Alldata 2004, , , Mitchell CDs, year 2005 - 2003 , 53 CDs, total 107 CDs ----------------------------------------------------------------------------------------------------- Alldata 2004, , ARRIVED IN BETWEEN 31/MAY/2004 to 28/JUNE/2004 FULLY FUNCTIONAL, AND GOOD FOR UNLIMITED SEATS.

I have a 2002 Ford Explorer XLT with a couple of wiring problems. The dome light works, however not when the doors are open. Also, the 12V charger will not charge. I have been looking for an auxiliary fuse or something along those lines, but have not been able to isolate the problem. I checked...

This is a recent problem, 2 days tops. Sometimes when I start the car it starts fine but then dies. I have to keep my foot on the gas to keep it going. When I am driving and I slow down the rpm's drop fast and the car can stall. After driving a while it seems to be fine, but it does this even...

1996 Explorer XLT 5.0 AWD In the past 6 months or so it's been difficult to unlock all the doors from the inside using the unlock button on the driver's side door. I have to rock the switch between lock/unlock several times before the doors will finally unlock. Any ideas what could be wrong and...

A P1053 code just popped up on my '98 Explorer (V8, 94,000 miles). I know that it means 'B2S1' oxygen sensor sluggish to respond. The manual lists about 20 different reasons, before it gets to the obvious suggestion to replace the sensor. The vehicle has been well maintained and I have no reason to...

I have a 93 xlt that the driver side seat is just about gone. My backside is getting a little sore riding on the metal. The fabric is decent shape but I will need to rebuild everything underneath. Does anyone have and good sources for supplies? Any hints? Thanks in advance. Dennis

I am about to replace the radius arm bushings for the second time on my '91. At about 91,000 I used NAPA poly bushings, and they are needing replacement at about 140,000. Any experience with the replacement rubber bushings vs Ford OEM bushings? And I also remember reading something about using...

I just got a new (to me) 2002 XLT. The DRLs don't seem to be working properly. Before I ask any dumb questions, are they standard on this model? If they're an option, how can I tell if I have them? TIA.

we recently changed the valve cover gaskets and the manifold gasket on our 91 explorer and after doing so the idle speed stays at about 2000 rpms we think that it may be a vacuum leak but we arent sure we would like any suggestions on other possibilities as to the source of this problem it is a 4.0...

I would like to know what will happen in the future? Can anybody tell me if the explorer will come back to europe or if the explorer will be fitted out with a diesel engine? I would be grateful for your information. Best regards -- Posted using the http://www.autoforumz.com interface, at...

Bought a used 93 without a radio. I wanted to install a stock am/fm/cass that was given to me, I was told came from an explorer. Now I'm having trouble with the connectors, I have radio wires coming out of the radio slot. One set goes to a female connector with 8 tongue slots in 1 row, the...

My 97 has a small cargo lamp directly above the cargo area. In fact, the vehicle is very well lit, two map lights, two door mounted lights, two bulb dome for 2nd row and again one in the cargo. I dont know, is one of your bulbs burnt out? or mabe a fuse? CuriousJuryus wrote: > Couldn't find a...

hi everybody i just bought 94 in great shape i'm really enjoying it as i've never had a ford before.but here is my problem as it was purchased as is the right front was broken and the left wasn't working.we purchased new fog lights an my installed them very simple job still not working after...

Leaving country need to sell 96 Explorer XLT 4x2 every option good condition.4.0L V6 with recent tuneup, brakes front and rear. It has been in California its entire time so no rust what so ever..I just moved to PA out side Philadelphia. All highway miles, does not smoke or use any oil. Mobil 1 in...

I just found out that I have a burnt out brake light and just tried to change and was unsuccesful. There are 2 big screws on the top side of the light but it seems that there are 2 more that I can not get to. Am I missing something? Any advice would be appreciated.

I have an annoying problem putting a child seat in the back of my 98 XLT. Since the seat is split 1/3-2/3 and I put the seat in the center my kid will lean to the left of the truck because the bottom of the seat has less support on the edge of the 2/3 bench. I thought about putting a piece of...

Looking for good cargo/storage for a 1998 XLT Ford Explorer roof top.I am not sure if they are referred to as roof toppers or not. Hopeful anyone has links/brands/recommendations. -- Posted using the http://www.autoforumz.com interface, at author's request Articles individually checked for...

Hi there, I am trying to find a switched power supply source on my 99 ford explorer, I have looked around but cannot really find anything. I am trying to install a radar detector and in the instruction it says that I have to connect the red wire to a switched power supply. Can anyone help me figure...

Hi all: I am new to this group and this is my first post. (I own a 2000 Ford explorer sport with the most basic no frill engine.) Here the very newbie question: What purpose does the O/D serve? Should I leave it on or off? Someone told me that leaving the O/D on was essential for highway driving...

From: Richard 1999 XLS V6 automatic. When I put the truck in park yesterday the shift indicator did not go all the way to park (P). It still shifts fine but the indicator is one position off when in PARK= R on indicator, when in REVERSE = N on indicator, and etc. Is this something that can...