Have a new Expedition with 900 miles on it. Truck pulls to the right slightly. Dealer said the alignment was dead on, and it maybe radial pull. Is this possible on new tires?

My 1993 S10 Blazer is running low speed rough idle. I replaced the rotor and cap, spark plugs (wires are 3 years old), cleaned the EGR valve and put a new gasket in the EGR valve. Can anyone give me an idea of what can be causing the problem?

I have a Sears lawn tractor which is 6 yrs old. It came with a 21HP B&S engine. A few days ago it started to run real rough at idle. If I add about 50% chock, it run ok, but still at times can misfire. At a 100% speed, it seems ok and can cut grass and move around ok. I got this condition a few...

can anyone tell me the diff between car motors and boat motors. i know exhaust manifolds are but what about the block,heads,intake, crank,etc thanks

I recently purchased an OBD-II auto scanner. I understand the basic obd codes, but there is also this freeze frame data that is completely beyond me. It is stuff about short and long term fuel trim systems. What do those percentages mean and how can I use them effectively?

1995 nissan altama gxe (no break lights) i checked the break light switch, fuses, bulbs. can it be the third break light bulbs out? would this cause break lights to fail? i have running lights and signels. please help!

My O2 Sensor is failing in my 1998 Ford Escort. Is this a simple thing to change? Any tips in changing it? Any help will be appreciated. - John

Hey everyone... ! I have a 1997 Saturn SL1 and recentley had it serviced where all breakpads and fluids were replaced. Today I drove the vehicle for about 15 minutes with the hand brake ON (I know... stupid!!) and when I realized what had happened, the foor breakes seemes really REALLY soft. So...

Having a 7MGE engine in an '89 Cressida overhauled after only 30k since last overhaul. Am I likely to find any ebay buyers for the first set of oversized pistons with low miles on them or do you just never install used pistons?

i got a 20 lb cylinder of the stuff and it's about half full. what could i get for it on craigslist these days? thanks

My 94 Toyota Corolla has a one inch hairline crack in the bottom of the fuel tank that's leaking fuel. The vehicle has 140,000 miles and is in great shape. The crack is on the bottom, near the center on the tank. This part of the tank is flat. I used a fuel repair tank epoxy, after cleaning and...

My O2 Sensor is failing in my 1998 Ford Escort. Is this a simple thing to change? Any tips in changing it? Any help will be appreciated. - John

i have a 1986 nissan pulsar, no ECU, just basic E16 engine. I've gone through 4 ignition modules inside the distributor. once the first one blew, the next one lasted 5 minutes. I had forgotten to put the di- electric grease on the back. The next one i put in lasted 3 weeks, up until yesterday when...

I am looking for a high quality replacement carburetor for my 1986 Chevy G10 van. The van has a 4.3l V6 engine with overdrive automatic transmission. The current carb is a modem M4MED Quadrajet that has been apart too many times to count and still doesn't work right. I don't have any faith left...

Hi I have a 95 Regal Custom that has been acting strange. The symptoms include: High idle and high rpm when in drive. Shut off/restart car appears to fix it (for a while, anyway). Air conditioning/heater/vents turn on and shut off inexplicably.

I need to install a generic power antenna on my 1993 Mazda 626. The original harness has five wires that went to the old antenna (which is long gone). Anyone know where I can find a wiring diagram for this? Wire colors a - Red - Blue/Red - Blue - Black/Yellow

Can anyone help!! When i drive my honda accord above 40mph, i begin to hear a loud humming sort of noise from the front of the car. not sure if its under the bonnet or to do with the wheel bearings. Its fine below 40mph. The noise developed after i did some hundred miles on the motorway last...

Greetings. Will a hole in the Y-pipe of a vehicle cause any damage if left for a while? Like 6 months?

My 1996 windstar has 202,000 miles.3.8L It runs fine untill it gets to temperature.Then it will sputter and shake and act like it does not want to go when given gas. I just replaced all the plugs, (original) plug wires, and EGR valve hoping this would solve the problem. It didn't. Fluids are...

I notice that when I work under a car, it seems to give me gastrointestinal issues and even makes me a bit queasy. Could it be some kind of issue with coming in contact with grease/oil and fumes?