|
|
P0133 & P0153 by
To Arms!!
I have a '96 with a 5L V8 XLT two wheel drive. I've been getting some
intermittent check engine lights with codes of P0133 & P0153. The
check engine light seems to come on when the temperature changes (from
above 76degrees to below 70degrees). Sometimes the check engine light
will go out after...
|
|
0 |
313 |
|
|
'96 XLT 4Dr Rear springs sagging? by
Just_Steve
Am wondering if there is a way to determine if the rear springs on my '96
(106k miles) are sagging, or if it's just my imagination? It seems to ride
rougher than in the past, and I seem to get more people flashing headlights
as if my high-beams were on. Is even worse with two people riding in back...
|
|
2 |
617 |
|
|
UK Explorer overdrive warning light flashing by
Ian Lowrie
Hi,
Ford UK dont want to know Explorers. So I'll ask the people who are sure to
know.
97 Explorer 4liter. 125,000 miles. Just ordered a prelube kit from
California. Stop it from self destruct. Usually over here about 80-100,000
timing chain destroys hydraulic adjuster, metal bits kill the oil pump...
|
November 28th 05 02:51 AM
by Ron
|
1 |
423 |
|
|
Does anyone have the 2002 Shop Manual (by Helm) for the Ford Explorer? by
Lee Weinstein
I have a stuck air diverter door in my climate control system and am
looking for the exploded view to see how to dissassemble the plenum on
my 2002 Explorer. Does anyone own a shop manual (preferably the
official Helm shop manual on CD ROM) that shows this view for the 2002
Explorer? I found a...
|
|
0 |
1,070 |
|
|
aftermarket seats by
Bob
I'm trying to find some aftermarket seats to replace my '94 Explorer XL
worn out seats but having no success. Anyone know where I might buy some
(2 front seats). Thanks.
|
|
1 |
524 |
|
|
Temp Guage Fluctuation - 98 Explorer by
VJC
When I start my 98 and allow it to come to running temp (~1/3 full
scale on temp guage), when i turn my heater fan on with temp set to hot
the temp guage drops to "C". Any suggestions as what the problem might
be? My first guess is the coolant temp sensor.
Thanks, VJC
|
|
5 |
493 |
|
|
2004 explorer auto trans keeps downshifting back and fourth from high to 3rd by
marlow
when this started happening i noticed that the cold idle would go to 1500
rpm, then take it's time to come down to normal, then when warm it still
goes to 1500 rpm then comes down to normal rpm a little quicker, at the
same time the transmission shifts normal, but between 45 and 55 mph the
trans...
|
November 27th 05 02:17 PM
by marlow
|
2 |
1,075 |
|
|
94 ford explorer high idle when cold 1500 rpm down to 650 by
marlow
rpm goes to 1500 on cold srart then takes it's time coming down to 650,
even when engine is warm, then when auto trans is in high gear it will
keep shifting back and fourth from overdrive to 3rd, at 45to 55 miles per
hour. any help would be apreciated, thanks.
|
|
1 |
545 |
|
|
5.0L Ford Explorer drive unit timing by
autoreman
Hi, I have a 1996 Ford Explorer witha 5.0L V8. I had a bad drive unit, it
had a bushing that was sqeeking. I have pulled it and now need to install
the new one. How do i time it?
Thanks, Autoreman
|
November 27th 05 01:35 AM
by Fred 2
|
2 |
353 |
|
|
Trans requires letting off gas to shift to 2nd gear by
sorrellv
94 Ford Explorer requires me to let off the gas when starting out. When
tach indicates 4k to 5k I have to momentaraly let off the pedal to shift
to 2nd. I changed the modulator and fluid but the trans still sticks
(fluid was not burned before change).
|
|
0 |
395 |
|
|
'99 Explorer Radio Upgrade Question to CD by
[email protected]
Hello,
I have a 1999 Ford Explorer Sport with a factory installed
AM/FM/CASSETTE system. I'd like to upgrade and get AM/FM/CD or
AM/FM/CD/CASSETTE factory system probably used off of EBay.
I know to look for the same style of mount and the same input jacks,
but are there other things I should be...
|
|
1 |
293 |
|
|
Front diff by
jack
Noticed a oil buildup in the right front wheel well. Traced it to the
front diff vent. Was told that the diff cover needs to be replaced due
to a poor design in the original(baffling was added to return the oil to
the diff while allowing the vent to function.. Ford dealer quoted 650$
for the...
|
|
6 |
510 |
|
|
|
|
2 |
415 |
|
|
obd11 scanner code message PO174 by
BLITZ11
I frenquently get code PO174 on my obd11 code scanner which reads "system
to lean ( bank 2 )". Could someone tell me what bank 2 mean.
Thanks.BLITZ11
|
|
1 |
642 |
|
|
help on removing door inside by
noone cares
Where can I find instructions on how to remove the inside drivers door
panel?
1996 Four door 4X4.
I have power locks, want to see if I have a keyless entry installed
before I buy an aftermarket one.
thanks!!
|
|
0 |
215 |
|
|
2002 Brakes by
XLS
Hello all!!
I have a 2002 XLS 4-door 4WD with 55k miles. Recently I noticed that when I
press the brake pedal to stop the vehicle, just before the SUV comes to a
stop (maybe 2-3 seconds before) -- ...there is a feeling of a thump or a
light jumping sensation from the rear as the vehicle comes to...
|
|
1 |
228 |
|
|
OS sensor by
Massive2001
I have a 2001 ford explorer sport trac. The check engine light will not go
off so I took it to auto zone where they tested it and informed me that i
needed two new oxygen sensors. I have replaced the one on the exhaust but
i do not know where the other one is.
|
|
1 |
260 |
|
|
problem starting and gear shifting (manual gears) for 1998 explorer by
hedgerum
My car has some kind of with starting. When I first noticed it, the
car would not start after I tried starting smoke came out from the
hood, and I noticed that the negative power connector grounding cable
had melted. Then it wouldn't start. I replaced the grounding cable
and the battery...
|
|
2 |
710 |
|
|
1994 ford explorer by
marlow
i have a 94 ford explorer 4.o litre v6 auotmatic ,lately when starting cold
it idles at 1500 rpm then slowly idles down to 650 rpm, even when engine is
warmed up, when started it starts at 1500 rpm then comes down to 650 more
qiuckly, also when traveling at between 45 and say 55 mph,...
|
November 25th 05 07:57 PM
by Ulysses
|
1 |
733 |
|
|
4x4 shifting 96 explorer by
Al Sproule
A quick question. On my explorer I have the electronic shifting dial.
When I teun it to 4x4 nothing happens, after awhile the hi and low 4x4
lights flash.
Now if I stop and put truck in neutral the turn it to low it works, also
from there if I change it to just 4x4 it also works. Now if I turn...
|
November 25th 05 04:57 AM
by jack
|
1 |
281 |