A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : 4x4 Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Reverse Sort Order Last Post Replies Views
cherokee 2002 hydraulic fan/power steering by chrisw
Hi there, anyone familiar with the fault that causes loss of power steering due to some kind of fault with the hyadraulic fan unit on the jeep cherokee? it appears that the valve assembly may be just redirecting pressure to the return rather than to the steering box, a schematic would be a great...
September 2nd 08 09:23 AM
by chrisw Go to last post
0 1,496
Winch Wiring by Chuck
I notice the power and ground quick connect kits sold by Warn and others for the 8 to 10 thousand pound winches are rated at 175 AMP and sized for #2 gauge power cable. I figure the connects are rated for continuous duty @175 but are these components,both the connectors and cable, really heavy...
July 12th 04 04:54 AM
by Roger Brown Go to last post
4 739
S-10 Blazer 4x4 transmission problem by Chuck Jurgens
I have a '96 S-10 Blazer 4x4 with 135K miles. It has been an excellent vehicle and I have had virtually no problems with it. However, yesterday I noticed a slip in the transmission; then after I stopped at an intersection the engine reved up to about 3000 RPM in first gear before it shifted into...
March 11th 04 11:47 AM
by David M. Moore Go to last post
4 1,065
Wiring for electric brakes (Blazer) by Chuck Jurgens
I have a '96 Blazer that I use to pull boats and utility trailers. I just acquired a trailer that has electric brakes and want to hook therm up. My current wiring connector is the standard flat 4 prong. The new trailer has a round 6 prong connector. When I initially spliced in the flat 4...
November 7th 05 05:06 AM
by Advocate Go to last post
6 613
power steering pump by Chuck474
I replaced the PSP on a chevy 3500. I still dont have power or power brakes. should I have primed this pump? Its full of fluid and turning fine. It has an electrical connection on the bottom, could I have pluged it in wrong? This PSP works with vacume, That about all I know bout...
July 27th 07 06:39 AM
by Chuck474 Go to last post
0 475
help with signal lights by chwolf
We have a 1987 Ford Bronco 2 4x4, with a/c,2.9 liter engine. We are having problems with the siganl and brake lights, the fusses keep blowing. One of the wire from the wire harsse was corrideed again hubby by-passed that wire we had siganl and brakes lights for awhile. Now er just keep blowing...
January 7th 06 09:35 AM
by chwolf Go to last post
2 471
Check out my stepsons JEEP by [email protected]
http://www.cardomain.com/ride/2143270
April 21st 06 01:09 PM
by SnoMan Go to last post
1 668
Check out my stepsons JEEP by [email protected]
http://www.cardomain.com/ride/2143270
April 22nd 06 03:48 AM
by Clueless in Sterling Go to last post
1 685
FAST MONEY!$!$ THOUGHT IT WAS A SCAM BUT HOLY CRAP THIS REALLY WORKS!!! by citymouse
SO YOU NEED MONEY... AND NEED IT NOW!! THIS IS THE FASTEST... AND FAIREST... WAY I KNOW TO SHARE THE WEALTH! Would you like to make thousands of dollars quickly, legally, and with NO CATCH? ***PRINT THIS ARTICLE NOW***
February 17th 05 12:13 PM
by citymouse Go to last post
0 443
save so much time by CJ
COPY AND PASTE THE LINK BELOW - THIS REALLY HELPED ME OUT WITH BOLTS AND WASHERS AND PARTS THAT LOOKED ALIKE. EVEN THOUGH I HAVE THE MANUAL, THIS PRODUCT SAVED ME TIME, ITS PRETTY COOL!! I WAS GOING TO JUST MAKE TABS MYSELF BUT FOR 99CENTS OR EVEN TWO BUCKS, I THOUGHT WHY TAKE THE TIME PLUS THEY...
