A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Views Reverse Sort Order
ID'ing a bad Supercharger? by Mardon
Short Version: Is there an easy way for a driver to tell if a supercharger is not working properly? How likely is it that a supercharger problem would not be found by the dealer if one of their vehicles were brought back several times with a complaint of "loss of power"? Full Version: We have...
(Multi-page thread 1 2 3)
September 30th 06 10:16 PM
by Mardon Go to last post
21 1,047
Ecoboost torture and teardown by bob urz
http://news.pickuptrucks.com/2011/01/what-the-inside-of-a-torture-tested-ecoboost-v-6-looks-like.html bob
(Multi-page thread 1 2 3)
February 2nd 12 11:18 PM
by Brent[_4_] Go to last post
21 1,047
Convertible Roll over bars - windshield frame by Mr.X
On Mon, 16 Jan 2006 22:43:07 GMT, "Dennis" > wrote: >>>We had the same problem on our 04 Sebring. >>>Took it to the local dealer and he adjusted the top to fit down over the >>>drivers window a little tighter. >>>No leaks since. >>> >> >> Thanks for the response. Does anyone...
(Multi-page thread 1 2)
January 22nd 06 06:14 PM
by Nirodac Go to last post
13 1,046
Buy a used Honda Odyssey by P&L
I am considering buying a used odyssey. Any years (2001 and up) to avoid. What should I look for when buying one?
September 21st 05 05:12 AM
by « Paul » Go to last post
1 1,046
is $65/hr reasonable labor rate? (d) by [email protected]
I called a local independent mechanic and asked him how much labor he'd charge for working on the master brake cylinder and he told me it'd be $65 an hour. Is that a reasonable rate or is it too much? I don't really trust the auto repair franchises like Midas even though there are about 3 of...
December 20th 04 09:58 PM
by [email protected] Go to last post
8 1,046
worn bearing cause low oil pressure? by Don Stauffer
On 6/6/2010 11:23 PM, Nomen Nescio wrote: > I noticed low oil pressure when the revs are down. > So I get out the workshop manual, and it lists among the > possible causes "worn bearings". How is it so? > I can't see that oil is pumped through the bearings in > a closed fashion, such that worn...
(Multi-page thread 1 2 3)
June 11th 10 08:26 PM
by Steve W.[_6_] Go to last post
21 1,046
Honda versus Toyota by HLS
I have been thinking about trading out of my American iron, and going with something more economical. We have long discussed here how Toyota and Honda seem to have the edge on lower priced cars for economy, quality and dependability. But it seems to me that Honda has had its share of...
(Multi-page thread 1 2)
April 18th 05 05:14 PM
by Steve Go to last post
13 1,045
What does the FIPG mean in black liquid silicone gasket material by Zen
My oil pan apparently doesn't have a gasket because it uses FIPG black liquid silicone. What does FIPG mean?
(Multi-page thread 1 2 3)
January 19th 13 12:10 AM
by Nate Nagel[_2_] Go to last post
21 1,045
Electric fuel pump question by bige lewis
Hi all. I am getting a car ready for a demolition derby. Usually I run something older with a chevy 350, but due to time constraints I am stripping out a 89 mercury Grand Marquis with a 5.0. It runs and drives, so it won't take long to get ready. Anyway, I am having trouble figuring out the easiest...
August 1st 05 08:01 PM
by Steve W. Go to last post
2 1,045
avoiding cold starts by mac
First, are these assumptions correct? (1) Starting a car when the engine is cold puts alot more stress on it than when it's already warm. (2) And the colder it is, the more stress. Because i've always assumed the above, I do the following, but I want to verify whether it's really worth it and...
(Multi-page thread 1 2)
November 16th 06 04:19 PM
by mac Go to last post
13 1,044
best anti-RF ignition wiring TYPE by 63Avanti
best anti-RF ignition wiring TYPE background: I am getting my vintage AM/FM Delco reconditioned with the intent of getting that "cruis'n feeling" I will also add non-vintage sound deadening, and other electrical/static improvements noted here and elsewhere. Thanks for the help. My query in a...
