|
|
|
|
1 |
1,286 |
|
|
91 s-10 blazer by
eric082769
how do you put the rod back that works your high and low beem?
|
|
0 |
260 |
|
|
Caliper slider pin is stuck by
[email protected]
I am trying to replace the calipers and brake pads on the front of a
'93 Tracker. I've had a heck of time because of rust, but I managed to
get through most of the problems without too much difficulty. Until
now, that is. One of the slider pins is thoroughly stuck. I cut the
little rubber boot...
|
August 6th 05 02:40 AM
by no one
|
5 |
498 |
|
|
new clutch slips :( by
[email protected]
Guys,
I just installed a brandnew kevlar clutch in my 4runner. The clutch is
from southbend clutch and sports a 1600 lbs pressure plate.
Now that the clutch is in the first thing i notice is the clutch pedal
is soft as butter. pressing it in feels as light as the gas pedal.
the truck rols but...
( 1 2)
|
|
13 |
1,417 |
|
|
1998 jimmy blazer 4wd-a/c by
fastlearner
What would prevent the a/c button to stay in the on position, when try to
turn on the a/c the light flashes 3x then stays off. I recently had a new
compressor, dryer,& tube chg and flush out the system. All the fuses are
good, but the a/c won't turn on.
And just a couple of days ago, hot air...
|
|
0 |
289 |
|
|
87 4runner by
dyke
my 87 4runner has a 22re auto trans and when i put it in 4wd and then to a
drive gear (R,D,2,1) the motor stalls. I was having this problem w/ it in
2wd but i adjusted the timing and it works better. Does anyone have any
ideas....please help!!!
|
August 4th 05 10:06 PM
by dyke
|
0 |
204 |
|
|
brakes by
tjones
i have a 1988 suzuki samurai.4x4.how do u get the rear brake drum off? it
has 5 philp head screws around the drum i dont want to break them off.im
not sure that they have to come off!! any help please
|
August 3rd 05 01:45 AM
by tjones
|
0 |
182 |
|
|
Amp INSTALL Chevy Tahoe / ACCESS ?? by
Scan Da Bands
Wondering if anybody knows of a FIREWALL access in a Chevy Tahoe?
It's a 1997 4x4 - 1500.
Installing an amp for a 10 meter radio and also , any advice on where
to power from , I was thinking straight from the battery would be
fine? Any advice listened to and thanks group!
Tom
|
August 1st 05 06:19 AM
by Mark D
|
7 |
750 |
|
|
ford bronco 2 transmission by
dhow
I HAVE A 89 FORD BRONCO 2 THE TRANNY WENT OUT I PUT ANOTHER ONE IN AND IT
STILL WONT ENGAGE THE TRANNY FLUID WILL NOT GO DOWN DOES ANY ONE HAVE ANY
SUGGESTIONS
|
August 1st 05 02:35 AM
by .boB
|
5 |
310 |
|
|
1997 Chevy Tahoe (blowing fuse tail lights) by
Scan Da Bands
One bulb (turn signal rear)went out so of course I replaced both at
the same time......go to turn on the lighted dash and the fuse blows
????????????????????????????????????????
|
|
5 |
373 |
|
|
1996 Mazda MPV by
Jayson8
Trying to figure out what is wrong with my MPV. When I brake it begins to
shake, rather violently sometimes. Any sugggestions?
|
|
1 |
264 |
|
|
Towing a Samuria by
Tom Storey
I just bought an 87 Samurai and I would like sometimes to tow it benind my
truck. It came with a 'towing plate' on the front bumper and I believe a
'wish-bone' type of draw bar attaches to in and then to the ball on my
hitch. I don't have the draw bar. My questions a any draw bar make...
|
|
7 |
507 |
|
|
|
July 29th 05 03:31 AM
by V1tte
|
0 |
658 |
|
|
1995 van w/4L60E shifting trouble by
jonkuehn
Working on a 1995 GMC fullsize van, 4L60e tranny shifts up and down between
drive and od at speeds above 45 mph. Shift is quick and harsh, and happens
every minute or two. With shifter in d, van drives ok. Is tranny bad or?
Thanks
|
|
5 |
350 |
|
|
Dumb Q: DRL's by
[email protected]
Are some late '90's DRL's controllable as to whether they come on or
not, by the ECM (apart from the DRL module)?
Reason for dumb Q:
My Tracker ('96) has had its DRL's out since I got it used, which is
fine with me, and I never see others on the road with DRL's on, even
though it's originally so...
|
|
0 |
180 |
|
|
Suburban stutters! by
overloadedjc70
My 95 suburban acts like it is choking, not wanting gas at the slightest
movement of the peddle. Seems to want to die but finally takes off and
runs normal. It has new plugs,cap rotor,wires and O2 sensor.
|
|
5 |
397 |
|
|
96 Geo Tracker by
jerwayclar
It is 4 cylinder and an automatic. We have replaced 3 distributors lately.
The mechanic said the first rebuilt one he ordered was bad, so he
reordered. It lasted 700 miles. I have replaced this one and it lasted for
one startup. The mechanic tells me that I am just getting bad rebuilt
distributors....
|
|
2 |
529 |
|
|
truck stalls out by
redranger
i have a 1997 ford ranger , 4 cyl, stick with a/c. 58k milages. started
stalling out since i had new belt installed. engine has self tensioner.
stalls when braking. hot, cold, engine, same thing. stalls when slowing
down to turn. i can eliminate stall sometines if i put stick into neutral
and coast...
|
|
2 |
210 |
|
|
P0320 codes by
hosbadar
I have 96 chev truck 305 CI with 228,000 miles on it. trouble code comes up
with catalyist efficiency below threshold bank 1. It has 4 02 sensors and 1
catalytic converter. I clear the codes and it runs fine for a couple of
days up to a couple of weeks. Cant figure out if 02 sensors or converter
is...
|
|
1 |
298 |
|
|
4x4 frustration by
spectre750
my 93 s-10 blazer 4.3 auto electronic 4 wheel drive, put my truck in 4
wheel hi but when i pushed the button to disengage 4 hi the unit slammed
into 4lo and now refuses to do anything but stay locked in 4lo....I need
HELP!!!!
|
|
4 |
374 |