|
|
98 explorer reverse issue by
[email protected]
I have a 98 explorer 4.0 XLT.with 133,000 miles . On cold morning
startups, When shifting into reverse theres a 2-4 sec delay in it
catching reverse gear. I've checked the fluid level and its fine. When
Its warm out or after driving it shifts with no delay. All forward
shifts are fine. Any...
|
|
0 |
365 |
|
|
Replacing Power Steering Pump on '92 by
Ulysses
Hi.
My power steering pump is leaking and sounding kinda noisy so I'm planning
on replacing it. According to Hayne's I'm supposed to jack up the front end
and remove both front wheels. Is this correct? I don't see why I need to
remove the wheels.
Also, Hayne's says I have to remove the pulley...
|
|
1 |
519 |
|
|
97 ford explorer 5.0 liter drive abilty prolbems by
Darryl12
Idles fine, then when in drive it shudders and stops. Runs very rough. Some
days it will clear up and runs fine for so long 1 day 2 days then this
prolbem crops up again.
Fuel pressure WHILE having this prolbem was 31 psi. Any thoughts.
|
|
3 |
282 |
|
|
Ford Explorer Wont Start by
jjwebb123
I ihave recently been having trouble with my 1999 explorer eddie bauer.
Occasionally when you get in it wont start. I changed the batteried in
my security remote but it still wont start. dont think it is the
battery for some functions still work. I can hear a clicking of some
kind. Can it be the...
|
|
3 |
418 |
|
|
vacuum line by
rdome43417
I have a vacuum line that is broken, it goes to the egr vacuum sensor. I
spliced a piece of tubing to reconnect it. I would like to replace the
line. It is the red line. It goes into a line that connects to another and
then is reduced to one single line that goes into the top of what I think
is the...
|
|
2 |
573 |
|
|
94 EB 4x4 intake gasket procedure by
Sam
Last week I torqued down my lower intake manifold bolts hoping to
solve the "mysterious" coolant leak that leaves no drips anywhere.
Well a week after I have done this I am still lossing coolant.
Later on today I am going to pull the intake manifold off and examine
the the manifold area.
I have a...
|
March 26th 06 02:54 AM
by JohanB
|
1 |
525 |
|
|
2005 Explorer XLT 4.0 Liter V-6 by
[email protected]
Vehicle has approx. 30,500 miles. Filled up with Exxon 87 octane gas in
Jackson, Mississippi on Wednesday morning, and less than 10 miles later
the engine started running very poorly and the "check engine" light
started flashing....then it died on the side of the road. Got it
cranked again and made...
|
|
0 |
301 |
|
|
Thanks by
rdome43417
I want to thank everyone. I was having a problem with my blend door and
thanks to you I did a temporary repair and it works like new.
I have recomended your sit to all my friends.
|
|
0 |
222 |
|
|
2001 Ford Explorer Starting Problem by
cusack
Hi,
I'm hoping someone can figure this out. My wife has a 2001 Ford
Explorer with the V6 4.0. We were having a problem to where it would
not crank without pressing the accelarator and I thought I had it
solved on two seperate occasions. First time someone suggested that it
was the Idle Air Control...
|
|
9 |
480 |
|
|
99 Explorer - No control of AC / Compressor by
RC
Either it's the age of the truck, or it has been designed this way.
Latley (and what seems to have been always) - the darn A/C compressor
is engaging when I do not want it to. This has been bothering me for
about 4 years, just finally fed up enough to post about it.
Anyhow - I have read the...
|
March 25th 06 05:45 AM
by sf/gf
|
3 |
250 |
|
|
P0756 Code by
Spud Unger
My 96 Explorer 4.0 4wd A/T with 76k mi is not shifting into 2nd or
shifting late and the "overdrive off" light stays on. the scanner picked
up a P0756 code that translates to Shift Solenoid B...
Looking at the manual, there is no shift solenoid b. can i assume that
it is solenoid 2? tia
|
|
0 |
444 |
|
|
97 Ford Explorer alarm problem by
lisasnoe
Due to an incident with snow chains, my electrical is messed up. Windows
won't work, door locks won't work and alarm won't work. How can I manually
disable alarm so I can move the car someplace to fix the wiring problem? I
can't start the car because of course I can't turn the alarm off with...
|
|
4 |
407 |
|
|
|
|
0 |
324 |
|
|
Is is necessary to decarb your engine? by
Aaron
I have a '99 Explorer Sport with normal driving conditions and 54,000
miles.
I took my Explorer into the dealership today because the check engine
light was on. They hooked it up and I needed a new exhaust sensor.
They also recommended the following:
* fuel injection service
* decarbon engine
*...
|
|
4 |
254 |
|
|
IAC Valve or AIR bY PASS VALVE by
Claude
Hi,
again claude from france.
I wonder what the difference is between the 2 parts, because whith the
number on the part of my vehicle, i find Air by pass valve in rockauto.com
catalog. Is there a difference, or I have not found the IAC valve yet ...
my explorer is a 98 one.
please help, because...
|
March 22nd 06 01:49 PM
by Claude
|
3 |
283 |
|
|
Looking for advice to buy newer Explorer by
[email protected]
I own a 97 Limited 4WD SOHC with 118k miles and i've been told by a
shop that the transmission went. The fluid is a dark nasty color and
when it gets hot it stops moving. If I let it cool it drives again but
then stops when it gets hot. Is it in fact toast and needs a complete
rebuild? If the...
|
|
3 |
626 |
|
|
Trailer rentals for Explorers -- perhaps an old topic by
[email protected]
This is my first post to this or any news group since about 1999.
Since U-Haul will not rent trailers to go behind Explorers, are there
any other options for one-way trailer rentals? What is the typical
position of local-only rental companys? I have a feeling that U-Haul
has a complete monopoly...
|
|
2 |
361 |
|
|
Double-Din Radios by
[email protected]
I was interested in purchasing a new radio for my '01 Sport, but hate
the pocket look of a single din radio. Has anyone successfully
installed a Double-Din sized radio into the slot for an Explorer Sport,
and if so what brand?
|
|
1 |
255 |
|
|
94 Explorer license plate bulb socket part # ?? by
Sam
I went to replace my license plate bulb today and noticed the socket
is corroded and needs to be replaced.
I went to napa and several other autoparts to find a generic bulb
socket that will fit into the housing that is affixed to the bumper
with no luck.
Does anyone know what the part number is so...
|
|
3 |
300 |
|
|
oil change by
Carmie
I'm having trouble locating the oil pan and thus the oil plug, is there a
schematic diagram available? I have changed the oil on a few other
vehicles, but not a Ford .......please help me. Thank you.
|
March 20th 06 03:59 AM
by Ron B.
|
2 |
358 |