|
|
spark by
jrock
i need some advice on a ford e 150 van that has great spark to all
cylinders other than the number one cylinder . have changed plugs,
wires and some other things as well but still have the same problem.
think it is the coil pack or is there something else i might be over
looking ?
|
August 11th 06 04:41 PM
by jrock
|
0 |
233 |
|
|
Bronco II Rear Brake Problem by
bnhcomputing
1989 Ford Bronco II. Rear brakes not working. Replaced brake
cylinders. With pedal depressed all the way to the floor, I can still
turn the wheel by hand. Turned adjustment to the point where the wheel
barely turns, but it still turns when brake is depressed. Removed
drum, and new cylinders...
|
|
3 |
625 |
|
|
Smog check HC question by
nutso fasst
Hello.
I replaced cat converter 2 yrs ago to bring down HC in wife's 81 VW
Scirocco. Now the car's failing due to high HC again, with only about 2800
miles since last test! Results:
15mph, 1807rpm
HC max: 162 - HC meas: 149
CO max: 1.09 - CO meas: 0.27
NO max: 1227 - NO meas: 983
( 1 2)
|
|
13 |
1,098 |
|
|
1984 Audi 4000S Quattro brake bleeding by
Christoph Bollig
Hi,
I just found the following message on google while looking for hints
on brake fluid bleeding. It's two months old now, but it still cought
my attention (copied from google, my reply is below):
> From: - view profile
> Date: Mon, Jun 13 2005 6:28 pm
> Email: ...
|
|
2 |
1,219 |
|
|
accord start up problem by
[email protected]
Hi. I have a 1990 honda accord and recently when I try to start the car
it just whines but doesnt start. If i let it sit for about 15-20
minutes then try again it starts up fine. This has happened about 3
times this month and im not quite sure what is wrong. 90% of the time
it starts up fine. Im...
|
|
4 |
390 |
|
|
Timing belt replacement question by
Victor Faraday
I still have a 1990 Mazda Protege knock-around-town car. It has 178K+ on
the odometer and is an amazing little machine (very reliable and solid).
I've always done nearly all of the service work on it, and enjoy doing it,
but replacing the TB is something I've always taken it into a shop for.
I...
|
|
4 |
539 |
|
|
2001 Silverado OBD codes? by
zxcvbob
Is there a way to read the diagnostic codes on a 2001 Chevy Pickup
without an OBD-II reader? Several previous vehicles would blink the
codes to you if you turned the key on/off/on/off/on/off rapidly, or
pushed the right combination of radio buttons, etc.
My truck (34000 miles) has been hard to...
|
August 12th 06 03:59 AM
by Mike
|
7 |
435 |
|
|
1995 Nissan Hardbody engine trouble by
[email protected]
It's been doing this for about 7,000 to 10,000 miles now, but this is
the worst it has been. My truck is a 1995 Nissan Hardbody with a 2.4L,
4-cylnder, manual transmission. (Just incase that helps.)
What it's doing:
In neutral and only in neutral the engine stops, uhh, working. The
engine stalls....
|
August 12th 06 04:04 AM
by Mike
|
1 |
309 |
|
|
Bad engine mounts, but who cares? by
[email protected]
Just got a '96 toyota Camry from my father in law, 150K miles.
Great shape otherwise, but it shakes like ten epileptics when idling
in drive. Mechanic recommends replacing motor mounts, about $700
to replace two of the three.
My father in law recommends just ignoring the shaking, or putting it
in...
( 1 2 3)
|
|
20 |
1,110 |
|
|
rebuilding a 318 for added torque and fuel economy (if possible) by
fishmeister
I have a 1974 318 engine that i would like to rebuild and install in my
2001 dodge ram 1500 when this engine drops. I would like some imput on
what i should do to create more torque and possibly better fuel economy
(if that possible). The 318 magnum that i have in it now pulls my boat
nice but it...
( 1 2)
|
|
10 |
485 |
|
|
Water dripping after using the A/C is normal? by
George Lin, editor in chief of Intellibridge
I drive a 2004 Nissan Sentra.
After a 20-mile drive on the highway during which I used the a/c,
when I parked in the garage, I discovered a leak of something like
water -- a clear fluid from a drip in the undercarriage. the drip came
from the underside of the car between the driver seat and...
|
|
9 |
346 |
|
|
Tech: 1990 Grand Caravan 3.3L won't start.. Has spark & getting fuel by
m6onz5a
It'll crank & crank and won't start.. It has a code 22 (coolant temp
sensor). Sensor & plug have been replaced. Still nothing. If you
disconnect the collant temp sensor plug it'll start for 3-5 seconds and
run at about 2400 rpm, then die out. Computer has also been replaced.
Any...
|
|
4 |
484 |
|
|
96 Buick #4 misfire, still chasing the problem by
[email protected]
Just found this problem, engine light on showed a misfire. Had shop
double check all of the injectors and fuel pressure, all good. Install
a new fuel filter. Then did a new plugs. Thought it might be a spark
plug wire, installed a know good one, no fix. Then swapped with the
one next to it,...
|
|
5 |
770 |
|
|
|
|
1 |
414 |
|
|
350 fuel pump by
[email protected]
Hi all.. New here.. I have been working on my 86 Trans AM for the
last two years.. a few questions have come up. One is I dropped a 76 2
bolt 350 in and trashed the 305. The 350 came out of either a truck or
a vette. My question is will the 86 mechanical 305 fuel pump work on
the '76 block?
|
|
1 |
341 |
|
|
1992 Chevy Lumina 6 cylinder radiator fans not coming on by
Roscoe[_1_]
Hi Everyone,
I'd like to thank everyone ahead of time for all the help. I have a
1992 Chevy Lumina, 6 cylinder, I think 3.1. I have ran my car with the
air conditioning on and the 2 Radiator fans I have in my car do not
come on, ever. When I turn the air conditioner on should at least one
fan...
|
|
7 |
592 |
|
|
Trane air handler too noisy by
~^Johnny^~
On Thu, 10 Aug 2006 02:07:28 GMT,
wrote:
> True 'shine is about like Everclear - 190 proof :-)
Yep. It's about 199 proof, but reverts to 190 proof due to teh
affinity ethanol has for water. Ethanol ETOH) can't be more than
about 95% in water, and isopropanol...
|
|
9 |
493 |
|
|
91 maxima by
Mike Alderman
Car almost stalls no power. Advanced timing, ran better for short time.
Started to stall and no power.
|
|
1 |
1,120 |
|
|
chevy: fuel tank, removing fill limiter valve - how much force? by
George[_1_]
'99 Cavalier. I got the tank out. To extract the limiter valve
assembly, the book calls for a J43288, and I seem to have misplaced
mine. It doesn't come free when I turn it by hand. The body is kind of
soft plastic.
Can I use (large) pliers on this, or can I tap one of the tabs with...
|
|
0 |
912 |
|
|
98 Ford Escort-No voltage to A/C compressor by
69_muscle
I have a 98 escort with no A/C. No voltage to compressor. I replaced
the high side A/C switch on the receiver/dryer, and checked the Low
side switch near the radiator. No go. The compressor still gets no
voltage. Is there some sort of A/C relay WAC switch that controls
voltage to the compressor? I...
|
August 14th 06 03:57 AM
by Kevin
|
1 |
370 |