When is Chrysler going to update their website with the 2006 models? -- Thanks, Mike

Had my 06 300C at the dealer as when the a/c is on the vents in back of the console for the rear passengers the air coming out of them is ambient. Not cold but same temp as outside. The dealer says this air is not controlled in that heat or a/c is not affected there. Does this make sense or is...

My talon sometimes quits when I back up particularly on a slope. It will start right up again and drives fine for the majority. It is an automatic transmission, 2.0 litre engine, no turbo. The problem is intermittent. The electrical on this car is also very touchy. I was told that it was the...

The headlights won't open,is there a fuse anywhere.or can you open them manually

My van was dead when I went to start it this morning so I hooked up the battery charger and Charged it for a few min(red + Black-), went to start it and it started, but now some of my stuff isnt working, that I have notices, Instrament panel (lights, mph, temp. gaige, fuel gaige, rpm, windshield...

Title says it all. Looking for a spot on the net to D/L the Hemi ads for the PC. Thanks

After having the time chain gasket changed on a 3.3L '95 Intrepid the engine is completely dead. Testing produced Code 11 below. 11 No ignition reference signal detected during cranking (bad Hall effect) OR timing belt skipped one or more teeth; OR loss of either camshaft or crankshaft position...

http://www.idpz.net/wolfgang/

Hi 2 u all, could anyone help - having had my 98 grand voyager 3.3lx for nearly two years i'm experiencing problems - the gears seem to change for no reason rather than the previous comfortable exchange - they change down for no reason and it seems she cant decide what gear to be in - at low speeds...

I have a 1993 Chyrsler Intrepid and the windsheild wipers just stopped working. No noises, sounds, or attempts to work when tried. I was advised to check the fuses. Where might I locate these fuses and are they hard / or expensive to replace. Can you think of any other reasons that the wipers...

Does anyone know anyone who can help me get a/c - heating vents for my 1991 (red) lebaron Convertiable

I just read where someone said that coolant was forced out of the overflow tub and that is a result of his blown head gasket. I've had that happen to me on a few occasions, not every time I drive the van. If it were a head gasket, wouldn't it overheat and wouldn't I'd see water in the oil...

engine dies when speed exceeds 55 mph any speed lower than that and it runs ok whats wrong?

I HAVE A 1990 LEBARON CONVERTIBLE AND THE HEADLIGHT DOORS DO NOT WORK, I AM NOT GETTING ANY POWER TO THE MOTOR. DOES MY CAR HAVE A MOTOR RELAY AND IF IT DOES WHERE IS IT?

I have a 1997 Jeep Cherokee (4.0L/6 cyl) that has a problem with a hesitation on acceleration first thing when I drive it in the morning and when the Jeep has been parked and then driven again within 1 - 4 hours of being parked. I've just replaced the spark plugs and the problem is still there. I...

Back in May, my Firestone dealer replaced the left lower ball joint. Have been noticing some squeaking that appears to be coming from the left front. When I looked it over, it appears that the boot on that balljoint is loose, there's a gap between the boot and balljoint. Question is, aren't the...

I have a 2000 cirrus that only blows cold air. any ideas on how to correct this problem.

My car is cirrus 95 stalling v6 2.5L. It always stalling when temp. getting warm and speed not very high. To restart it have to wait the engin temp cold down. It will shake when running on highway like loss power (this problem had been sloved after replacing a IAT sensor). The results of scan...

The Haynes manual makes it sound SOOOO easy...basically it says, remove the WW arms, the cover under them and the 3 bolts from the motor and it's out. But when you get to the wrecking yard to actually GET ONE? It's under 3 tons of linkage, nuts, bolts, wires and hoses!! Fortunatly, before I got...

Hey, I was driving my wife's 2003 t&c last night and I couldn't find the mirror controls in the dark. Could anyone tell me if it is supposed to be illuminated. If so I will have to find where the bulb is that has burnt out. Thanks in advance,