(Multi-page thread 1 2)
November 1st 06 01:44 PM
by GregS Go to last post
16 1,044
Tempo/Topaz front motormount / swaybar help please by [email protected]
Greetings, I am doing my first '89 Tempo/Topaz motor mount replacement. It's the one under the battery/airbox on the drivers side. I have removed the rubber part, but cannot get a good grip on the three 13mm bolts that hold the top metal half to the automatic transmission. My tools are all either...
July 20th 06 04:48 AM
by Tom Adkins[_1_] Go to last post
1 1,044
2001 Jeep Grand Cherokee Limited AC fans not blowing by [email protected]
I've got a 2001 Jeep Grand Cherokee Limited 4.7L 8 CYL SOHC MPI 4 DR. WAGON/SPORT UTILITY. The AC seems to be working fine, but the fans aren't coming on so the cold air isn't blowing out. I had somebody work on the AC before and I think they messed up the wire harness that is below the dash...
June 1st 06 03:01 AM
by [email protected] Go to last post
0 1,044
Zero lash Cont. by Rojo2G
As recomended I TDC'd each cylinder(chey 6 cycl.) and tightened out the play on the pushrod, plus about 5/8 rev. on the nut. I rotated the engine by hand and rechecked the play. Most had play again so I repeated the tightening a second time. I spun the engine once more and still had to tighten a...
(Multi-page thread 1 2)
January 31st 05 02:59 PM
by Mike Romain Go to last post
12 1,044
Question: Can synchro-mesh be adjusted? by BD
Hey, all... I have an '02 Subaru WRX. Had it for about 2 1/2 years now, and it has 36,000km on it. Lately I've noticed that when I gear down from second to first, the synchro-mesh occasionally seems to let me into 1st before the rpms have synched up properly - it results in a bit of a thud, or...
(Multi-page thread 1 2)
October 4th 05 07:11 PM
by BD Go to last post
19 1,043
Spark plug lead is loose, car is sounding funny (see pic) by [email protected]
Hello all, Today i took my car to a mechanic to replace the engine mounts (Toyota Cressida 91). After picking up the car, i start noticing rough idle. I suspected the spark plugs based on previous experience. I checked the spark plug leads and i noticed that one is loose (please see the pic...
(Multi-page thread 1 2)
August 31st 05 01:52 PM
by Go to last post
11 1,043
Electric Rangers for sale by EVRanger
We have exciting news! Our company was able to save a number of Ford EV Rangers from being "disposed of". If you were one of the original users/lessees of these trucks, we know how hard it was to turn them in at the end of your lease. Now is your opportunity to put these trucks back into your...
(Multi-page thread 1 2)
October 21st 13 04:19 PM
by m6onz5a Go to last post
17 1,043
Just Curious..... by *
It is now against Federal law to point a laser at an airplane....... Why are cops still allowed to point lasers at motorists?????? Exposure to Microwave radiation (RADAR) has been shown to have a cumulative effect that can result in various cancers. There is evidence that a number of cops...
May 31st 05 03:18 AM
by nobody Go to last post
3 1,043
94 Caravan - fuel pump won't run by [email protected]
94 Caravan, 3.0L V6. The van has been sitting for a while, but started fine 2 weeks ago. A few days ago it cranked fine, but the fuel pump didn't do the normal 2-second pressure up when the key was first turned on. I can get the fuel pump to run if I jumper the fuel pump relay, so the relay, the...
December 17th 04 04:52 PM
by [email protected] Go to last post
0 1,043
Inspection and oil change by Arlen Holder[_5_]
On Sun, 21 Jun 2020 17:26:31 -0500, Jim Joyce wrote: >>Depends how many quarts and what kind of oil. I've heard of people >>spending that just for oil change. > > I wait for the $9.99 coupon to roll around. If I miss it, there's always a > $14.99 coupon available. Wow. That seems inexpensive...
June 22nd 20 08:15 PM
by Arlen Holder[_5_] Go to last post
5 1,043
Post New Thread


Display Options
Showing threads 2001 to 2020 of 16938
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 11:30 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.