Brandy Alexandre wrote: > Before I move to another state, I went to the same Honda mechanic for > decades. Before I left, I had him give the car one last look and fix > everything that needed fixing. I got new shocks/structs and other > funky things. And a week later a new radiator because the...

FUTURE PRIDICTIONS - STOCKS - PRODUCTS - FUTURE GLOBAL MARKET TOP SELLING CHRISMAS PURCHASE IF ADVERTISE MAKES A GREAT GIFT !!!! DVD'S X-FM AND SIRIUS RADIO I POD MP3 PLAYER I TUNES GIFT CERTIFICATES CELLPHONES WITH PLAN X-BOX 360 AND PLAYSATION 3

Hi, how can I tell the difference between valve misadjusment and pinging? next time I fill up I am going to try higher octane, 93 instead of 87, if the noise goes away I conclude it is pinging, if the noise remains I think it must be the valves. is this logic correct or faulty? thanks

getting brave enough to change my timing belt on 1999 honda accord 4 cylinder so far i have looked at step by step instructions for timing belt instalation off of the internet however this information was for early 90's honda. everything i have seen looks fairly easy so far

My daughter's been driving my '91 Acura (she's 18). This is the same car that had its oil drain bolt stipped by Jiffy-Lube recently, and had its AC converted to the newer coolant not long ago. She mentioned the battery light came on the other day. I told her this car eats a battery about every 4...

RayGun wrote: > Hey All.. I rebuilt my daughters 91 Si, had burned and bent exhaust > valves. Put in new rings, valves, valve seats, gaskets and all the > necessary items needed. Break-in period was gentle and 2000 kms. > It passed the emission test no sweat, but after about three months > started...

Hi All I just rebuilt my daughters 91 SI last winter, had one broken and one bent valve. New rings, valves, seals, gaskets, the whole enchelada. 2000 km easy break-in period, passed the emission test no sweat, then slowly started to use oil. Seven months later it is using about a litre a week, but...

Where can I get my D15 block sleeved (iron sleeves) affordably?

I have a 1999 CRV that runs well. The one thing that I notice is that the engine idles at 300-400 rpm (using the tach on the dash). The car does not stall but when I run the AC, the compressor keeps cutting in and out due to the low rpm's (i.e. the AC is fine when riding at any speed). Only idle is...

I recently got a good deal on a set of used, but minty, bridgestone potenza's (195/60R15) mounted on integra gsr blades and I'm planning on installing them on my 99 civic se. However, the new rim'n rubber combination is slightly taller and wider than what is currently on the car. Is it safe to...

Does anyone know if "Life-time" brake pads are a good idea for Honda CR-Vs? Will it affect ABS braking? Does Honda make them or are they an aftermarket product?

Hi All, I finally got speedbleeders for my Si of which I plan on installing with fresh brake fluid this weekend. My question is can I replace each screw and bleed it one corner at a time in one step or do I need to replace all 4 bleed screws and go back and bleed them again. I'm wondering if...

What could this be? It all started about a week ago. Whenever I turned in one direction (can't remember if it was right or left) the left rear wheel would squeek (sounded like it was once per revolution, *squeak* *squeak* *squeak* faster or slower depending on my speed. Now, for the last 2 days,...

AAAAaaaaaaaaaaarghhhhhhh! I drained the tank, topped it off, hit the trip reset and started my experiment. I drove down the tank until darn near empty using the air conditioner on recirc for the entire tankful. Last night the little lady ran some errands and put $10 in to get her around! See what...

John wrote: > Hello, > > Can someone confirm if I have struts or shocks/coils on my 92 civic dx > hatch? > > Thanks! > > John >

98 honda civic LX 1.6L Have replaced the whole entire a/c system, when reading the a/c gauges low side indicates 35 and high side indicates 250 to 300. High side too high, can some one point me the right direction to solve this high side problem

In article >, RayGun > wrote: > Hello All > I rebuilt my daughters 91 SI last winter, after determining it had some > head aches... > Broken valve and a bent valve. > Did the rings, valves, guides all gaskets, and after an easy 2000 km >...

Does anyone know what is the maximum speed that stock tires can handle (2005 Honda Civic LX)? Thanks.

1994 Accord EX Car starts and runs OK, but mileage is a bit low. I think the O2 sensor may be shot - barely passed smog last couple times. But new issue: My temp gauge rarely rises above the bottom peg. Checked the TW sensor with an ohmeter and IR gun. The resistance appears very close to the...

Has anyone installed these on his/her Honda? Any thing I should look out for while installing? What manufacturer of hood pins do you like? My 91 Civic's hood release lever and cable mechanism have been a pain for many years. I am thinking of discarding the whole setup, sacrificing looks for...