|
|
1991 Pontiac sunbird starter. by
Jesse
My daughters 1991 sunbird either 3.1 or 3.3 engine is in the snow and
needs starter replaced. I need to crawl under the engine and replace
it, looks like very poor access. Advice on how to please. jesse
|
March 15th 06 05:11 PM
by Jesse
|
2 |
385 |
|
|
Toyota by
donf
I have a 1996 toyota tacoma sometimes when you push the clutch in it
makes a really bad noise but not everytime it dosent sound like it
coming from the throw out bearing it sounds like its coming from around
the starter thanks.
|
|
2 |
444 |
|
|
Power Steering Fluid vs Slick 50? by
Barbara Harris
is it possible to substitute power steering fluid for a synthetic brand oil
additive e.g., slick 50, prolong, duralube?
Larry Von
( 1 2)
|
|
13 |
1,684 |
|
|
DP 90 LF Black Epoxy Primer for Engine Compartment? by
Rick2950
I am getting ready to paint my engine compartment on my 66 Impala SS
Ragtop.
Not a trailer queen car but a driver during the summer with few shows
thrown in.
I have a quart of PPG DP 90 LF black epoxy primer and was wondering if
anyone had any input on using it for the engine compartment.
I am...
|
|
0 |
548 |
|
|
1985 Ford Bronco II melted hoses by
[email protected]
I was driving home today, 25 miles, and noticed an exhaust leak coming
from under the hood. When I got home and looked, there was a wad of
melted hoses on the passenger side of the engine. No exhaust manifold
leak I can find, just a noise coming from a hose that goes to the
catalityc converter. ...
|
|
2 |
337 |
|
|
|
March 15th 06 05:05 AM
by Bob
|
4 |
393 |
|
|
92 acclaim check engine light goes on and off by
dutchie26
Hi
My wife's 1992 plymouth acclaim's check engine light goes on whenever
the radio or heater is turned on. When the radio or heater is turned
off the check engine light goes out as well.
Should I be looking for a new alternator? or should I be looking
elswhere?
Thanks
( 1 2)
|
|
10 |
560 |
|
|
toyota relays ? by
aeon13
i am not undertsanding how to check to see if the relay is bad or good .
my cooling fans will not work when the relays are pressed in all the way
the fans will not work . but if i pull them half way out and wiggle them
a bit i can get the fans working. i am not sure if this is a contact
issue or...
|
March 15th 06 01:38 AM
by aeon13
|
4 |
753 |
|
|
1991 Honda Civic by
elnene80
Hey guys, ok i have a 1991 Honda Civic I installed lowering springs on
it and well now the vehicle is leaning to the side (left) i checked and
replaced left font strut and checked and it stil leaning what you think
it could be guys help me out thanks....
|
|
2 |
324 |
|
|
|
March 14th 06 08:13 PM
by Shep
|
3 |
439 |
|
|
Clutch Does Not 'Return' - what would cause this? by
LoadHawg
'92 Nissan 240SX 140K mi, 4 cyl, put new Beck Arnley clutch in including disk, bearing and pressure plate about 2 years
ago. Also put new master cyl in about that time.
Couple weeks ago it went to the floor and sat there. I can flick the pedal with my foot and it comes up. Then it works
fine about...
|
|
5 |
652 |
|
|
clear coat by
ronkinz
I recently painted my motorcycle. After applying the clearcoat I noticed
particles in the clearcoatfinish. Can I sand the clearcoat smooth and
recoat.
--
ronkinz
------------------------------------------------------------------------
ronkinz's Profile:...
|
|
3 |
935 |
|
|
92 V6 Camery heat sensor by
[email protected]
The heat indicator in my 92 V6 camry does not work. The dial doesn't
move. Where is the sensor plug located? I suspect that is the problem.
Or do you have a different suggestion?
Thanks,
Ed
|
|
2 |
483 |
|
|
anyone know how to read brake lining codes? by
N8N
Still trying to figure out why my car won't stop... rears are locking
up way before the fronts really start to work. This is a '55
Studebaker coupe, FWIW... see below for copy of post to
alt.autos.studebaker.
So I pulled my drums again today... found several things interesting.
1) both my rear...
|
March 14th 06 05:26 PM
by N8N
|
9 |
487 |
|
|
91 honda civic by
rc
my son was driving up hill and he lost any power to keep going, when I
tried, i could let the clutch all the way out and there was very little
power. Some days later, I was able to drive it into the garage but had
to rev pretty high to do it. What could this problem be?
|
|
8 |
311 |
|
|
Help with A/C diagnosis? by
Kevin Highsmith
Hi all
1996 Chevy Silverado 1500 w/Vortech 350
Just warmed up enough here to turn the A/C on for the first time the other
day and it blew hot. It was working fine last season, so I figured it just
needed a recharge.
I bought a kit with the hose, gauge, and can of refrigerant....
|
March 14th 06 07:23 AM
by John_H
|
4 |
733 |
|
|
Muffler install on 325i by
SQ
How hard is it to install a muffler on E30 325?
I understand I'll need a dremmel tool for the bolts, which are likely
frozen beyond removal. What else? Do I need to do any bending? Should I
expect problems separating the mulffer piece from where it joins the
cat? What about the install?
( 1 2)
|
|
10 |
503 |
|
|
Autozone-branded full synthetic by
Nexus7
Is thre any information about the Autozone-branded full synthetic oil?
It is being sold in the usual passenger car weights, and is labeled as
meeting the same API certifications as the Mobil 1, Castrol, and other
synthetics. There is some suggestion on Usenet that it may not be made
from PAO stock,...
( 1 2)
|
|
12 |
832 |
|
|
96 Subaru brakes by
[email protected]
I have a 96 Subaru Legacy with 4 wheel disc brakes. I'm about to
change the pads in the rear.
My Chilton's manual says, "WARNING: Before beginning the procedure,
determine whether your vehicle is equipped with a rear parking brake
assembly. If equipped with rear parking brakes, only compress...
|
|
1 |
342 |
|
|
|
|
7 |
1,291 |