A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Reverse Sort Order Views
Pesky radiator leak...can't decide what to do by [email protected]
I've got a '90 Mazda Protege (173K miles) and it's still in amazingly good condition, and runs like it did when one- day old. It's been very well maintained all these years, which is why I still have it. Here's the deal: I put in a new after-market radiator last July; last month I noticed a...
(Multi-page thread 1 2 3)
December 1st 05 06:18 PM
by Scott Dorsey Go to last post
22 1,171
Steering Wheel Shimmy 55-75 by [email protected]
Okay so i'm beginning to notice some shimmy in my 00 Pontiac Grand Am and i'm running out of ideas as to what it may be... I figured it was out of balance first since I just had new Avon Tech M550's put on. Took it back in and they rebalanced. Problem still existed. Tried rotating tires to see if...
(Multi-page thread 1 2 3)
August 7th 06 05:19 PM
by Pop` Go to last post
22 2,061
Worst retailers or brands: by J J
What retailers or brands etc have been so bad that you would never use them again? For me it would be: Firestone tires. Maco auto paint Sams Wholesale tires Bought a new Buick. 3 of 4 Firestone radials blew out at highway speeds.
(Multi-page thread 1 2 3)
October 31st 06 03:12 PM
by E Meyer Go to last post
22 863
help-need someone smart to tell me about water in gas tank... by Sean[_3_]
I'm assuming I have water in my gas tank. on the top of the tank there's a small hole, and last night there was alot of rain and I drove through some pretty big puddles. I didn't have problems last night for a good while after I drove through the puddles, but I'm assuming that it took a while for...
(Multi-page thread 1 2 3)
November 27th 06 06:55 PM
by brian70 Go to last post
22 927
Getting fuel line compression fittings leak free by Ed
The FI return line attaches to the fuel tank with a 5/16" compression fitting that I can't get a good seal on. I even replaced the tube section and of course used a new compression sleeve. I've tightened it quite a bit, but it still weeps. It so little that it probably wouldn't matter if it were...
(Multi-page thread 1 2 3)
January 9th 07 05:50 PM
by Mike Romain Go to last post
22 1,076
About jumping car - Connection Negative by klabu
About jumping car - When attaching NEGATIVE to the target car - what is the difference btwn attaching to battery negative pole and attaching to the metal part of the car ? Why "attaching to the metal part of the car" is the "default instruction" than otherwise ? Thanks
(Multi-page thread 1 2 3)
February 6th 07 01:19 AM
by Daryl Bryant Go to last post
22 1,468
High mileage, burning oil, but love car! Help! by wanda
Hi, i have a 93 mazda 626 i love the car. has 199,000 miles, long commute using 2 quarts week, using 30weight oil. anything to help?
(Multi-page thread 1 2 3)
April 2nd 07 07:14 PM
by Scott Dorsey Go to last post
22 811
About Spark Plugs by TOM CAT
what is your opinions about Champion Spark Plugs as compared to lets say Autolite or NGK or other brands. Do you feel they are a better quality plug or not.
(Multi-page thread 1 2 3)
May 15th 07 06:24 PM
by Scrapper[_63_] Go to last post
22 1,020
Does this exhaust look like water in the cylinders? by Doc
This is a short 5-sec .wmv video at the exhaust pipe. Warm engine at idle, mid-high 80's outside. I've been losing water and don't see where it's going. Wondering if I've got a head gasket issue. The engine was just rebuilt a couple of years ago, dangit. Thanks for all input. Video is 646 kb
(Multi-page thread 1 2 3)
May 22nd 07 05:14 PM
by Hachiroku $B%O%A%m%/(B Go to last post
22 1,009
Overheating - Fiero GT by Nightcheck
Hi - I have a beautiful 1987 Fiero GT (original owner) which (knock on wood) has rarely given me problems - but I a stumped now (probably because I know next to nothing about auto repairs). The problem is overheating as follows: 1) I fill the place (where the thermostat is housed - on the...
