|
|
World's Smallest GPS Receiver by
virig[_2_]
The new module AMY, of just 6.5 x 8 x 1.2 mm, is the smallest GPS
receiver module available anywhere in the market.
http://www.freegpsguide.info/2008/09/amy-5-u-blox-worlds-smallest-gps.html
|
|
0 |
279 |
|
|
need all the help i can get w/ 99 mazda 626 4 cyl. by
jpinal
a week ago i installed a new baterry . now when i turn the car off it wont
start . the battery is charging . and all i get is a clicking sound and a
buzzing sound like something is stuck . i put a new starter last year. can
this be an electrical or computer problem . has anyone ever...
|
|
2 |
279 |
|
|
engine and tranny out as unit by
peter
reading up on the engine removal, the factory manual "says" to remove
tranny, (from under carrage), and then procede w/ engine removal. can
they be extracted as a unit from the top? is it really necesary to drop
the ppf?
thanks,
peter
|
November 11th 06 12:48 PM
by peter
|
4 |
280 |
|
|
no sparky by
mazdahter
Own a 89 Mazda 929.Iwas driving down the road & car died.Was not getting
spark.Replaced coil & still no spark found out about "igniter"& replaced
it as well.Nothing has changed.Any suggestions would be greatly
appreciated. Thank You
|
June 8th 05 11:16 PM
by Chuck
|
2 |
281 |
|
|
Replace Tail Light on 2000 Miata? by
Tom[_26_]
My friend has a 2000 Miata with a damaged left rear tail light. Is it
difficult to remove the old light assembly and replace it w/ the new one?
I haven't had the opprotunity to look inside the trunk to see how the
assembly is attached to the body.
Are instructions available on line?
Thanks,
Tom
|
|
2 |
282 |
|
|
closing up gap between bumper and fender by
frank
I've got uneven spacing between the front bumper and fenders, with the
passenger side wider in the front and not snug below the headlight
assembly on my 2002.
My assumption, and I'm guessing since I haven't got a shop manual, based
upon gazing at what can be seen under the hood is that removing...
|
May 7th 06 02:14 AM
by frank
|
0 |
283 |
|
|
Cold air induction by
Sydney Peters
Does anyone know if a cold air intake and cold box for a 2004 miata will #1
void the warranty and #2 does it allow moisture into the intake.
Thanks Syd 2004 silver ls
--
"Photographs are the windows
into the past
For the future to see."
Sydney Peters
|
|
1 |
283 |
|
|
Moving car to Europe by
szafajego
Hi, does anybody know what is the cost of moving car to Europe?
I want to buy Miata (1991-1995) and I'm wondering what is the average
price of 1992 Mazda in US?
Could you recommend me some good US websites with car ads?
--
szafajego
|
|
1 |
284 |
|
|
FS:90-97 Mazda Miata CONV TOP W/WDW by
Dave B
NEW 1990-97 MAZDA MIATA BLACK CONVERTIBLE TOP.
IN ORIGINAL CABRIO GRAIN VINYL MATERIAL WITH ZIP DOWN TINTED REAR GLASS
WINDOW.
$550cdn OBO
CALL 204-697-2899. Ask for Dean
Winnipeg, Manitoba Canada
|
|
1 |
284 |
|
|
Console Question by
Geary Morton
I'm looking for an '01-'05 console to put in my '99. I've only found a
few over the last several months, and they have all been tan in color. I
want a black one. My questions a
Did they ever make this style of console in black?
How well would vinyl spray work to make a tan one...
|
|
2 |
284 |
|
|
Install instructions/pictures? by
John Smith[_1_]
Guys, I have an ultrashield Rallye seat, and a set of G-Force 5 point belts
awaiting the weekend to install, but I need help.
Do any you folks know of install instructions with pictures for them? I'm a
tall guy, so I know that I need to mount the seat to the floor. I'm looking
for a...
|
|
0 |
285 |
|
|
Radio Removal - 2006 by
WendyC88
Anyone point me to a "how to" on taking out the radio on a 2006? We are not
necissarily swapping out the stock radio, I need to get to the back to do
either an audiolink or wired fm transmitter for an ipd connection. Thank
you.
I guess while I'm at at, any experience on the audiolink or wired...
|
|
2 |
285 |
|
|
Smoke in the morning... by
Alan Baker
Blue smoke. A large cloud just after I start my 1990.
What do you think is the likely cause? I've got one friend who's
suggested it might be worn valve guides. What am I looking at paying if
it *is* valve guides?
Any other thoughts?
TIA
|
May 18th 05 05:08 PM
by darren
|
3 |
285 |
|
|
Does anyone know this noise? by
Dave Smith[_5_]
I have a '97 with PS, AC, and JRSC. 108K miles.
When I first got the JRSC, everything was perfect. Then a couple
months later the car developed a heavy buzzing when the engine was
lugged slightly, especially starting off from a full stop, but also if
I deliberately lugged it. Then the noise...
|
|
4 |
286 |
|
|
Proof that Phoenix drivers.... by
XS11E[_3_]
...... control the universe!
This is exactly the way people drive he
http://news.aol.com/story/_a/hubble-captures-crashing-galaxies/20080426210609990001?feeddeeplinkNum=0
"Images of colliding galaxies show them spinning, sliding and
slipping into one another, wreaking stellar...
|
|
0 |
286 |
|
|
Screenwash reservoir cradle - update by
vat677
On 2 Nov I posted re a difficult bolt, and received some very helpful and
sympathetic replies. Well, finally, we cracked it in 10 minutes, but only
after thought and preparation. Since a number of you guys will meet this
problem, here's how we did it.
1. We ground most of the threads off the...
|
November 28th 07 04:17 PM
by vat677
|
0 |
286 |
|
|
motor is out! by
peter
after a couple stray wires and a stubborn heater hose, the power train
came out. my cherry picker is pretty big and as i was pulling the unit
out i was hoping i had enough room to clear the car. it is resting on a
2x4 next to the car.
next, tranny to the shop to be checked out and strip to a...
|
December 7th 06 07:26 PM
by peter
|
0 |
286 |
|
|
HKS Turbo Manifold? by
Robert
Has anyone used the hks turbo manifold on 1.6/1.8? Any thoughts about
it? Looking to build my own kit and need opinions if they are reliable
unlike greddy units.
Robert
|
February 6th 05 06:36 PM
by Robert
|
0 |
286 |
|
|
torqueing head by
peter
hi,
95 Mazda Miata
even with glasses, deciphering the "instructions" which came with my
head gasket is difficult, so does this sound right?
torque to 22
43
58
|
|
3 |
286 |
|
|
Mazda Hardtop Wall Brackets by
Andy Wilson
We have purchased genuine Mazda hardtop wall brackets for my wife's 2003
MX5's hard top but the instructions say to remove the hardtop, fit brackets
and only then to measure the spacing for the drilled holes in the wall.
I had hoped to pre-mount the brackets to make removal and storage quicker
and...
|
|
3 |
287 |