|
|
|
September 27th 05 02:57 PM
by Oppie
|
9 |
539 |
|
|
Vibration/noise when turning left by
Rock
I have a 93 Saturn SL2 that started to make a vibration and low pitched
noise when I turn left. I jacked it up and do get a slight amount of play
when a grab the top and bottom of the wheel and try and move it. I don't
seem to get any when I grab the front and rear of the tire and try to move
it....
|
|
6 |
991 |
|
|
Vibration/noise by
94SC2
My 94 SC2 DOHC 130K miles is starting to make low frequency noise and
vibration. After sitting overnite (cold) , after starting and putting gear
in reverse an odd rumble/growl/vibration occurs when idling stopped. If I
let off brake and start rolling in reverse it ceases until I stop again.
After a...
|
June 30th 05 01:17 AM
by 94SC2
|
0 |
1,071 |
|
|
Vibration in my SW2...getting worse every day... by
WTP07
Hey all...anyone else have this problem?
I have a 97SW2 with about a million KM's on it...(OK...it's like
300k....)...and for the last 5K or so I have had an engine vibration that is
getting worse. It is really bad at idle, but you can still feel it/hear it
at cruising speed....I thought it might...
|
October 24th 04 01:13 AM
by marx404
|
2 |
513 |
|
|
Vibration in 99 SL1 when running in gear at stop. by
reex01
My 1999 SL1 has a very loud vibration coming from the engine compartment
when it is running and in gear and standing still. If I shift it into Park
the vibration stops. When you begin moving it stops. It is only when you
are running and in gear and stopped that the vibration is felt and heard
(at a...
|
|
3 |
821 |
|
|
Vibration by
Scott
Hello,
I just had a new oil pan installed on my 1996 Saturn SC2. The drain in my
old one was stripped, so I was using rubber plugs, which I don't like, so I
had a new pan installed. Anyway, when I got my car back, it vibrates like
crazy now, especially when I am still, like at a traffic light,...
|
|
4 |
657 |
|
|
Very high idle after transmission swap by
zoogle
Hello,
I just finished putting a 2000 SW2 back together and fired it up. The
idle shot up to 4000 rpm and hovered between 3500-4000 for 10 minutes
after which I shut the car off. Is this a normal re-learn procedure? I
made sure to plug all of the sensors in as I was putting it back
together. Any...
|
|
1 |
568 |
|
|
very fast idle then stall by
ernie
My daughter's 1996 Saturn sc single ohc. sometimes
revs up to 3000 rpm when stoping and then slows to
near stall or stalls. Auto zone read the codes as P0133
Oxygen sensor 1. Is there anything before this that might
cause this problem ?( before I change this sensor)
Ernie
|
March 24th 06 05:08 PM
by ernie
|
2 |
411 |
|
|
very easy to earn $10000 per month by
joy junior
http://earningwebmoney.blogspot.com
theres an absolute site which gives the brief about how can we earn
money from google ads .. I’m earning more than $3000 per month without
working in any means. Try it out
http://earningwebmoney.blogspot.com
|
|
0 |
478 |
|
|
Ventshade tape removal mess by
marx404
I am removing the Ventshade wind deflectors that the orig. owner of my "new"
'02 SC2 had put on . I removed the shade part and now am encountering messy
messy 3M tape which is on the rubber upper molding of my windows where they
were mounted.
What a mess. What is the best way to safely remove the...
|
February 22nd 05 01:26 AM
by tom
|
7 |
657 |
|
|
vent control mode cable, 93 dohc by
CBrooks
This cable, when the dash lever is pushed to the left, sends the
air to the front air vents, when pushed to the right, it sends
the air to the windshield. From my Haynes manual, it says there
is a clip that keeps the cable onto the plastic control arm of
the lever. Well my clip evidently either...
|
|
3 |
436 |
|
|
|
|
7 |
672 |
|
|
valve seats by
punxyguy
Anyone ever replaced valve seats on a 92 saturn sl sohc I am thinking of
replacing mine and was wondering if anyone has done it. If so was it a
pain and any suggestions or tips would be great
|
|
3 |
380 |
|
|
Valve cover leaking oil by
marx404
I just noticed that one of the top 3 bolts in the center of my valve cover
is permeating oil around the edge of the bolt. It is so minimal that it is
hardly noticeable. Everything else is bone-dry. I just had the valve cover
gasket replaced last year, is this normal?
I have a 94 SL2 with 90K...
|
|
4 |
1,013 |
|
|
Valve cover gasket by
Steve Murad
Have 1997 Saturn and just had the valve cover gasket and spark plug seals
replace. The gasket was aprox $200. Is this correct I'm from the days when a
valve cover gasket cost $7.00 Labor was only $45.00 but a $200+ gasket
sounds way out of line?
|
|
4 |
733 |
|
|
valve body bolts torque by
D. Gignac
I, anybody know the upper valve body bolts torue and tansmission cover bolts
torque?
tanks
Denis
|
|
4 |
439 |
|
|
valve body assembly?? by
[email protected]
I have the old slam in reverse problem and figured on changing the
valve body.. now saturn has changed the program and only change the
whole assembly. Does the whole assembly come with switches/solenoids or
is it just twice as much money for the heck of it???
I have an extended warranty program...
|
|
3 |
615 |
|
|
vacuum gauge by
Lee3333
Can I install a vacuum gauge in my 1993 Saturn SL2? Which vacuum line can
I plug into?
|
August 23rd 04 12:53 AM
by Oppie
|
2 |
990 |
|
|
|
August 1st 05 07:55 AM
by Box134
|
3 |
498 |
|
|
Used SW2 or SW1; Buying advice by
[email protected]
I am thinking about looking for a good used Saturn wagon. I really
like the LW2 but that may not be in my budget and the SW should get
better gas milage.
I have a fair amount of car buying experience but what special problems
should I be aware of in searching for a SW wagon?
I recall that early...
|
|
5 |
1,207 |