|
|
head gasket leak? by
dumdum
I have a 87 reliant 2.5, It starts o.k. when cold but after 5 mins. it
stalls.I wait 5 mins. and it runs fine. I checked all vaccum lines,changed
map sensor,fuel filter the pvc valve and air cleaner also new fuel
regulator. Could the head gasket need torqing? Also, will head gasket
cause this...
|
November 20th 05 09:52 PM
by dumdum
|
0 |
579 |
|
|
__ Plastic 'plug' left in heater drain . . . by
'Curly Q. Links'
My '87 Caravan had it and my '91 Caravan has it too. The drain that is
supposed to allow water in the heater to run out thru the firewall has a
plastic plug (Carplug) in it, that was apparently not removed when the
vehicle was assembled. On the '87, it caused the water to sit in the
heater and rust...
|
|
0 |
1,289 |
|
|
rec.autos.makers.chrysler FAQ, Part 3/6 by
Dr. David Zatz
Archive-name: autos/chrysler-faq/general/part3
Posting-Frequency: 15 days
Last-modified: 2004/4/13
Version: 4.5
Modifications and detailed fixes are at the web site -
http://www.allpar.com/
IMPORTANT. Do not attempt to respond to .
Due to spam this address DOES NOT GO ANYWHERE.
|
|
0 |
754 |
|
|
rec.autos.makers.chrysler FAQ, Part 2/6 by
Dr. David Zatz
Archive-name: autos/chrysler-faq/general/part2
Posting-Frequency: 15 days
Last-modified: 2005/7/21
Version: 4.6
This section is generally revised every 300 days.
SERIOUS updates to the body code list, July 2005.
IMPORTANT. Do not attempt to respond to .
Due to spam this address DOES...
|
|
0 |
412 |
|
|
1990 Spirit. Door sill chrome trim removal by
[email protected]
I would like to remove the chrome *sill* that sits at the top of the
door, so that I can replace the plastic moulding that resides
underneath.
It looks like the sill is held in place with screws. It it appears that
these the screws are not accessible regardless of whether the window is
in the up...
|
|
0 |
326 |
|
|
300C Easter Egg by
[email protected]
Found this on one of the forums.
On the steering wheel, if you press the music note and the compass
simultaneously for about 10 seconds, you will get some interesting stats in
the EVIC window. This is for the 2005:
Page 1 - CCN SW P/N
Page 2 - Speed/RPM/Coolant Temp/BattV
Page 3 -...
|
|
0 |
401 |
|
|
|
|
0 |
422 |
|
|
code 43 by
dumdum
My 87 plymouth reliant has a stall problem code 43 comes up and says
ignition control circuit and the discrition is out put driver stage for
ignition coil doesn't respond properly to the dwell control signal. can
anyone tell me what this means and where to fix it? thanx
|
December 7th 05 10:00 PM
by dumdum
|
0 |
175 |
|
|
Transmission skipping by
nirodac
Vehicle; 1980 LeBaron (149,000Km); 318 (49,000Km), A904 Tranie (71,500Km).
Generally the car runs great (after new rebuilt carb with ported vacuum,
installed), no rust, no body damage, slight vibration over 80 Km, another
problem for another day.
Problem; Tranie has a hard time shifting from 1st to...
|
December 8th 05 03:51 AM
by nirodac
|
0 |
332 |
|
|
___ Slipping guts out of a '91 3-speed tranny :-) by
'Curly Q. Links'
I've got a '91 Caravan 3.0 Litre cargo apart in my unheated (Canadian)
garage tonight, (-14C) because I broke the Reverse band Anchor a few
months ago. It's just a 3" axle that acts as the stop for the reverse
band. To get it out is easy, (if you're a tranny guy). :-)
Does anybody have a link of...
|
|
0 |
1,088 |
|
|
|
December 4th 05 05:08 AM
by Michael
|
0 |
231 |
|
|
stall problem, Head gasket? by
dumdum
I have an 87 reliant 2.5 with a stall problem.I checked all vaccum
lines,changed map sensor,fuel filter and fuel regulator. Also replaced
cap,rotor, and new wires,themostat and antifreeze. Could the head gasket
need tourqing ? The car starts ok cold and runs for 5 mins. then stalls. I
wait 5mins....
|
November 20th 05 10:06 PM
by dumdum
|
0 |
220 |
|
|
PT rattle up date. by
tomkanpa
philthy wrote on Nov 6, 10:11 am:
It's called the watts link and it connects the 2 sway bars in the
center.
____Reply Separator_____
That's what it was. My local garage (not a dealer) replaced it. They
got it at the dealer though, they called it the Track Bar Pivot.
$63.00.
|
|
0 |
215 |
|
|
95 chrysler cirrus pwr mirrors and door locks by
witman
My pwr windows and door locks have stopped oerating. I have a chilton's
manual, howerver, it does not contain elictrical diagrams for these
systems. Does anyone know where to look for the common link between these
two systems or can anyone email me the diagrams?
The fuse is GOOD!
|
November 23rd 05 12:18 AM
by witman
|
0 |
405 |
|
|
96 T&C odd pcc issue by
[email protected]
Our 96 T&C died on the road. After a tow home, I initially found that
I was getting no worthwhile codes (12) and no spark. After charging
the battery, it started but ran on 4 cylinders - no's 1 and 4 (center
two on the coil pack) were dead. I found that I had continuity between
the coil pack...
|
|
0 |
361 |
|
|
Pesky High Idle problem on 1992 Grand Caravan 3.3L by
[email protected]
Hello,
On my 92 Grand Caravan 3.3 I have a high idle problem that
consistently trips the Code 25 (IAC circuitry). Here is what I have
checked and replaced.
Idle Air Conntrol Motor
Swapped out another ECM from another Caravan
Cleaned throtle body area and replaced TBI gasket.
No known vacuum leaks...
|
|
0 |
447 |
|
|
|
|
0 |
545 |
|
|
|
December 2nd 05 11:01 PM
by Alex
|
0 |
440 |
|
|
"Ram Mega Cab lives up to name" by
Mike
Ram Mega Cab lives up to name
Dodge's quest to offer the largest and most spacious pickup truck on
the market has yielded the all-new Dodge Ram Mega Cab.
at http://www.washtimes.com/autoweekend/20051201-122539-8800r.htm
|
December 3rd 05 02:11 PM
by Mike
|
0 |
574 |
|
|
Chrysler fuel mixture lean - how to fool the PCM? by
primetime2
i have a 98 plmouth neon service engine soon lights is on ive tuned car up replaced plugs, wires, pvc valve, oil filter, oil, air filter, car runs good but ligth still on checked codes by key on key off system got code 72 cant find a code 72 no where in my book please help here anybody much...
|
|
0 |
472 |