May 18th 05 02:06 AM
by el Diablo Go to last post
1 1,105
cj8 lift update and another question by [email protected]
2 1/2" lift kit. Got all the parts. Appreciate all the helpful advice. Been soaking all the nuts and bolts daily for about a week with pbblaster to work on any rust. And so far, so good. Have dropped the rear springs with no real problems.
June 24th 04 04:29 PM
by Roger Brown Go to last post
2 818
cj8 lift? by [email protected]
After posting some messages and soliciting advice to try and learn about the pros/cons, about what to do to fix/or replace the aged springs on my 82 cj8 I decided to try a mild lift kit. Mild nothing wild -- just 2 1/2". With luck it will arrive this week and I can go after the job...
(Multi-page thread 1 2)
June 19th 04 03:56 AM
by [email protected] Go to last post
14 1,118
blazer 4x4 problem by cjkeenan
Hi my 97 blazer seems to be stuck in 4hi. I press the button to swtich to 2 hi and i can hear clicking like its trying to do something, but nothing happens. Any ideas? Thanks
December 11th 05 03:10 AM
by tango2 Go to last post
1 342
2000 GMC Jimmy - 4 Wheel Low tries to turn on while driving by [email protected]
Sometimes when I normally drive my Jimmy, the 4 wheel low light flashes. If I continue driving, it'll turn off in a minute or so. If I am not paying attention and it is flashing when I park, the truck will change into 4 Low and I will need to get out of it before I can drive again. Does anyone...
December 2nd 06 07:17 PM
by SnoMan Go to last post
1 359
Opinions wanted Landcruiser vs. 4runner by clangq
I'm planning to buy a used SUV in the very near future. I'd narrowed it down to an early 90's 4runner. When looking around, though, I noticed one or 2 1990 Landcruisers in the same price range. Looking for some experienced opinions on which would better suit my needs. This rig will be used as a...
(Multi-page thread 1 2 3)
July 6th 04 03:47 AM
by Chris Phillipo Go to last post
25 2,517
front hub drive flange sizes. by clare at snyder dot ontario dot canada
What are the standard 4X4 front drive hub flange bolt patterns? Anyone have a list of what bolt circle is used on what vehicles? Looking for something to fit 6 on 2 3/8" -- Posted via a free Usenet account from http://www.teranews.com
March 27th 08 12:06 AM
by clare at snyder dot ontario dot canada Go to last post
0 717
Engine Swaps vs Smog Laws by claudel
Hi What's the story on various US state smog law and swapped in engines. I see that folks swap different engines into different 4x4s and I'm curious how that works out regarding smog laws. I'm mainly concerned with how one can legally drive such a vehicle on the street. Obviously it is possible...
January 23rd 05 01:34 AM
by Jerry Bransford Go to last post
2 957
Parts for SsangYong Korando Jeep by Claudio Bogado Pompa
Hello. Do you know where in the world I can find parts for a 1991 SsangYong Korando Jeep. Greetings from Paraguay. Claudio Bogado Pompa.
September 3rd 04 04:35 PM
by Claudio Bogado Pompa Go to last post
0 1,026
Trac-Loc clunking? by Clay B Carley
I recently picked up an '87 Jeep Grand Wagoneer, which is completley stock at the moment, with the tow package & lsd rear. It's getting new springs & shocks shortly :) Anyway, the LSD in the rear D44 is clunking from time to time. The Ring & Pinion are fine; they don't make any wierd noises,...
January 12th 07 05:00 PM
by Clay B Carley Go to last post
9 889
Usenet Abuse: Someone at IP address 63.188.107.84 is impersonatingme and posting nonsense by Clay B Carley
Like I really enjoy seeing this kind of stuff when I see there's a new post in rec.autos.4x4. Perhaps learn to filter. Somehow, nobody is impersonating me. Make anyone mad with some random post somewhere buddy? Now the rest of us are wondering when your posts will go away.
September 6th 07 03:08 PM
by Clay B Carley Go to last post
0 814
Post New Thread


Display Options
Showing threads 461 to 480 of 2914
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 12:27 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.