|
|
- DSCF4399.JPG (2/2) Spare Trans Part by
Jim Warman
Two, no, make that three suggestions.... Google "post pictures to
newsgroups".... You should find something that will work for you...
Second.... make sure that someone isn't going to **** on you for posting a
binary in a text only NG.
Third... throw the little plastic piece away.... Think...
|
|
2 |
333 |
|
|
Hood Release Lever Stuck, Can't Open Hood by
[email protected]
I just solved the problem of opening an inoperative hood release on my
1997 Explorer. I tried gripping the cable under the dash with locking
pliars and pulling as hard as I could but that didn't work. Try that
first. I then looked thru the grill at the latch. There is a sheet
metal cover blocking...
|
|
0 |
624 |
|
|
98EB A/C issue by
Al Williams
My 98 Explorer SOHC A/C stopped working late last summer and the dealer
indicated that the accumulator (drier) was seeping and had some rust issues
(blend door is OK). They recommended replacing it and the pressure cycling
switch but wanted over $500. I decided to wait till after winter and...
|
|
2 |
423 |
|
|
OBD P0420 - 1996 Ford Explorer, V6, 84k miles by
Mig
I have 1996 Ford Explorer, V6, 84k miles.
A month ago I replaced the thermostat because it was running cold. Then I replaced the air filter too. Two days later Check Engine light came on. The car is running well, the gas mileage improved from 19.5mi/gal to 21.4mi/gal.
The OBD code is P0420 (the...
|
May 15th 06 08:58 PM
by Mig
|
0 |
648 |
|
|
1994 ford explorer backup lights by
[email protected]
Hi,
I have a 1994 ford explorer 2 door sport. I recently noticed my backup
loghts are not working. I checked my fuses, and my actual light bulbs
and they all appeared OK. Is there a switch or something else that I
could have missed? a relay switch? I'm not sure, as I want to try and
avoid the...
|
|
0 |
331 |
|
|
re---Oil pressure alert/engine check light. by
Joe balls the ragman
your problem could be very serious. Worn engine and seals. No OIL pressure on startup. Overnight the engine oil drains down from the oilways into the sump. Worst is the timing chain tensioners are hydraulic (oil pressure needed). If this combines with a sticky idle control valve your engine will...
|
|
0 |
476 |
|
|
'98 Ford Explorer - Sluggish starting? by
top1percent
I've got a '98 Ford Explorer Sport with the 4L SOHC V6 engine.
Unfortunately, it's starting getting very sluggish when trying to
start. One time it took me several minutes and several tries to get it
to finally start. I don't believe it's the starter or the battery since
it will crank like a son of...
|
|
3 |
525 |
|
|
rear wire harness by
billc
I have a 1994 Ford Explorer Eddie Bauer edition. I recently put a tow
hitch on it. In the process I found tucked under the rear bumper a
wiring harness that lookes like it would be for a towing package (
lights, directional signals, etc.). It even as a plug on the end that
lookes like it should...
|
May 14th 06 07:18 PM
by Dave
|
2 |
260 |
|
|
- DSCF4399.JPG (0/2) Spare Trans Part by
I'm hoping somebody has seen this before. I was performing a 60K mile
service on my 2002 4.6L Expedition automatic transmission-fluid, filter
and gasket. The transmission is a 4R70W, which I believe is also used
with the Explorer 4.6L V8, which is why I'm posting to this group. When
I dropped the...
|
May 14th 06 03:54 PM
by
|
2 |
734 |
|
|
|
May 14th 06 01:47 PM
by
|
0 |
746 |
|
|
|
|
0 |
226 |
|
|
Group 1 Ford Dealership Complaints by
[email protected]
Hello All-
I am launching a complaint website focusing on the Group 1 Automotive,
Inc. dealerships. The site is not launching for a few weeks so you
won't be able to post live on the forum yet. That said, I would love
to include your experiences with Group 1 dealerships on the site before
the...
|
|
0 |
461 |
|
|
Shock Replacement on '97 EB by
Stephen M. Gluck
I brought my '97 EB in for service and they found that the shocks were
worn and leaking 61K on truck and original shocks. The offerred to
replace them with KYB Gas Pressure shocks. Has anybody heard of these
shcoks and if so how are they ? I also had the 4 X 4 service done .
First time at 60K...
|
|
1 |
256 |
|
|
1997 transmission question by
Stan
1997 auto. 4x4
Transmission pulls fine, but when going down hill the transmission will "rev
up" faster than the engine causing a whineeinf noise. I can give it more gas
and the engine will catch up with it. any ideas what is wrong?
Thanks
Stan
|
May 11th 06 06:43 PM
by Stan
|
0 |
296 |
|
|
|
|
4 |
312 |
|
|
Transfer case sensors by
JohanB
> wrote in message
...
>It's starting to shudder again when turning, as if it's in
> 4-high. .
Did a rear diff service and forgot to add friction modifier ?????
|
May 11th 06 02:15 AM
by JohanB
|
2 |
355 |
|
|
door adjustment by
Bob
I put new hinge pins and bushings on the driver's door of my '94 XL. The
door is nice and tight on the hinges now but doesn't latch quite right.
How do I adjust this? Adjust at the latch or latch pin or do I adjust
the hinge mounting bolts? Thanks.
|
May 10th 06 08:27 PM
by Bob
|
2 |
220 |
|
|
2004 Ford Explorer Key Pad by
loren311
Like many I have just purchased an 04 explorer and it didnt come with the
combo to the key pad. I have ready on many different sites ways to find it,
anyone actually know how to find it on the 04? Thanks in advance!
|
May 10th 06 02:24 AM
by Madmax
|
1 |
433 |
|
|
02 hitch and ball receiver by
WilM
I need to buy a ball receiver (draw bar) for my 02 Expolorer. The factory
hitch uses the smaller 1 1/4 inch receiver size. Does anyone have a
recommendation on a drop size? The guy at my local auto shop suggested that
a 2 1/2 inch drop was the right one. However, I don't trust his opinion
since...
|
May 10th 06 02:22 AM
by Madmax
|
7 |
1,047 |
|
|
92 explorer stolen, now wont start by
WendyLady
I just got my explorer back last night, it was relatively undamaged,
just some minor stuff, but it wont start, the steering column appears
to be intact, isnt loose at all, I can put a key in the ignition, when
I turn the key the battery and check engine light come on, but it will
not even attempt...
|
|
8 |
509 |