|
|
1984 Mitsubishi 2.6 engine/parts market? by
William R. Walsh
Hello all...
Is there any market or value for Mitsubishi 2.6L engine parts or the entire
engine itself?
I have a 1984 Plymouth Reliant with this engine and the feedback type Mikuni
carburetor setup. This car does run and drive very well, but the body is
failing from rust. It's bad enough now that...
|
|
1 |
212 |
|
|
More fun with the '88 Reliant by
William R. Walsh
Hello all, once again...
The car itself is a 1988 Reliant LE wagon, 2.5L engine with the three speed
automatic. It ran a lot better when I put a good battery in it. The "check
engine" light works, but it is not on right now. Codes in the computer are
12 and 55, which seem to indicate a "normal"...
|
|
8 |
309 |
|
|
2000 Chrysler Grand Voyager Water Pump by
William R. Walsh
Hello all...
This has been a "fun" van to own--while it seems to be reliable enough and
is holding up well, it has had enough stupid problems to make you wonder...
It's a 2000 Grand Voyager with the 3.3L V6.
About two or three months ago, it suddenly and without provocation dumped
coolant out of...
|
|
5 |
525 |
|
|
Two oil warning lights on '84 Reliant? by
William R. Walsh
I had the car parked just so the sun was shining through the rear window
when I happened to notice something. There is a row of three indicator lamps
between the speedometer and fuel/charge/water temp gauges. On my car they
are unused--the bottom two being for "door open" and "gate open". The...
|
October 1st 07 08:01 PM
by Mike Y
|
3 |
365 |
|
|
1984 Plymouth Reliant idles way too fast... by
William R. Walsh
Hello all...
The vehicle in question is a 1984 Plymouth Reliant with the 2.6L Mitsubishi
engine. It runs and drives, but the problem is that the engine is idling
way, way too fast. It also diesels a LOT at shutdown, although that may be
due to some very stale gasoline that I'm trying to get rid of...
|
|
3 |
664 |
|
|
2003 Dodge intrepid 2.7 engine cam tone ring swap question? by
WILLIAM HILL
Hello, I am converting 2000 2.7 to fit a 2003 vehicle I have already
swapped out the flex plate and I was told to change the cam tone ring
on the left camshaft, So I removed the cam tone ring from the 2003
engine without removing the cam sprocket and holding the camshaft with
a breaker bar. During...
|
|
0 |
696 |
|
|
VIN INFO WANTED by
William Falconer
There used to be a site here where you could punch in a VIN number and get
all the recalls for that vehicle, is that site still available. I have a
dodge 2006 Grand caravan
Bill
|
|
6 |
581 |
|
|
Pacifica Clunk by
William Warren
have anyof yall heard of a clunk in a 2004 pacifica FWD's front end. sounds
like tranny. not sure.
|
September 23rd 05 02:41 AM
by tim bur
|
3 |
250 |
|
|
MPG? by
William Warren
hello all. my father has a 1997 lincoln town car, which has the 4.6 litre
v8. I am wondering, why does it, weighing as much as my Pac, get 30 mpg plus
on the highway, while i get 25?
|
|
4 |
625 |
|
|
99 T&C AWD rear rotor removal? by
Will Halina
Hi Guys:
Any one have tips on removal of the rear brake rotors on the AWD minivans?
It's not clear to me if brute force is required or perhaps I missed
something. BTW, there are the rotors with the (painfully awful design IMHO)
integrated parking brake drums on the backside..
TIA
Will
|
|
0 |
496 |
|
|
rear brake disc removal 99 T&C AWD? by
Will Halina
Does anyone have any advice on how to get the rear discs off of a 99 T&C
AWD? After removing the calipers, the discs don't seem to budge at all. I
assume they are rusted/frozen to the hub/bearing assembly. Any Tips?
thanks
Will
|
|
0 |
366 |
|
|
99 T&C headlight wiring and poor performance by
Will Halina
Here's my story:
The road illumination from this vehicle seemed to be getting pathetic
lately. I noticed that the exterior of the lens were pitted, but as well
the interior of the lens has been fogging up and has moisture in them. When
they dry out, the reflector and interior of the lens is not...
|
|
6 |
764 |
|
|
2000 Voyager Horn Problem by
wildthing33
Just lost horn button operation from steering wheel. When I cranked car,
the airbag light stayed on for a longer period of time than normal.
Horn still works from remote.
|
|
7 |
527 |
|
|
2000 Voyager Infinity 6x9 Rear Speaker by
wildthing33
Purchased E-Bay replacement Infinity Speaker for rear of vehicle but it
only has a 4 wire connector and my original has a 6 wire connector.
Need help with pinout connections so I can splice in. Don't care what it
looks like; just want it to work properly. I do know if you pull the plug
that it...
|
|
0 |
293 |
|
|
1994 Dodge Caravan 3.3 loss of power/backfires by
wildside1975
I have a 1994 dodge van with a 3.3 engine. It runs fine for about an
hour, then once it gets up to operating temp then it backfires through
the intake, spits and sputters and has no acceleration. Recently
replaced the fuel pump, new spark plug wires, and coil pack.I tried
loosening the gas cap and...
|
|
4 |
9,669 |
|
|
'02 Caravan gauges and turn signals out by
wildcat03
I have an '02 Dodge Grand Caravan with 39K. While driving on the
freeway last week, my temp, gas, and speedometer bottommed out. The
digital odometer and digital gear reading went blank. Also, my turn
signals did not work. However, the dashboard and instrument cluster
lights are intact.
A 20A...
|
|
0 |
1,377 |
|
|
|
May 30th 05 01:05 PM
by WHOPHD
|
0 |
474 |
|
|
Yet, when we really think about it, this all seems like nonsense. by
wholesale2
Yet, when we really think about it, this all seems like nonsense.
http://www.watchec.com
Swiss Rolex Watches Mens Rolex Watches Ladies Rolex Watches A.lange &
Sohne Watches Alain Silberstein Watches Audemars Piguet Watches Baume
& Mercier Watches Bell & Ross Watches Blancpain Watches BMW...
|
|
0 |
225 |
|
|
Extended warranties by
Whoever
This article might be interesting, folloiwng the discussion earlier:
http://pcworld.com/howto/article/0,aid,122094,pg,4,00.asp
|
September 10th 05 06:44 PM
by Whoever
|
0 |
1,724 |
|
|
Removing Oil Pressure sender connector? by
Whoever
Can anyone explain how to remove the connector from the oil pressure
sender on a 1997 Voyager 3.3L V6?
I can't figure out how to get the connector off the sender, so I cannot
get a socket on the sender itself!
Thanks!
( 1 2)
|
|
12 |
1,871 |