boot and rim replaced and alignment done.
> Paid $$$$.
>
|
|
0 |
2,468 |
|
|
change my distributor cap and rotor by
Burt Squareman
"www.mo-de.net" > wrote
> I am going to attempt to change my distributor cap and rotor. I know if
> I don't do this correctly the car will not start. Any tips to ensure it
> does start and thing(s) I should look out for?
> The car is a; BMW 318i 1984 4 cylinders 1.8 liter...
|
|
1 |
2,400 |
|
|
radiator temp fix by
Mike Behnke
Gawd;
Glickman admitting his suggestions are not always right! Pa Shaw!!!!
Lawrence Glickman wrote:
> On Tue, 07 Dec 2004 08:21:00 -0600, Mike Behnke >
> wrote:
>
>
|
|
0 |
2,002 |
|
|
F250 Diesel start problem .. Dealer no help by
[email protected]
Looking for some help with an intermittent hot starting problem on a
2001 F250 SD PSD. The V8 turbo diesel.
Truck starts fine the first time in the morning, but intermittently
does not start if shut down after about 30 minutes.
Engine cranks rapidly and fine -- would probably turn the engine...
|
|
0 |
2,385 |
|
|
Haynes manual instructions by
ray
Neil Nelson wrote:
> In article <Dgvtd.456741$nl.6891@pd7tw3no>, Ray >
> wrote:
>
>
>>Can latex gloves hold up to wrenching? I wore latex gloves while
>>painting my race car this summer and they didn't hold up very well just
>>swinging a spray gun. I can't imagine them lasting more...
|
December 8th 04 05:52 PM
by ray
|
0 |
2,061 |
|
|
Haynes manual instructions by
Matthew Russotto
In article >,
Arif Khokar > wrote:
>Neil Nelson wrote:
>
>> I've tried latex gloves, usually within 10 minutes, there is
>> sweat pouring out of them...
>
>That hasn't been my experience even being in the operating room for over
>3 hours.
|
December 8th 04 06:00 PM
by ray
|
1 |
1,969 |
|
|
Rear illumination pattern for '85 Celebrity by
Christopher DiStefano
Hi. I would like to know the rear illumination pattern for a 1985 Chevrolet Celebrity. The specific model has a horizontal divider splitting the lenses, resulting in a total of 12 lenses in the taillight assembly.
I need to know the illumination pattern for all four configurations: Headlights on...
|
|
0 |
2,364 |
|
|
2000 Buick Regal CD changer socket?! by
Bill Bradford
Love my 2000 Regal - never had any problems but I'm a bit puzzled right now.
I've just bought a Neo iOn Ipod connector and the manual says my car is
meant to have a socket for it to connect to in the trunk!!
I cannot see one. I'm guessing it's meant to be an 'optional' CD changer
connection but...
|
|
0 |
2,340 |
|
|
Doughnut spare tire? by
Paul Hovnanian P.E.
Jake wrote:
>
> My auto has a doughnut spare tire.
>
> what is the speed I should use when this doughnut is installed .
> is there a limit on the main highways..
>
> like if i have a tractor trailer barrelling on my tail, when the
> doughnut is in use.
>
|
|
0 |
2,116 |
|
|
Do you need car help/support sometimes? by
Travis Roe
Come to
http://thecarscene.com/
we have
2003-2005 350Z Owners manuals
Nissan Z technical articles
Nissan S13-S15 SR20DET factory service manuals
Nissan Silvia S13-S15 technical articles
Lancer evolution technical section
|
|
0 |
2,489 |
|
|
Cold starting problem - '89 CRX Si by
James Masologites
I have a 1989 CRX Si with MPFI. When warm, it starts up in one crank and
catches strongly, no problem. However, when its sat for a while and
become cold, it takes a good 3 or 4 seconds of cranking for the engine
to catch, and even then, it kind of "burbles" to life (doesn't catch
crisply).
Another...
|
|
2 |
2,322 |
|
|
|
|
0 |
2,393 |
|
|
98 Grand Marquis Stalls (Bad EGR???) by
Finite Guy
Hi All: I seem to rcall that when I bought my 98 Grand Marquis some
years back, someone on this news group advised me to
(1) Change the transmission fluid often)
(2) Be sure the EGR Valve is clean because it carbons up.
My car is strating to stall at idle speed. Just wondering if the EGR
could be...
|
|
0 |
2,078 |
|
|
95 s10 blazer freeze plug by
Sportster4Eva
Bill wrote:
> I have had success with a screw in slide hammer/dent puller. (Take the
> radiator out, drill a small hole to accept the hammer screw and whack away)
> You could also drill a hole big enough for a pry bar. Whatever you do, don't
> knock it inward. Fishing for a loose freeze plug...
|
December 9th 04 04:05 PM
by ed
|
6 |
2,296 |
|
|
ceramic power liquid by
Vojinovic Milos
Has someone used ceramic power liquid and what do you think about it.
Thank you.
Regards
|
December 9th 04 04:20 PM
by ed
|
4 |
2,200 |
|
|
|
|
0 |
2,028 |
|
|
Brake booster question by
Henry H. Hansteen
My 2001 Ranger has had a long, soft pedal and weak brakes for quite
a while. The dealer replaced the shoes, pads, master cylinder, and
the ABS unit. Four dealer visits later, the brakes still suck.
Now they want to replace the booster. I don't see how a bad booster
could cause long pedal travel,...
|
|
1 |
2,045 |
|
|
might need new alternator by
Lawrence Glickman
On Wed, 08 Dec 2004 07:35:05 GMT, wrote:
>Lawrence Glickman > wrote:
>
> > driving with your brake lights constantly on is not overly important.
> > It is better to keep the cars behind you guessing whether you are
> > stopping and slowing...
|
|
7 |
1,903 |