(Multi-page thread 1 2 3)
June 6th 06 05:36 PM
by Junqueboi Go to last post
22 632
Does speed-shifting blow up engines? (Little problem) by frank wight
I took my dad's old dump truck out into the field and managed to get the rear wheels spinning at 70 mph-- while standing still. Trouble is, the rear tires got traction and the whole truck got airborne--- leaping and jumping across the meadow. It really was a handful, trying to regain control.
(Multi-page thread 1 2 3)
July 26th 06 02:23 AM
by Raymond J. Henry Go to last post
22 1,211
Noisy swaybar bushings. by Richard
1994 Sentra. Rear sway bar has stock rubber bushings, which are producing a very annoying and loud squeak noise on sharp bumps (like backing out of the driveway, speed bumps, potholes, etc). I have removed the bushing from one side to diagnose the source of the sound, the bushing is in good...
(Multi-page thread 1 2 3)
December 5th 05 01:29 PM
by Hugo Schmeisser Go to last post
22 882
lug bolt issue by verminaard
Admittedly I have no car expertise, but I can do some things like change oil, tune up, minor repair etc... So, I have a Nissan Quest Minivan. I have had it for years with only minor problems here and there. Several monthe ago I felt the wheel wobbling a little bit. It felt like the tire was about...
(Multi-page thread 1 2 3)
December 18th 05 06:49 PM
by news Go to last post
22 993
Oil Pressure Gauge and Engine death by CL (dnoyeB) Gilbert
Trying to get some lessons learned from my first car 'death.' To make it short, the oil gauge started behaving curiously to me probably last year this time. But since the oil light didnt come on, and the pressure seemed high enough, nothing seemed wrong. This turned out to be bad because the odd...
(Multi-page thread 1 2 3)
January 22nd 06 01:11 AM
by Nate Nagel Go to last post
22 1,479
2 snow tires on FWD car go on front or back? by peter
If I replace only two tires of a FWD car with snow tires, should they go in front or back? The other tires are all season tires. I used to think they should go in front, because braking, steering, and acceleration all use the front wheels. However, a friend went to a tire store and they put the...
(Multi-page thread 1 2 3)
February 14th 06 02:53 AM
by y_p_w Go to last post
22 865
"new" engine doesn't start right? by Eric B.
Had a 1995 Mits. Galant 5-speed with 133K miles on it. A 2-year-old balancer belt slipped somehow, got underneath the timing belt, and the interference engine was trashed (valves bent, pistons damaged). A local garage with a good reputation found a used engine with 66K miles on it. They installed...
(Multi-page thread 1 2 3)
February 13th 06 07:53 PM
by ray Go to last post
22 862
86 Maxima, failing NOx. Here’s what was done. What next? by [email protected]
86 Maxima, 139K failing Mass emission, Nox. Here are the numbers HC gpm 1.35 (limit 2.0) PASS CO gpm 8.72 (limit 30) PASS Nox gpm 3.85 (limit 3) --- FAIL Co2 gpm 332.97 (limit N/A) NA After browsing through recommendations from this and other groups here is what I’ve done so far:
(Multi-page thread 1 2 3)
April 12th 06 06:53 AM
by steve Go to last post
22 1,463
Which cylinder is oil-fouled? by Spud Demon
I always check my oil at gas stations because that's the flattest place. Well, a few weeks ago I checked and put in a quart. Only after the engine started running rough did I notice that particular gas station wasn't flat at all but on a hill, and I had overfilled the oil. Now I've changed the...
(Multi-page thread 1 2 3)
April 20th 06 02:18 AM
by ~^Johnny^~ Go to last post
22 708
Motor Oil Viscosity by [email protected]
In the U S South regions where the temps in the summer time reach 100° - I hate the idea of using 5W30 wt. motor oil - even tho it is a factory recommendation. what do you think? mho vƒe
(Multi-page thread 1 2 3)
April 21st 06 05:18 AM
by [email protected] Go to last post
22 945
what are used catalytic converters generally worth for scrap? by [email protected]
and where do i take them? i am in the philadelphia area
(Multi-page thread 1 2 3)
September 15th 07 07:13 PM
by dahpater Go to last post
22 458
Post New Thread


Display Options
Showing threads 1061 to 1080 of 16938
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 12:08 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.